Salsbury Industries 3350 User Manual

Regency Decorative CBU Accessories

Decorative Top # 3350

Decorative Pedestal Cover - Short # 3386

Decorative Pedestal Cover - Tall # 3396

Installation Instructions

Thank you for your purchase of Regency® Decorative CBU Accessories manufactured by Salsbury Industries. We are confident that you will find
them to be an attractive addition to the Cluster Box Unit (CBU). Installation of the Regency
approved F-type CBU. Installation of the Regency

Installation of Decorative Top

1. Fasten the ball finial to the decorative top from the underside of
the decorative top using two (2) M4x8 allen bolts.

2. Before placing the decorative top on to the CBU top, apply
thread lock to the four (4) M6x8 allen cone point set screws and
insert into the two (2) threaded holes on each side of the
decorative top.

3. Only turn the set screws until they are flush with the inside
surface of the decorative top so that the decorative top can be
placed on the CBU top.

4. Place the decorative top on to the CBU top. Be sure the logo on
the decorative top is positioned at the rear of the CBU. Tighten
the four (4) allen set screws evenly to secure the decorative top
to the CBU.

Decorative Top

®

decorative pedestal covers (# 3386 and # 3396) are intended to be on the CBU pedestals.

Installation of Decorative Pedestal Covers

Note: The following instructions apply to both the short decorative
pedestal cover (# 3386) and the tall decorative pedestal cover (# 3396).

1. Slide one half of the black plastic insect guard into the top of either
one of the decorative pedestal cover halves. Make sure the locator
tabs on the pedestal cover align with the slots on the insect guard.
Repeat on the other half of the pedestal cover.

2. Place one of the pedestal covers with guard installed into position
underneath the rear of the CBU and around the rear of the CBU
pedestal.

3. Place the other pedestal cover with guard installed underneath the
front of the CBU and around the front of the CBU pedestal.

4. Use four (4) M4x16 allen bolts, two (2) at the top and two (2) at the
bottom, to bolt the two (2) halves of the pedestal covers together.

5. Thread four (4) M6x20 allen set screws, one at the top and one at
the bottom, on both the front and rear halves, into the threaded
holes to prevent the pedestal covers from moving.

®

decorative tops (#3350) are intended to be on a USPS

U.S.P.S. APPROVED

Decorative Pedestal Covers

SALSBURY INDUSTRIES

1010 East 62nd Street, Los Angeles, CA 90001-1598
Ph: 1-800-624-5269 Int’l Ph: 323-846-6700
Fx: 1-800-624-5299 Int’l Fx:
www.mailboxes.com [e-mail]

Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.

Copyright © 2010 Salsbury Industries. All rights reserved. (Rev. 02, 11/3/2010)

323-846-6800