Sakar 24280 User Manual

24280/24282 Digital

Camera

Owner’s Manual

Section One - Profile Overview

Thank you for purchasing this digital camera. Not only can it take photos but it also has built-in PC camera functions. This camera is equipped with 8MB SDRAM. In order to download photos from your camera to your computer, you need only connect the USB cable from your computer to your camera. You can also use the built-in PC camera to hold a video conference via the internet, enabling face to face online conversations.

Package Contents

* Digital Camera * User’s Manual * Neck Strap * Camera Stand * Software CD * USB cable

System Requirements

¾ Windows98 SE/ 2000/ ME/ XP ¾ 125MB or more free hard disk space, 32MB or more RAM. ¾ Available USB Interface and CD-ROM drive. ¾ Color Monitor (Recommended at least 800*600, 24 bit or higher)

Getting to Know your Digital Camera:

A. Camera/Charger selector B. Viewfinder C. Lens D. USB Socket E. Mode Button F. Shutter/ Confirm Button

- 1 -

Section Two - Lithium Battery

Before using your camera for the first time, charge your camera’s battery. Once the battery is charged, move the Camera/Charger selector to “Camera” mode. Do not move the selector back to “Charge” mode until you have downloaded all your photos to your computer and are ready to recharge the camera. Switching to Charge mode will erase all the photos on your camera.

To recharge your camera’s battery, connect the camera to your computer with the USB cable and move the Camera/Charger selector to “Charge” mode. When the batteries are recharging, the LED will be red. Once the batteries are fully charged, the LED will turn green (after less than 3hours). The camera will function normally while charging. We recommend charging your camera’s battery every 7 days or when you have used up the full memory capacity of the camera.

NOTE: first use.

In order to conserve battery power, if the camera is not used for 30 seconds, the camera will automatically enter energy save mode.

Section Three – Software and Camera DriverInstallation IMPORTANT: Before attempting to install the software, ensure that you do not have the camera attached to your computer. This will affect the installation process and could cause your installation to fail. Do not connect the cable to the computer until the entire installation process has been completed. We recommend the step by step instructions that will appear on your screen during the installation process.

The camera batteries must be recharged for at least four hours on the

following

1. Insert the CD into your CD-Rom drive. Make sure that your camera is not

connected to the computer.

- 2 -

2. For WIN 2000 or WIN XP operating systems - On the “Install your camera software” screen, select your camera model from the drop

down list and click the “Install” button to install PhoTags Express followed by the installation of PhoTags WebCam Express and your camera driver.

For WIN 98SE operating system- On the “Install your camera software” screen follow these instructions:

1. Click the “DirectX” button and follow the installation instructions, restart your computer after the installation.

2. Insert the CD into your CD-Rom drive. Make sure that your camera is not connected to the computer.

3. On the “Install your camera software” screen, select your camera model from the drop down list, click the “Install” button to install PhoTags Express followed by the installation of PhoTags WebCam Express and your camera driver.

4. On the “PhoTags Express" screen, click the “Next” button.

- 3 -

5. Please review the license terms and click the “Agree” button to continue.

- 4 -

6. Let the “PhoTags Express” installer create the folder where the program will be installed to, and then click “Install”

7. Click “Finish” to let the “PhoTags Express” installer finish the installation program.

- 5 -

+ 14 hidden pages