INSTRUCTION MANUAL
PHV-130
Mechanical/Hydraulic Machine Vice
130mm
V330
Page 1
Instruction Manual for PHV-130 (V330)
05/12/2014
Page 2
Instruction Manual for PHV-130 (V330)
05/12/2014
BEFORE OPERATION CHECK THE FOLLOWING
1. Check the accuracy sheet and attachment
2. Remove the protective layers of grease and rust preventive before moving
the slides.
3. Lubricate all slide ways and lubrication points
4. After setting the vice to the work piece size check that the lock pin is
securely through the side of the vice and the centre block. Not in front or
behind the centre block.
5. Insure that the vice is balanced before lifting
FEATURES
1. Mechanical/Hydraulic spindle
2. Down thrust “Semi-sphere Segment” mechanism eliminates jaw lift and
work tilting
3. All surfaces ground
4. Rigid vice body manufactured from ductile iron FCD 60JIS (equal to
GGG60) with 60kgs/mm or 80888 psi tensile strength
5. Vice bed flame hardened to HRC 45 to minimise wear and maintain
accuracy
Page 3
Instruction Manual for PHV-130 (V330)
05/12/2014
BEFORE INSTALLING VICE ON THE TABLE
1. Insure that the bottom of the vice the table and the Tee slots are clean and
free of swarf.
2. Secure the tee slot blocks provided into the base of the vice with the Allen head
screws.
Note! Make sure that the tee slot blocks are the correct size for the table slots.
If oversize machine to the correct size taking the material off one side only.
3. Lift the vice using the mounting lugs provided
Page 4
Instruction Manual for PHV-130 (V330)
05/12/2014
OPERATING INSTRUCTIONS
1. CLAMPING WITH HYDRAULIC POWER
a. Insure that the four lines on the
hydraulic spindle 34 are visible. To
bring them into full view hold the
cylinder 35 body and turn the
spindle 32 counter clockwise.
b. Slide the collar 33 to the non
en-gauge position.
c. Turn the handle clockwise to
bring the movable jaw into the
work piece
d. The vice will lock up as a
mechanical vice. When the
handle starts to tighten bump the
handle sharply clock wise with
your hand and the hydraulic
mechanism will commence. The
spindle 34 will remain
stationary and the outer handle
will turn.
e. The lines engraved on spindle 34
can be used as a guide to indicate the
amount of pressure applied to the job.
Maximum pressure is obtained when all the
lines have been covered.
f. To undo the vice wind the handle anti clock
wise. The outer spindle 32 will rotate with
34 remaining stationary until the hydraulic
system has reached its home position the
spindle 34 will rotate to undo the
mechanical side of the system.
Page 5
Instruction Manual for PHV-130 (V330)
05/12/2014
Page 6
Instruction Manual for PHV-130 (V330)
05/12/2014
Page 7
Instruction Manual for PHV-130 (V330)
05/12/2014
Page 8
Instruction Manual for PHV-130 (V330)
05/12/2014
Page 9
Instruction Manual for PHV-130 (V330)
05/12/2014
OTHER PRODUCTS
Compact CNC Vice
Double Lock CNC Vice
A
ir Operated Production Vice
Page 10
Instruction Manual for PHV-130 (V330)
05/12/2014
Loading...