SaltDogg LS6 User Manual

TM

Installation & Operator’s Manual

LS6 Liquid Spray System for
SHPE1500, 2000 Style Spreaders

9049 Tyler Blvd. • Mentor, Ohio 44060

Phone [phone] • Fax [phone]

Toll-Free Fax [phone] • saltdogg.com

Installation Instructions

1. Position Support (3013939) in truck’s bed.
Place 30 gal. Tank (#3014062) on support as
show in Fig.1. Strap tank to support using
straps 149650501.

2. Lower spreader onto support, Make
sure support’s long brackets are inside of
spreader legs openings and screws are
between two front legs as shown in Fig.2

3. Secure spreader on support using stops
(3014065) and provided hardware as shown
in Fig.3.

4. Position and attach enclosure LS102 as
shown in Fig.4.

5. Plumb: reservoir, ball valve, filter, pump
enclose and spray nozzle according to
plumbing schematic using supplied fittings,
hose and hose clamps. Do not use Teflon
tape on threads. Use liquid thread sealant.
(see fig.5, 6,7 &8).

—continued inside

9

9049 Tyler Blvd. • Mentor, Ohio 44060

TM

Phone [phone] • Fax [phone]

Toll-Free Fax [phone] • saltdogg.com

3014062

Fig. 1

3013939

Fig. 2

2

TM

Fig. 3

9049 Tyler Blvd. • Mentor, Ohio 44060

Phone [phone] • Fax [phone]

Toll-Free Fax [phone] • saltdogg.com

3014065

Cab Controller Installation
Instructions (

1. Install cab controller (#WSE1) in cab for conve­nient driver operation. Mounting bracket and fas­teners included.

2.

Route 8' wire harness (#WSE24) under dash from

controller (#WSE1) to truck’s fuse panel.

3. Ground “black” wire from controller to truck
frame or truck’s battery (not dash).

4. Attach “green” wire in 8' wire harness
(#WSE24) to a fused and keyed 15 Amp hot wire
circuit.

5. Connect main power “white” wire in 8' wire
harness (#WSE24) to fuse box that is “hot” full
time or to battery “positive”.

6. Route the 25' wire harness (#WSE25) from the
rear of the spreader to the cab. Plug connector on
controller (#WSE1) to the connector on pump har­ness (#WSE25).

Fig. 5)

Fig. 5 WSE1 Cab Controller, front view

WSE25

25' Cable Connector

LS102

Fig. 4

WSE2 4

8' Cable

Connector

Fig. 5 WSE1 Cab Controller, back view

3