Salamander Designs SA-XR20-AC User Manual
E X T E N D E D R E A R /
ACTIVE COOLING KIT
MODELS: SA/XR, SAXR/AC
PARTS
4X
Thumb Nut
300-530
4X
Flat Nut
300-560
Skip steps 1 and 2 if you are not installing active cooling kit.
1. Attach Thermister
Use supplied Magnetic Cube to hold
Thermister in place on top of the hottest
piece of equipment closet to the heat
source. Consider your ”always on components”
(i.e. Satelite Receiver, Cable Box).
4X
Washer
300-515
1X - Allen Key 400-070
4X
Stud
300-505
4X
Drop-in Nut
300-565
2. AC Adapter
Plug in the AC adapter located on the top
right of the circuit board, behind the cover.
1X
Magnet
Note: You can also connect the thermister wire
directly to a component. Loosen screw and slip the
thermister wire under screwhead and tighten.
3. Install Extended Rear Panel(s)
A. Complete 4 hardware assemblies as shown.
B. Slide hardware assemblies loosely into four
outward slots in rear panels aligning drop-in
nuts vertically to fit into extrusion slot.
C. Align rear panel to rear of cabinet and while
pressing into extrusion turn thumbnuts clockwise
to complete the installation.
D. Place heat sensor on component that produces
the most heat. Note: Consider your ‘‘always on
components’’ (i.e. Satelite Receiver, Cable/DVR Box).
LIMITED WARRANTY
Salamander Designs warrants the Cooling Kit against defects in materials and workmanship for a period of two
year from date of purchase. We will repair or replace, at our option, any Cooling Kit which has a defect in materials
or workmanship. The product must be properly packaged and returned prepaid with a Salamander Designs return
authorization number clearly written on the outside of the shipping carton and with a copy of the bill of sale or
Salamander Designs invoice to verify the original purchase date.
Our warranty does NOT apply to:
1. Damage caused by improper installation or improper electrical voltage.
2. Any product which has been modied.
3. Damage caused by corrosion, abrasion, immersion, or severe temperatures.
4. Products which have been subject to abuse, misuse, abnormal usage, or accident.
These warranties give you specic legal rights, and are subject to any applicable consumer protection legislation.
You may also have additional rights which vary from state to state. No other warranties, expressed, implied, or written, shall apply to this product. Salamander will not be responsible for any consequential or incidental damages, loss
of property, revenues, or prot, cost of removal, installation, or reinstallation, personal injury, or for any breach of
warranty, regardless of how caused.
© 2008 Salamander Designs Ltd.
Doc. No. 500-395 v.1.10
Loading...