Salamander Designs SLW40C-B User Manual

SYNERGY WALL ASSEMBLY INSTRUCTIONS

Hardware Triple Wall Quad Wall

3/16” Hex Key 1x 1x

400-060

5/32” Hex Key 1x 1x

400-080

1/8” Hex Key 1x 1x

400-070

Joint Connector Bolt 2x 3x

300-540

Extension Stud

300-450

Cup Point Screw

300-505

Felt Pads

300-260

Metal Spacer Tabs

302-060

4x 5x

2x 2x

4x 5x

2x 3x

Parts Triple Quad

37.75” Posts (A)

37.75” Posts w/Holes (B)
Top Shelf

Rear Panels
Side Panels
Adapter Plates

Before You Begin

If you have an assembled Synergy Base you must first
remove the connector bolts securing the top shelf using
the 3/16” hex key and set aside for Step 6.

4x 5x
2x 2x
1x 1x

3x 4x
2x 2x
2x 2x

Flat Nuts

300-560

Caplugs

301-280

Grommet Cover
301-785 1x 1x

2x 2x

4x 6x

Limited Warranty

For five full years Salamander Designs Ltd will repair or replace, at our option, any product defective in materials or craftsmanship. Salamander Designs Ltd. will not be responsible for any damage to or destruction of other
equipment consequential to our equipment failure. Defective product must be given Return Authorization and is to be returned to the factory prepaid, in the original carton and packing material. Any damage incurred in a
shipment not in original packaging shall be the responsibility of the owner. Warranty repairs will be returned prepaid, via UPS within the continental U.S.A. only.

Salamander Designs Ltd. 800-535-5659 • www.SalamanderDesigns.com ©2005 Salamander Designs Ltd. Doc.# 500-960 v 8.05 / 1 of 3

1

Adapter Plates

A. Place a adapter plate at each end of

the base unit. Be sure to align the

bracket with the the holes as shown.

2

Install Posts

A. Screw threaded studs into the ends

all A posts. Tighten with hex key.
Stick felt pads to underside of post,
this will prevent marring the surface
of the top shelf.

Screw the rear posts through the panel
and into the bottom posts.

Do not over tighten.

- A

B. Place the two front posts onto the bracket.

Be sure to square the posts with the shelf.

A

A

A

A

B

B

Assemble 2 flat nuts with 2 set screws and
slide down the 2 front posts. Place screw
through the hole in the post and tighten.

- B

©2005 Salamander Designs Ltd. Doc. #500-960 v 8.05 / 2 of 3