Salamander Designs SNRC-B User Manual

SYNERGY TWIN RISER - SNR

®

Parts

5 - Aluminum Posts
1 - Top Shelf
2 - Rear Panels

Not available in custom sizes.)

1

Remove Top Bolts

If assembled, remove the 5 connector bolts
securing the top shelf. Set aside for Step 5.

(8.5” Risers Only.

(400-060) - 3/16” Hex Key

1x

(400-080) - 5/32” Hex Key

1x

2

Install Connector Studs

A. Screw threaded studs into the ends of the

B. Stick felt pads to underside of post, this will

posts and tighten with hex key.

prevent marring the surface of the top shelf.

(300-450) - Connector Studs

5x

(301-280)

Plastic Cap Plug

3

5x

(300-260)

Felt Pads

1x

Attach Riser Posts

Screw the posts into the base unit.
Be sure to square the post with the shelf.

Doc No. 500-770 / v7.05 / 1 of 2

SALAMANDER DESIGNS

Rear Panels

4

Slide the rear panels down the rear posts.

NOTE: Rears are only available for 8.5” Risers.
Not included with custom sized posts (SNR10,
SNR11 or SNR12).

5

Final Assembly

Insert 5 Connector bolts
from Step 2 and tighten
shelf down & place Cap
Plug into center hole.

Limited Warranty

For five full years Salamander Designs Ltd will repair or replace, at our option, any product defective in materials or craftsmanship. Salamander Designs Ltd. will not be responsible for any damage to or destruction of other
equipment consequential to our equipment failure. Defective product must be given Return Authorization and is to be returned to the factory prepaid, in the original carton and packing material. Any damage incurred in a
shipment not in original packaging shall be the responsibility of the owner. Warranty repairs will be returned prepaid, via UPS within the continental U.S.A. only.

Salamander Designs Ltd. 800-535-5659 • www.SalamanderDesigns.com ©2003 Salamander Designs Ltd. ® Synergy System, Patented. Doc No. 500-770 / v7.05 / 2 of 2