Salamander Designs CA-AC20 User Manual

chameleon

Active Cooling Kit

ASSEMBLY INSTRUCTIONS

The active cooling kit uses thermostatically controlled fans to keep gear running cool.

Attach Thermister

1

Use supplied Magnetic Cube to hold Thermister in place on top of
the hottest piece of equipment closet to the heat source.

Consider your ”always on components” (i.e. Satelite Receiver, Cable Box).

Note: You can also connect
the thermister wire directly to a
component. Loosen screw and
slip the thermister wire under
the screw head and tighten.

AC Adapter

2

Plug in the AC adapter bottom/center, behind fan grille.

Install Rear Panel

3

Limited Warranty

Salamander Designs warrants the Cooling Kit against defects in materials and workmanship for a
period of two years from date of purchase. We will repair or replace, at our option, any Cooling Kit
which has a defect in materials or workmanship. The product must be properly packaged and returned
prepaid with a Salamander Designs return authorization number clearly written on the outside of the
shipping carton and with a copy of the bill of sale or Salamander Designs invoice to verify the original
purchase date.

Our warranty does NOT apply to:

1. Damage caused by improper installation or improper electrical voltage.

2. Any product which has been modied.

3. Damage caused by corrosion, abrasion, immersion, or severe temperatures.

4. Products which have been subject to abuse, misuse, abnormal usage, or accident.

These warranties give you specic legal rights, and are subject to any applicable consumer protection

legislation. You may also have additional rights which vary from state to state. No other warranties,
expressed, implied, or written, shall apply to this product. Salamander will not be responsible for any

consequential or incidental damages, loss of property, revenues, or prot, cost of removal, installation,

or reinstallation, personal injury, or for any breach of warranty, regardless of how caused.

www.SalamanderDesigns.com

© 2006 Salamander Designs Ltd.

Doc No. 501-605 v1.10