Thank you for purchasing your 93045 digital camera. Please read this manual carefully FIRST in order to
get the most out of your digital camera.
- 2 -
What your camera includes:
Digital Camera
Spider-Man Photo Lab software and driver installation CD
USB cable
User’s Manual
Strap
Computer System Requirements
To be able to download photos to your PC you will need the following minimum configuration:
Windows 2000/XP
Pentium-based PC (or equivalent)
200 MB hard disk free space and 128 MB or more RAM
Available USB Interface
CD-ROM Drive
Color display (16 bit or higher recommended)
Screen resolution 1024 X 768
- 3 -
A Quick Look at Your Camera
- 4 -
Preparing Your Camera for Use
Battery Installation
Your camera requires two AAA alkaline batteries, which must be inserted as follows:
1. Open the battery compartment on the bottom of the camera.
2. Insert the batteries in accordance with the polarity (+/-) shown on the inside of the
cover.
3. Close the battery compartment.
The LCD will flash if your batteries are running low in which case you will need to replace
the camera’s batteries before taking photos. When the battery voltage drops below 2.2V,
the LCD will display “Lo” and then automatically switch off.
Note: If you do not intend to use your camera for an extended period, remove the
batteries to avoid leakage and corrosion.
Warning:
•Please download any photos you have on the camera before opening the
battery compartment.
•Opening the battery compartment and/or removing the batteries will erase the
photos currently stored in the camera.
•Download your photos as often as possible. Photos may be lost when the
batteries run low.
- 5 -
Starting Your Camera
• Press the Mode button to start the camera.
• The camera will sound a beep to confirm that it is ready for use.
• The LCD display will indicate the number of photos that can be taken before it
becomes necessary to download them to your PC.
Taking Photos
1. Compose your shot using the viewfinder. (The optimal distance between the camera
and the subject is approximately 5 feet.)
2. Hold the camera steady and press the shutter button to take a photo.
3. The camera will beep when a photo is taken.
If the camera beeps twice rapidly or if "00" appears on the LCD this is an indication that the
memory is full in which event no further photos can be taken until the existing photos have
been downloaded and cleared from the camera memory.
Note: The LCD display indicates how many photos may still be taken at the current
resolution and compression. E.g. In "Lo" resolution and "Hd" compression 208 images
may be taken. However the LCD counter only displays up to 99. It will continue to display
99 until less than 99 images may still be taken.
- 6 -
The Camera Modes
Power Off - oF
1. Press the mode button to select “
2. Press the shutter button and the camera will switch off.
Self-Timer - St
1. Press the mode button to select the “
2. Press the shutter button to start a 10 second count down (the camera will beep once
a second).
3. After 10 seconds a photo will be taken.
Continuous Shot Mode - d8 (video)
1. Press the mode button to select “d8” shown on the LCD display.
2. Hold the shutter button down to shoot continuously.
3. The camera will continue to beep while the video is being taken.
Photos taken in Continuous shot mode may fail under poor lighting conditions. Photos taken in this mode
are saved as (avi) video clips.
oF” shown on the LCD screen.
St” icon shown on the LCD screen.
- 7 -
3 Shot Mode - CS
1. Press the mode button to select “CS” shown on the LCD display.
2. Press the shutter button once - 3 continuous shots are taken.
Note: The 3 photos taken in this mode will be downloaded individually.
Delete All - CA
To delete all photos on the camera:
1. Press the mode button to select the “
2. Press the shutter button and the photo counter will flash.
3. Press the shutter button again within 5 seconds and all photos in the camera will be
deleted.
4. The LCD counter will be reset to show the number of photos that can be taken at the
current resolution and compression.
Delete (Last Photo) - CL
To delete the last photo taken:
1. Press the mode button to select the “CL” icon shown on the LCD screen.
2. Press the shutter button within 5 seconds and the last photo will be deleted.
CA” icon shown on the LCD screen.
- 8 -
Loading...
+ 18 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.