Sagrad SG9011203 Installation Instructions

Installation / Users Manual

For:

802.11 B/G/N WiFi Module
Model SG901-1203

Sagrad Inc.

Corporate Headquarters and Service

650 Atlantis Rd.

Melbourne, FL 32904

PH# 321-726-9400

Fax [phone]

www.Sagrad.com

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS. (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.”

Sagrad DOC # 906-0012

Product Description
You have purchased an 802.11 B/G/N module. This module is designed to be used
with different types of processors (Blackfin, Samsung, etc) and in different types of
applications (medical, industrial, etc).

For information on how to integrate the SW and Hardware for this module into the final
product please contact Sagrad Inc.

Warning: This device must be used with the following approved antennas:

1. MFG: Antenove Part#: 3030A5887-01

2. MFG: Sagrad SG901-1066

Use of any other antenna may violate you local government requirements such as the FCC
or IC.

NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE
CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS
COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT.

NOTE: “This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.”

Warning: Changes or modifications to this device not expressly approved by Sagrad could void the user’s
authority to operate the equipment.

Class B Device:

“NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.

• Consult the dealer or an experienced radio/TV technician for help.”

Modular Approved Device

showing that the unit contains the FCC approved device. See below for exact information on the label.

Contains FCC ID: VRA-SG9011203

: Please make sure to add a label on the outside of the final product

Sagrad DOC # 906-0012