Salsbury Industries 3700 User Manual

SALSBURY INDUSTRIES

1010 East 62nd Street, Los Angeles, CA 90001-1598

Phone: [phone] Int’l Phone: [phone]

Fax: [phone] Int’l Fax: [phone]

www.mailboxes.com [e-mail]

ACCESS DOOR ARROW LOCK

3700 Series Horizontal Mailboxes

Installation Instructions

This installation instruction document is for installing the USPS Arrow lock in the access door on the 3700 series Horizontal Mailboxes.

Note

The mailbox is shipped without a USPS Arrow lock installed in the
access door. This lock must be requested from the USPS and
installed by USPS personnel. Call your local post office to request
this service.

Step 2

Install the spacer plate against the stiffener bracket aligning its four
(4) holes with the four (4) holes on the stiffener bracket.

Installation

Step 1

Open the access door. Remove six (6) preinstalled locknuts and
remove the backup plate, the spacer plate and the door stiffener
bracket.

Step 3

Install the Arrow lock onto the stiffener bracket by sliding the lock bolt
through the latch slot. Align the four (4) holes of the Arrow lock with
the four (4) holes of the spacer plate and stiffener bracket.

Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.

Copyright © 2013 Salsbury Industries. All rights reserved. (P/N 370136, Rev. 07, 8/26/13) Page 1 of 2

SALSBURY INDUSTRIES

1010 East 62nd Street, Los Angeles, CA 90001-1598

Phone: [phone] Int’l Phone: [phone]

Fax: [phone] Int’l Fax: [phone]

www.mailboxes.com [e-mail]

Step 4

Install the stiffener bracket with Arrow lock and spacer plate over the
six (6) captive bolts on the access door.

Step 6

Install and tighten the six (6) lock nuts onto the six (6) captive bolts.
DO NOT OVERTIGHTEN THE NUTS.

Step 5

Install the back-up plate over the back of the Arrow lock.

Step 7

Insert the Arrow lock key into the Arrow lock then retract the lock bolt.
Close the access door then lock and unlock the Arrow lock to ensure
the lock bolt travels freely. Installation is complete.

Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.

Copyright © 2013 Salsbury Industries. All rights reserved. (P/N 370136, Rev. 07, 8/26/13) Page 2 of 2