SaltDogg LS7 User Manual

9049 Tyler Blvd. • Mentor, Ohio 44060

TM

Phone [phone] • Fax [phone]

Toll-Free Fax [phone] • saltdogg.com

Installation & Operator’s Manual

LS7 Liquid Spray System for SCH Style Spreaders

Installation Instructions

1. Position and weld Enclosure Bracket
(#3028485) and Support (#3014077) to
spreader as shown on Fig.1.

2. Position 30 gal. Tank (#3014062) on support
as show in Fig.2

3. Attach Enclosure Assembly (#LS102) to
Enclosure Bracket using provided hardware as
show in Fig.2.

4. Secure Tank on Support using 2 locators
(#3014080) and provided hardware as shown
in Fig.3.

5. Plumb: reservoir, ball valve, filter, pump
enclose and spray nozzle according to
plumbing schematic using supplied fittings,
hose and hose clamps. Do not use Teflon tape
on threads. Use liquid thread sealant. (see
fig.4, 5, 6 & 7).

—continued inside

1

9049 Tyler Blvd. • Mentor, Ohio 44060

TM

Phone [phone] • Fax [phone]

Toll-Free Fax [phone] • saltdogg.com

3014084

3014077

3.38

Fig. 1

3014062

Fig. 2

LS102

2

9049 Tyler Blvd. • Mentor, Ohio 44060

TM

Phone [phone] • Fax [phone]

Toll-Free Fax [phone] • saltdogg.com

Cab Controller Installation
Instructions (Fig. 4)

1. Install cab controller (#WSE1) in cab for convenient
driver operation. Mounting bracket and fasteners
included.

2.

Route 8' wire harness (#WSE24) under dash from

controller (#WSE1) to truck’s fuse panel.

3. Ground “black” wire from controller to truck frame
or truck’s battery (not dash).

4. Attach “green” wire in 8' wire harness (#WSE24) to
a fused and keyed 15 Amp hot wire circuit.

5. Connect main power “white” wire in 8' wire har­ness (#WSE24) to fuse box that is “hot” full time or to
battery “positive”.

6. Route the 25' wire harness (#WSE25) from the
rear of the spreader to the cab. Plug connector on
controller (#WSE1) to the connector on pump harness
(#WSE25).

Fig. 3

3014080

Fig. 4 WSE1 Cab Controller front view

WSE25

25' Cable Connector

Connector

WSE24

8' Cable

Fig. 4 WSE1 Cab Controller back view

3