CLEVERBOARD 3 with LYNX 4
QUICK START GUIDE
LOADING DRIVER SOFTWARE
• Place the Cleverproducts disk (su
pp
lied with your board)
p(ppy)
into your computer.
• From the screen that automatically opens up on screen
“
-
”
select Cleverboard 3
GO (this is the driver). Do
NOT
have the computer connected to the board at this time.
• Follow the on screen instructions until “Finish” is
displayed
.
• Now connect your computer to the board via the USB
cable (supplied).
•
A
new USB device will be detected, Continue to load the
second part of the driver until “Finish” is once again
displayed.
py
LOADING LYNX SOFTWARE
• From the same disk su
pp
lied with the board now
pp
select “Lynx” “GO” and follow the on-screen
instructions.
•
Duri
ng the installation you w
ill b
e asked to type
in two sets of licence codes, one for Lynx and
one for Wordwall, these can be found on the
reverse side of the disk case.
• Note the red “cross” will not change to a green
“tick” until all of the code has been entered
correctly.
SET UP
• Should look something like this
• Computer to board via USB cable
•Com
p
uter to projector via VGA cable
ppj
• Image positioned on board
GETTING STARTED
• Check that the batteries in your pen are live by
yp y
pressing on the pen nib whilst holding the pen to
your ear and listening for a high pitched “buzzing
”
sound
• Ensure that the left hand door is in the open
“
”
position as this is the receiver device which will
not see the signal from the pen (transmitter) if
closed.
• If you are using the Ink Capture mode refer to
the Ink Capture document for the use of this
facility
.
Loading...