Salamander Designs SLC20, SLC30 Assembly Instructions

SYNERGY SYSTEM

!

!

Model: SLC20

BEFORE YOU BEGIN:

TM

• Unpackallpartsandreadinstructionscarefullybeforebeginning.

•Shelfpegsanddoorhingesmustslideintothechannelsofthepostinthecorrectorder.

They cannot be removed individually without disassembly.

Connect Posts to Bottom Shelf

1

Model: SLC30

A. Square Post

Square the post to the bottom shelf.

O

90

B. Connect Post

Screw foot with metal washer through bottom
shelf and into the end of each extruded post.
Hand tighten fully and use wrench to tighten
nut onto underside of shelf.

WARNING: Tighten by screwing the leveler foot NOT the post.

Leveler Foot

Short Post

Washer

Hex Nut

Limited Warranty

Five full years Salamander Designs Ltd will repair or replace, at our option, any product defective in materials or craftsmanship. Salamander Designs Ltd. will not be responsible for any damage to or destruction of other
equipment consequential to our equipment failure. Defective product must be given Return Authorization and is to be returned to the factory prepaid, in the original carton and packing material. Any damage incurred in
a shipment not in original packaging shall be the responsibility of the owner. Warranty repairs will be returned prepaid, via UPS within the continental U.S.A. only.

Salamander Designs Ltd. • 800-535-5659 • www.SalamanderDesigns.com ©2006 Salamander Designs Ltd. Synergy System, Patented.

TM

Doc No. 500-982/v4.08 SLC -1/5

Add Shelf Pegs

SPACER

SPACER

1 2 3 4 5 6 7 8 9

S2 0 / S V D O

RE A R P A N E L

4

1 / 2

ww w.s ala man de rde sig ns. co m

E X T E N D E D

RE A R P A N E L

S3 0 / S 4 0

RE A R P A N E L

2

3

Attach Rear Panels

A. Pegs for Shelves

Insert one shelf peg down each post.
NOTE: There are two varieties of shelf pegs
(A and B). They are designed to cradle the
shelf in place. Refer to drawing.

A B

B

A

A

B

Note:

If installing 10” door(s), use 2
sets of shelf pegs at the top of
short posts to act as door stops.

A. Insert Hardware

Combine the 1” threaded studs with flat nuts.
Slide 2 sets of hardware down the two outside
posts and 4 sets down the center post. Allow
studs to remain loose at bottom of post.

2X

4X

4X

2X

B. Position & Secure Studs

Align the Spacer Tool at the top of each post,
then position top studs through the small “Rear
Panel” hole. Repeat this step with the bottom
studs aligning the Tool along the bottom of post
to set spacing for cable passage. Use the hex key
to secure the top and bottom studs to the posts.

TIP

To ease installation of rear
panels gently place the unit face
down on the floor to improve
alignment of panels.

B. Adjust Peg Height

Position the shelf peg through the Spacer Tool
and tighten at desired height. See step 4 for
fine tuning the shelves.

C. Place Rear Panels

Secure each panel in place with thumb nuts.

Doc No. 500-982/v4.08 SLC - 2/5