Salsbury Industries 19000, 19100 User Manual

SALSBURY INDUSTRIES

1010 East 62nd Street, Los Angeles, CA 90001-1598

Phone: [phone] Int’l Phone: [phone]

Fax: [phone] Int’l Fax: [phone]

www.lockers.com www.mailboxes.com [e-mail] [e-mail]

Cell Phone Locker Pedestal

For Select 19000/19100 Series Surface Mounted Cell Phone Lockers

Installation Instructions

Installing the Cell Phone Locker on the Pedestal

Step 1: Install the pedestal to the mounting surface. Use 1/2 in. diameter anchors (not provided).

Step 2: Remove the cell phone locker from the enclosure. Drill eight (8) 7/16” diameter holes through the bottom of the enclosure. Match the hole
locations on the top pedestal plate.

Step 3: Position the enclosure on the top pedestal plate then position the interior support plate inside the enclosure. Assemble to the pedestal by
installing 3/8”-16 x 1-1/2” long hex bolts (provided) through the top pedestal plate, through the bottom of the enclosure and through the interior
support plate. Fasten with 3/8” lock washers and hex nuts (provided).

Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.

Copyright © 2013 Salsbury Industries. All rights reserved. (Rev. 1, 9/16/2013) Page 1 of 2

SALSBURY INDUSTRIES

1010 East 62nd Street, Los Angeles, CA 90001-1598

Phone: [phone] Int’l Phone: [phone]

Fax: [phone] Int’l Fax: [phone]

www.lockers.com www.mailboxes.com [e-mail] [e-mail]

Cell Phone Locker Pedestal

For Select 19000/19100 Series Surface Mounted Cell Phone Lockers

Installation Instructions

Installing the Cell Phone into the Enclosure – without
Front Access Panel

Install the cell phone locker into the enclosure by sliding it into the
enclosure until its front peripheral flange is flush against the front of
the enclosure. Open the four corner compartments of the cell phone
locker. Install #8 x 1-1/4” long screws (provided) through the top and
bottom of the locker unit into the enclosure. Close the compartment
doors.

Installing the Cell Phone into the Enclosure – with
Front Access Panel

Install the locker unit into the enclosure by sliding it into the enclosure
until its front peripheral flange is flush against the front of the
enclosure. Open the front panel access compartment of the cell
phone locker then open the front panel. Install #8 x 1-1/4 in. long
screws (provided) through the slots in the sides of the front
peripheral flange of the locker unit into the enclosure. Close the front
panel then the front panel access compartment.

Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.

Copyright © 2013 Salsbury Industries. All rights reserved. (Rev. 1, 9/16/2013) Page 2 of 2