Salton TWT40 User Manual

cordless

Instruction Booklet

Model: TWT40

TWT40_2016_Booklet_ENG.indd 1TWT40_2016_Booklet_ENG.indd 1 7/12/16 9:12 PM7/12/16 9:12 PM

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should always
be followed including the following:

1. Read all instructions.

2. Do not touch hot surfaces. Use handles or knobs.

3. To protect against electrical hazards, do not immerse cord, plugs, or
the appliance in water or other liquid.

4. Close supervision is necessary when any appliance is used by or near
children. Children should be supervised to ensure that they do not
play with the appliance.

5. This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities or lack
of experience and knowledge, unless they have been given
supervision or instruction concerning the use of the appliance by
a person responsible for their safety.

6. Unplug from outlet when not in use and before cleaning. Allow to
cool before putting on or taking off parts, and before cleaning the
appliance.

7. DO NOT operate any appliance with a damaged cord or plug or after
the appliance malfunctions, or is dropped or damaged in any manner.
Return appliance to the manufacturer for examination, repair or
electrical or mechanical adjustment. All servicing, other than cleaning,
should be performed by an authorized service representative. See
Warranty section.

8. The use of accessories or attachments not recommended by the
manufacturer may cause hazards.

9. Do not use outdoors.

10.Do not let cord hang over edge of table or counter, or touch hot
surfaces.

11.Do not place on or near a hot gas or electric burner, or in a heated
oven.

12.Extreme caution must be used when moving an appliance containing
hot liquids.

13.Always attach plug to appliance fi rst, then plug cord into the wall
outlet. To disconnect, remove plug from wall outlet and then remove
other end from appliance.

2

TWT40_2016_Booklet_ENG.indd 2TWT40_2016_Booklet_ENG.indd 2 7/12/16 9:12 PM7/12/16 9:12 PM