Salsbury Industries Pedestal Mounting Kit User Manual

Pedestal Mounting Kit

Installation Instructions

Installing the Pedestal Mounting Kit

The Pedestal Mounting Kit can be used for all
Salsbury mailbox posts, pedestals, enclosures and
cell phone locker pedestals and enclosures that
require anchoring to concrete. The kit is for
installation in newly poured concrete.

After pouring the concrete foundation, place four (4)
anchor bolts into the freshly poured concrete with
the J-hook of each anchor bolt pointing into the
concrete spaced at the appropriate bolt mounting
pattern for your mailbox or cell phone locker device.
Allow the threads on the anchor bolts to protrude
one inch above the mounting surface of the device.

After the concrete has cured, set the device onto
the concrete base with the anchor bolts protruding
through the mounting surface of the device. Install
nuts and washers on the anchor bolts and tighten
securely.

Optionally, after the concrete has cured, you may
install a leveling nut on each anchor bolt then set
the device on to the leveling nuts with the anchor
bolts protruding through the mounting surface of
the device. Adjust the leveling nuts to square up
the device. Install nuts and washers on the anchor
bolts and tighten securely.

Sample Installation Shown

SALSBURY INDUSTRIES

1010 East 62nd Street, Los Angeles, CA 90001-1598

Phone: [phone] Int’l Phone: [phone]

Fax: [phone] Int’l Fax: [phone]

www.mailboxes.com engineering

Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.

Copyright © 2013 Salsbury Industries. All rights reserved. 2/20/13

@mailboxes.com