How it Works
Safety Technology International
Loading...
STI-SA5500

Safety Technology International STI-SA5500 Installation Instructions

2020_V1.6
ON
OFF
SIRENVOL
1 2 3 4 5 6
1 2 3 4 5 6
ON DIP
ON
OFF
STROBE
LOW
BAT
1
2 3 4
1 2 3 4
ON
DIP
ON
OFF
LOW BAT
1
S1
STROBE
234
SLOW
FAST
VR1
5501
2020_v1.6
ON
OFF
S2
45 612 3
VOL SIREN
LOW BATTERY LED
DETAILS S1
DETAILS S2
S2
S1
FLASH RATE ADJUSTMENT
FAST
SLOW
PCB SCREWS
9 VDC BATTERY (NOT INCLUDED)
9 VDC BATTERY CONNECTOR
CIRCUIT BOARD
LENS
LENS
#6 x 2 1/2 in. SCREW
(2) PROVIDED
O-RING (2) PROVIDED
ELECTRONIC BASE
DRILL 3/16 DIA. HOLES
1 1/4 in. DEEP WHEN USING ANCHORS
DRILL 7/64 DIA. HOLES 1 1/4 in. DEEP
WHEN ANCHORS ARE NOT USED
#8-10 WALL ANCHOR (2) PROVIDED
S1
S2
REFLECTORS
LOW BATTERY
LED
FLASH RATE ADJUSTMENT
2020_V1.6
ON
OFF
SIRENVOL
1 2 3 4 5 6
1 2 3 4 5 6
ON DIP
ON
OFF
STROBE
LOW
BAT
1
2 3 4
1 2 3 4
ON
DIP
ON
OFF
LOW BAT
1
S1
STROBE
234
SLOW
FAST
VR1
5501
2020_v1.6
ON
OFF
S2
45 61 23
VOL SIREN
LOW BATTERY LED
DETAILS S1
DETAILS S2
S2
S1
FLASH RATE
ADJUSTMENT
FAST
SLOW
Don’t Touch LED
Don’t Touch LED
1
Siren
Volume
2
3
4
5
6
ON
OFF
1
Strobe
LOW
BAT
2 3
ON
OFF
4
5500
V1.3_x1
Slow
Fast
2.83 in.
(71.8 mm)
1.02 in.
(26.0 mm)
3.87 in.
( 98.2 mm)
LENS
9 VDC BATTERY (NOT INCLUDED)
9 VDC BATTERY CONNECTOR
CIRCUIT BOARD
REFLECTORS
O-RING (2) PROVIDED
PCB SCREWS
1 1/4 in. DEEP WHEN USING ANCHORS DRILL 7/64 DIA. HOLES 1 1/4 in. DEEP
WHEN ANCHORS ARE NOT USED
#8-10 WALL ANCHOR (2) PROVIDED
ELECTRONIC BASE
DRILL 3/16 DIA. HOLES
SPECIFICATION Input Standby Operating
9VDC < 14µA 0.95A 12VDC < 180µA 0.96A 24VDC < 170µA 0.49A
Operating Temperature
-4°F to 140°F (-20°C to 60°C)
BATTERY INSTALLATION/REPLACEMENT
1. Unscrew lens to remove.
2. Loosen PCB screws (do not remove).
3. Gently rotate PCB without touching LED’s and without damaging the reflectors.
5. Re-install PCB and tighten screws. NOTES
1. Internal battery will provide backup power if loss of external power.
2. If no internal battery is used, remove all power and move S2-1 to “OFF” position (see detail S2).
( 98.2 mm)
3.73 in.
(94.6 mm)
.94 in.
(23.8 mm)
1.02 in.
(26.0 mm)
2.83 in.
(71.8 mm)
1 2 3 4
1 ON 0 OFF
S2 - LOW BAT. NOTIFICATION/STROBE CONTROL
3.87 in.
#6 x 2 1/2 in. SCREW
LENS
(2) PROVIDED
LOW BATTERY OPERATON
Replace battery when low battery condition occurs, Low battery LED flashes 1x per 1 minute and sounder beeps 1x per 3 minutes
1 2 3 4 FUNCTION 1 LOW BATTERY NOTIFICATION ON * 0 LOW BATTERY NOTIFICATION OFF * 0 0 0 CONTINUOUS “ON” 0 0 1 DOUBLE LED ROTATION 0 1 0 3 FLASH - DELAY - 3 FLASH 0 1 1 SINGLE LED ROTATION (FAST) 1 0 0 FLASHING
WARNING: This product can expose you to chemicals including Dichloromethane, which is known to the State of California to cause cancer, and Bisphenol A (BPA), which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Three year warranty or a one year limited warranty (from date of purchase) on most products.
LED
DETAIL S1
LOW BATTERY
S1
6
5 4 3
2
Siren
1
ON
OFF
ON
OFF
S2
Don’t Touch LED
LOW
1
BAT
Volume
2
Fast
3
Strobe
4
Don’t Touch LED
V1.3_x1
Slow
5500
FLASH RATE ADJUSTMENT
DETAIL S2
See pg. 2
1 0 1 INTENSITY RAMPING UP & DOWN 1 1 0 SINGLE LED ROTATION (SLOW) 1 1 1 RIGHT/LEFT ROTATION
*Default Settings
INSTALLATION OF STI-SA5500 SELECT ALERT SIREN/STROBE
All specifications and information shown were current as of publication and are subject to change without notice.
