INSTALLATION GUIDE using mimio®technology & incorporating lynx software
using mimio®technology & incorporating lynx software
Mounting the mimio eraser and styli
• Install batteries in the mimio eraser and in each mimio stylus, Fig I
• Insert Expo® Dry Erase Markers according to the colour of the stylus, Fig J
I
AAA battery AAA battery
Install the software
• Insert CD into CD-Rom drive
• Loads automatically
• If CD fails to load, click: >Start >Run >Browse
>Choose CD Drive >Set up.exe >OK
Sahara Presentation Systems PLC
Williams House, Hailey Road, Erith Kent DA18 4AA England
www.cleverboard.com
CleverBOARD Helpline: 020 8319 7788
mimio is a registered trademark of Virtual Ink Corporation.
CleverBOARD is a registered trademark of Sahara Presentation Systems PLC.
J
Connecting the Cable
• Shut down your PC/Mac and make sure the power
is off
• Disconnect your keyboard from the keyboard port
• Connect the mimio cable as shown in Fig H
(ii)
C
D
H
PS2 Keyboard port
CleverBOARD
Single Wire
mimio Serial
Port Connector
Dual Wire PC
Serial Port
Connector
Line of fixing
Bottom of
CleverBOARD
Mounting the Cleverboard
• Pencil mark the top and bottom of the CleverBOARD as desired on wall, Fig A
• Fix brackets as shown in Figs B and C
• Lift CleverBOARD onto lower brackets, Fig D
• Push the top of the board towards the wall until it is vertical as in Fig D
• The push down top brackets until they ‘click’ onto the top of the board, Fig E
• The CleverBOARD is now securely wall mounted
G
F
Dismounting Cleverboard
• Push a flathead screwdriver under
the top brackets and turn clockwise
as shown in Figs F and G
A
(i)
225mm
E
225mm
Distance of bracket from
CleverBOARD edge
(ii)
Top of
CleverBOARD
(i)
B
Distance of bracket from
CleverBOARD edge
Line of fixing
Loading...