Sagitter 1200 (PF09014), MOVING WASH 1200, PF09014 User Manual

MOVING WASH 1200 (PF09014)

Moving head projector

USER’ S MANUAL release 1.0

This manual must be considered an integral part of the projector.

1

BEFORE CONNECTING AND USING THE PROJECTOR, IT IS IMPORTANT TO READ CAREFULLY ALL THE
INSTRUCTIONS IN THIS MANUAL.

QUALIFIED PERSONNEL ONLY, IN COMPLIANCE WITH ALL THE SECURITY LAWS, CAN DO THE
INSTALLATION, THE MAINTENANCE AND THE UTILISATION OF THIS PROJECTOR.

BEFORE CONNECTING THE PROJECTOR, MAKE SURE THAT THE FREQUENCY AND THE VOLTAGE
VALUES ARE SUITABLE AS SPECIFIED ON THE PROJECTOR.

FOR ANY DOUBT, CONTACT YOUR SUPPLIER OR SEND AN E-MAIL TO:

[e-mail]

INDEX

GENERAL DESCRIPTION ---------------------------------------------------------------------------- page 2
START-UP PROCEDURES -------------------------------------------------------------------------- page 2
SPECIAL FUNCTIONS -------------------------------------------------------------------------------- page 5
DMX CHANNEL ASSIGNMENT -------------------------------------------------------------------- page 5
OPTICAL SYSTEM ------------------------------------------------------------------------------------ page 7
MAINTENANCE ---------------------------------------------------------------------------------------- page 8

2

GENERAL DESCRIPTION

Technical Features and Dimensions

Voltage rating 230 V
Rated current 7,4 A
Frequency 50 Hz
Maximum surface temperature 70º C
Distance from inflammable surfaces 2 mt
Weight 52,5 Kg
Protection rate IP20
HMI 1200/S short discharge lamp, socket SFc 10-4

CAUTION

The projector cannot be mounted on inflammable surfaces.

Norms applied to construction:

EN 60 598-1 EN 60 598-2-17 EN 294 EN 50 082-1
EN 55 015 EN 60 555-2 EN 61 000-3-2

Working Position

Moving Wash 1200 can work in all positions.

Admissible Environmental Conditions

The projector was engineered and produced to function in covered, dry areas with an air temperature ranging
between 5° and 35° C, and with a humidity level between 30 and 90%.Sharp changes in room temperature may
generate condensation inside the projector, which can harm the projector. Therefore, switch on the projector only
after it has undergone a period of gradual adaptation to the room temperature.

Storage

The projector, in its original packing, must be kept in covered, dry areas with a temperature between -10° C and
+50° C.

Mechanical Safety Guards

A bipolar cut-off switch is located between the lamp compartment and the cooling unit. This safety switch cuts off
the power to the projector if the top lid is opened.

Noise Level

After the projector has been powered up and the initial configuration takes place, the noise produced by the
projector is primarily due to its cooling system. The noise level is much lower than the limit of 70 dB permitted by
law.

Handling

The projector, with or without packing, must be handled with care. Lifting and handling must be carried out with
special equipment. Do not expose the projector, with or without its packing, to brusque accelerated or decelerated
movements, knocks, dragging, or other stress caused by unsuitable handling methods.