SA5500IS DEC2020
SIREN
STROBE
TRIGGER
(NOT PROVIDED)
TRIGGER
(NOT PROVIDED)
TRIGGER
(NOT PROVIDED)
Control with Power Supply
-
Not supervised
- Alarm on close
- Cannot use battery turn off Low Battery Detect
STROBE & SIREN
9VDC
RED (+)
BLU YEL
BLK (-)
+
-
STROBE ONLY STROBE ONLY
9VDC
RED (+)
BLU YEL
BLK (-)
+
-
SIREN ONLY
9VDC
RED (+)
BLU YEL
BLK (-)
+
-
Power Supply Plus Battery
- Supervised trigger
- Alarm on open trigger
- Low battery alert (Turn off if battery not used)
+
-
+
-
+
-
STROBE & SIREN
9VDC
RED (+)
BLU YEL
BLK (-)
9VDC
RED (+)
BLU YEL
BLK (-)
SIREN ONLY
9VDC
RED (+)
BLU YEL
BLK (-)
TRIGGER (NOT PROVIDED)
TRIGGER (NOT PROVIDED)
TRIGGER (NOT PROVIDED)
Battery Only
- Supervised trigger
- Alarm on open trigger
- Low battery alert
STROBE & SIREN
9VDC
RED (+)
BLU YEL
BLK (-)
STROBE ONLY
9VDC
RED (+)
BLU YEL
BLK (-)
TRIGGER
(NOT PROVIDED)
SIREN ONLY
9VDC
RED (+)
BLU YEL
BLK (-)
TRIGGER
(NOT PROVIDED)
TRIGGER (NOT PROVIDED)
S1 ALARM TONES 1 2 3 4 5 FUNCTION * 1 1 1 1 1 1800Hz - 3300Hz @ 150ms O 1 1 1 1 500Hz - 1200Hz, 0.5s/ 0.5s OFF x 3/1.5s OFF (AS1670 EVACUATION) 1 O 1 1 1 520Hz, 0.5s / 0.5s OFF x 3/1.5s OFF (FIRE) O O 1 1 1 1200Hz - 500Hz @ 1Hz (DIN 33 404) 1 1 O 1 1 500Hz - 1200Hz, 3.75s ON / 0.25s OFF (AS2220) O 1 O 1 1 550Hz/440Hz @ 0.5 Hz 1 O O 1 1 970Hz, 0.5s/ 630Hz, 0.5s O O O 1 1 800Hz / 1000Hz 0.5s each (1Hz) 1 1 1 O 1 1500Hz - 2700Hz @ 3Hz O 1 1 O 1 800Hz / 970Hz @2Hz 1 O 1 O 1 800Hz, 0.25s ON/ 1s OFF O O 1 O 1 2400Hz - 2900Hz @ 9 Hz 1 1 O O 1 750Hz O 1 O O 1 970Hz 1 O O O 1 970Hz, 1s OFF/1s ON O O O O 1 500Hz - 1200Hz, 3.5s ON/ 0.5s OFF (NEN 2575:2000 DUTCH SLOW WHOOP) 1 1 1 1 O 800Hz - 970Hz @1Hz O 1 1 1 O 1000-2500Hz, 0.5s/ 0.5s OFF x 3/1.5s OFF (AS1670 EVACUATION) 1 O 1 1 O 2850Hz, 0.5s ON/0.5s OFF x 3/1.5s OFF (ISO 8201) O O 1 1 O 660Hz 1.8s ON/1.8s OFF 1 1 O 1 O 500Hz - 1200Hz @ 0.33Hz O 1 O 1 O 250Hz - 1200Hz @ 12Hz 1 O O 1 O 2400Hz O O O 1 O 800Hz - 970Hz @ 9Hz 1 1 1 O O 510Hz, 0.25s/ 610Hz, 0.25s O 1 1 O O 550Hz, 0.7s/1000Hz, 0.33s 1 O 1 O O 660Hz 0.15s ON/0.15s OFF O O 1 O O 800Hz - 970Hz @ 3Hz 1 1 O O O 420Hz 0.625s ON/0.625s OFF (AUSTRALIA AS1670 ALERT TONE) O 1 O O O 554Hz, 0.1s/440Hz, 0.4s (AFNOR NF S 32 001) 1 O O O O 970Hz, 0.5s ON/0.5s OFF x 3/1.5s OFF (ISO 8201) O O O O O 2400Hz - 2900Hz @ 3 Hz
S1 VOLUME 6 FUNCTION * 1 High volume 0 Low volume
* Default Settings
1 2 3 4 5 6
1 ON 0 OFF
INSTALLATION OF STI-SA5500 SELECT ALERT SIREN/STROBE
All specifications and information shown were current as of publication and are subject to change without notice.
SA5500IS DEC2020
Loading...
Buy Points How it Works FAQ Contact Us Questions and Suggestions Privacy Policy Cookie Policy Terms of Use