Section 1: PRODUCT AND COMPANY IDENTIFICATI ON
1.1
Product Name:
Product Form:
1.2
Product Use:
1.3
Supplier:
Phone Number:
1..4
Emergency Number:
Sakrete Cement Colors
Mixture
I
norganic pigment
Sakrete of North America
8201 Arrowridge Blvd.
Charlotte, NC 28273
866-725-7383
CHEMTREC (800) 424-9300
Section 2: HAZARDS IDENTIFICATION
2.1 Classification of the Chemical: Not classified
2.2 Label Elements:
Hazard Pictogram:
Signal Word: Hazard
Statement:
Prevention:
Response :
Storage:
Disposal:
N/A
N/A
No known significant effects or critical hazards.
N /A
N /A
Store in original container protected from direct sunlight in a dry, cool, and
well-ventilated area, away from incompatible materials and food and drink
N /A
2.3 Additional Information:
Hazards not otherwise classified :
Section 3: COMPOSITION / INFORMATION ON INGREDIENTS
N/ A
3.1
Mixture:
Ingredient
Calcium Carbonate
Iron (III) Oxide
CAS #
1317-65-3
1309-37-1
Wt. %
5-10
>90 %
%
There are no additional ingredients present which, within the current knowledge of the supplier and in the
concentration applicable, are classified as hazardous to health and hence require reporting in this section.
Occupational exposure limits, if available, arc listed i n Section 8.
1
Section 4: FIRST AID MEASURES
4.1 Description of First Aid Measures:
Eye
:
Skin
:
Inhalation:
Ingestion:
4.2 Most Important Symptoms and Effects, both Acute and Delayed:
Eye
:
Skin:
Inhalation:
Ingestion:
I
n case of contact, immediately flush eyes with plenty of water, occasionally lifting the
upper and lower eyelids. Check for and remove any contact lenses. Get medical
attention if irritation occurs.
In case of contact, immediately flush skin with plenty of water. Remove contaminated
clothing and shoes. Get medical attention if symptoms occur.
Remove victim to fresh ai r and keep at rest i n a position comfortable for breathing.
Get medical attention if symptoms occur.
Wash out mouth with water. Remove victim to fresh air and keep a t rest in a position
comfortable for breathing. If material has been swallowed and the exposed person is
conscious, give small quantities of water to drink. Do not induce vomiting uncles
directed to do so by medical personnel. Get medical attention if symptoms occur.
May cause mechanical irritation (abrasion).
May cause mechanical irritation (abrasion).
No known significant effects or critical hazards.
No known significant effects or critical hazards.
4.3
Indication of Any Immediate Medical Attention and Special Treatments Needed:
Note to Physicians: Treat symptomatically. No specific treatment.
Specific Treatments: No special measures required
Section 5: FIRE FIGHTING MEASURES
5.1 Extinguishing Media :
Suitable Extinguishing Media :
Use an extinguishing agent suitable for the surrounding fire.
In case of fire use water spray (fog), foam or dry chemical.
Unsuitable Extinguishing Media:
5.2 Special Hazards Arising From the Chemical
Products of Decomposition:
5.3 Special Protective Equip ment and Precautions for Fire Fighters
removing all persons from the vicinity of the incident
None known.
: No specific fire or explosion hazard.
Decomposition products may include the following
materials: carbon dioxide, carbon monoxide, metal
oxide/oxides
if
there is a fi re.
: Promptly isolate the scene by
No
action shall be taken involving any
personal risk or without suitable training. Fire-fighters should wear appropriate protective equipment and selfcontained breathing apparatus
(SCBA)
with a full face-piece operated i n positive pressure mode.
Section 6: ACCIDENTAL RELEASE MEASURES
6.1 Personal Precauti o ns, Protective Equipment and Emergency Procedures
taken involving any personal risk or without suitable train
i
ng. Evacuate surrounding areas. Keep
unnecessary and unprotected personnel from entering. Do not touch or wal k through spilled material.
Avoid breathing dust. Put on appropriate person protective equipment.
: No action shall be
2
OSHA PEL – TWA (respirable fraction)
OSHA PEL – TWA (total dust)
6.2 Environmental Precautions
waterways, drains and sewers. Inform the relevant authorities if the product has caused
soil,
environmental pollution (sewers, waterways, soil or air).
: Avoid dispersal of spilled material and runoff and contact with
6.3 Methods and Materials for Containment/Cleanup
release
Avoid
from upwind. Vacuum or sweep up material and place i n designated, labeled waste container.
creating dusty conditions and prevent wind dispersal. Dispose of via a licensed waste disposal
: Move containers from spill area. Approach
contractor. Note: see section 1for emergency contact information and section 13 for waste disposal.
Prevent entry into sewers, water courses, basements or confined areas.
Section 7: HANDLING AND STORAGE
7.1 Precautions for Safe Handling
equipment before entering eating areas. Workers should wash hands and face before eating, drinking
and smoking. Put on appropriate personal protective equipment. Eating, drinking, and smoking should
be prohibited in areas where this material is handled, stored and processed.
7.2 Conditions for Safe Storage, Including Any Incompatibilities
regulations.
area, away
closed and
kept
avoid
Store in original container protected from direct sunlight i n a dry, cool and well-ventilated
from incompatible materials (see section 10) and food and drink. Keep container tightly
sealed until ready for use. Containers that have been opened must be carefully resealed and
upright to prevent leakage. Do not store in unlabeled containers. Use appropriate containment to
environmental contamination. Empty containers or liners may retain some product residues.
Section 8: EXPOSURE CONTROLS AND PERSONAL PROTECTION
8.1 Control Parameters:
Exposure Guidelines
this product contains ingredient with exposure limits, personal, workplace, atmosphere or biological
If
monitoring may be required to determine the effectiveness of the ventilation or other control measures and/or
the necessity to use respiratory protective equipment.
: Avoid breathing dust. Remove contaminated clothing and protective
: Store in accordance with local
:
8.2 Exposure Controls:
Engineering Controls
8.3 Individual Protective Measures:
Personal Protective
Equipment
Eye/Face Protection
shields.
Skin Protection
Respiratory Protection
: Use only with adequate ventilation. If user operations generate dust, fumes,
gas, vapor or mist, use process enclosures, local exhaust ventilation or other
engineering controls to keep worker exposure to airborne contaminate
below any recommended or statutory limits.
:
: If contact with product is possible, wear safety glasses with side
: Wear sui table protective clothing and gloves. Suitable protective footwear.
: Dust- protection mask.
3