Salamander Designs 245C-B User Manual

SYNERGY 245

!

Quad Assembly

Includes:

(1) Quad 20 Baseunit

(4) Side Panels

(4) Rear Panels

(2) S20 Doors

(2) S10 Doors

(2) Adjustable Shelves

(1) Double Width Shelf

BEFORE YOU BEGIN:

!

• Unpack all parts before beginning and refer to the drawing below.

• Shelf pegs and door hinges must slide into the channels of the post in the correct order.
They cannot be removed individually without disassembling the whole unit.

Limited Warranty

For five full years Salamander Designs Ltd will repair or replace, at our option, any product defective in materials or craftsmanship. Salamander Designs Ltd. will not be responsible for any damage to or
destruction of other equipment consequential to our equipment failure. Defective product must be given Return Authorization and is to be returned to the factory prepaid, in the original carton and packing
material. Any damage incurred in a shipment not in original packaging shall be the responsibility of the owner. Warranty repairs will be returned prepaid, via UPS within the continental U.S.A. only.

Salamander Designs Ltd. 800-535-5659 • www.SalamanderDesigns.com ©2005 Salamander Designs Ltd. ® Synergy System, Patented.

Doc No. 501-090/v10.12 245 - 1 of 4

1

!

Connect Posts to Bottom Shelf

WARNING: Tighten by screwing the leveler foot NOT the post.

!

A.

Square Post

Square the post to the bottom shelf.

90

2

Add Shelf Pegs & Door Hinges

A. Group Shelf Pegs

There are two varieties of shelf pegs (A and B).
They are designed to cradle the shelf in place.

O

Refer to drawing.

A B

B. Connect Post

Screw foot with metal washer through bottom
shelf and onto the end of each extruded post.
Place the 8.5” Post front and center of unit.
Hand tighten fully and use wrench to tighten
nut onto underside of shelf.

C. Post Cover

Press post cover onto 8.5” center
post to protect the center shelf.

Washer

Hex Nut

Leveler Foot

B

A

A

B

B. Heavy Duty Bracket

The heavy duty brackets will be used
to supoort the double-width shelf.

C. Door Hinges & Shelf Pegs

1. Slide the bottom hinge plate through the

front post channels. (Doors can be either left
or right side opening.)

2. Insert one shelf peg into each post

except the center posts.

3. Slide top hinge plate through front

post channels.

Doc No. 501-090/v10.12 245 -2 of 4