Salsbury Industries 19900 User Manual

SALSBURY INDUSTRIES

1010 East 62nd Street, Los Angeles, CA 90001-1598

Phone: [phone] Int’l Phone: [phone]

Fax: [phone] Int’l Fax: [phone]

www.lockers.com www.mailboxes.com [e-mail] [e-mail]

19900 Free-Standing Enclosures

For 19000/19100 Series Recessed Mounted Cell Phone Lockers

Installation Instructions

Installation of the free-standing enclosure requires first installing the enclosure to its mounting surface, then installing the enclosure front panel to the
enclosure and lastly installing the recessed cell phone locker into the enclosure.

Installing Free-Standing Enclosure to Floor

Place the enclosure onto the selected location. Mark the fastener
locations on the mounting surface by transferring the four (4) large
holes locations in the bottom side flanges to the mounting surface.
Remove the enclosure and make the holes for the installation
fasteners. Install the fasteners (not provided). Return the enclosure
to the selected location. Complete the installation of the fasteners.
The use of leveling nuts on stud anchors is suggested.

Installing Enclosure Front Panel

Install the front panel to the enclosure using #10 x 1/2 in. long screws
(provided). Attach it to the enclosure along the two sides and the
bottom.

Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.

Copyright © 2013 Salsbury Industries. All rights reserved. (Rev. 02, 9/16/2013) Page 1 of 2

SALSBURY INDUSTRIES

1010 East 62nd Street, Los Angeles, CA 90001-1598

Phone: [phone] Int’l Phone: [phone]

Fax: [phone] Int’l Fax: [phone]

www.lockers.com www.mailboxes.com [e-mail] [e-mail]

19900 Free-Standing Enclosures

For 19000/19100 Series Recessed Mounted Cell Phone Lockers

Installation Instructions

Installing Recessed Cell Phone Locker – without
Front Access Panel

Install the locker unit into the enclosure by sliding it into the enclosure
until its front peripheral flange is flush against the front of the
enclosure. Open the four corner compartments of the cell phone
locker. Install #8 x 1-1/4 in. long screws (provided) through the top
and bottom of the locker unit into the enclosure. Close the
compartment doors.

Installing Recessed Cell Phone – with Front Access
Panel

Install the locker unit into the enclosure by sliding it into the enclosure
until its front peripheral flange is flush against the front of the
enclosure. Open the front panel access compartment of the cell
phone locker then open the front panel. Install #8 x 1-1/4 in. long
screws (provided) through the slots in the sides of the front
peripheral flange of the locker unit into the enclosure. Close the front
panel then the front panel access compartment.

Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.

Copyright © 2013 Salsbury Industries. All rights reserved. (Rev. 02, 9/16/2013) Page 2 of 2