Salamander Designs SDAV1 6626 User Manual

SDAV1 5031

Assembly Instructions

Tools Required

Parts

1

8 - Dowels

4 5

2

4 - Screws

Thank you for purchasing the SDAV1 audio/video cabinet.

Unpack all content and check to ensure that all of the parts are in proper
condition. To help protect the environment, use the appropriate recycling
and discarding methods for the packaging items.

Assemble this item on a soft surface, such as carpet, to protect the nish.

3

8 - Shelf Pins

6

7

4 - Corner Legs

SDAV1_5031 6/11 page 1 of 4

1- Center Leg

2 - Shelves 2 - Rear Panels

1 Install Legs

1

8X

2

4X

4

4X

5

1X

2 Install Door Pulls

SDAV1_5031 6/11 page 2 of 4

3 Place Shelves

3

8X

6

2X

4 Install Rear Panels

7

2X

SDAV1_5031 6/11 page 3 of 4

Aligning Doors

Follow these instructions if you wish to adjust your doors.

Top View

Adjust screw “A” to allow door adjustment
in and out of the cabinet.

A

Front View

Use screw “B” to adjust the doors
to be parallel to the cabinet.

A B

Door Front

SALAMANDER DESIGNS LIMITED WARRANTY

Salamander Designs Ltd. (Salamander) provides the following Limited Warranty. The Limited Warranties herein

described for the specic products listed below shall be in lieu of any other warranty, expressed or implied, including
but not limited to any implied warranty of merchantability or tness for a particular use. These Limited Warranties

do not cover damages incurred in shipment, failures caused by other products not supplied by Salamander, or
failures due to accident, misuse, abuse or alteration of the product. Salamander’s sole liability and the purchaser’s

exclusive remedy shall be for the repair, or at Salamander’s option, for the replacement of the defective part as

provided herein. Notwithstanding the above, if replacement parts for defective materials are not available, Sala­mander reserves the right to make reasonable compensation in lieu of repair or replacement. Liability for incidental

or consequential damages under the warranty is excluded. Some states do not allow limitation of incidental or

consequential damages. Therefore, the above limitation may not apply in certain instances. Defective product
must be given Return Authorization by Salamander and is to be returned to the factory prepaid, in the original
carton and packing materials. Any damage incurred in a shipment not in original packing shall be the responsibility
of the owner. Warranty repairs will be returned to the owner prepaid, within the continental U.S.A. only. This

warranty gives you specic legal rights and you may also have other rights which vary from state to state.

Salamander Audio/Video Furniture Warranty Limitations - For two (2) full years Salamander will repair or
replace, at our option, any product defective in materials or craftsmanship.

WARRANTY PROCEDURE

Claims should be made through the dealer from which the product was purchased. The dealer will contact
Salamander Designs Ltd. (Salamander) for warranty service. An original sales order number/purchase order #
will be required for warranty protection. Salamander’s liability under this warranty is limited to repairing or replacing
at Salamander’s option any part or parts of the product found to be defective in material or workmanship within the
applicable warranty period. Salamander in its sole discretion will determine the cause and nature of any defect,
the necessity and manner of repair or replacement, and all other matters pertaining to the condition of the product.

B

phone: [phone]

web: SalamanderDesigns.com

LABOR AND SHIPPING CHARGES

Should you be entitled to receive a repair or replacement under this warranty, Salamander will pay the cost of
labor, handling and shipping to the consumer for two (2) years from the date of purchase by the original consumer.
After that date, the purchaser will be responsible for these costs.

SDAV1_5031 6/11 page 4 of 4