Salsbury Industries 2240GU, 2240BP, 2240AU, 2240AP, 2245ZP Installation Manual

Letter Boxes - Standard – 2240 and 2245

Installation Instructions

Thank you for selecting Salsbury’s Standard Letter Boxes. With their rugged all aluminum construction, Salsbury 2240 and 2245 Standard Letter
Boxes will provide years of maintenance free service.

Model 2240 Surface Mounted Unit

Model 2245 Recessed Mounted Unit

#2240 Overall Dimensions

15”W x 19”H x 7-1/2”D

1. Hold unit up on wall at desired height.

2. Open door and mark wall through the mounting holes provided
on back panel.

3. Using appropriate screws and anchors securely fasten unit to
the wall. Due to variations in wall materials, mounting hardware
is not supplied.

#2245 Overall Dimensions

15”W x 19”H x 6-3/4” D

Note: A 6-3/4” D clearance is required from the front of the wall for
the #2245 unit to install properly. If this clearance is not available,
please inquire about Salsbury’s slim letter box - 2265.

1. Hold unit up on wall at desired height.

2. Mark the unit’s location on the wall. Cut out the rough opening
in the wall (13-3/4”W x 17-3/4”H x 6-3/4”D).

3. Frame the opening and replace any framing/blocking that has
been cut.

4. Place unit in the opening and secure to the framing by drilling
screws from the inside of the box through the side of the walls
and into the framing.

#2245 Rough Opening Dimensions

13-3/4”W x 17-3/4”H x 6-3/4”D

SALSBURY INDUSTRIES

1010 East 62nd Street, Los Angeles, CA 90001-1598

Phone: [phone] Int’l Phone: [phone]

Fax: [phone] Int’l Fax: [phone]

www.mailboxes.com engineering

Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.

Copyright © 2006 Salsbury Industries. All rights reserved.

@mailboxes.com