Safety Technology International Exit Stopper STI-6400 Series Quick Install Manual

SET UP

ON

OFF

LED
DO NOT TOUCH

Exit Stopper

Quick Install

STI-6400 Series

®

1. Key in OFF position

4. Choose setting – refer

to switch table, default
settings shown side 2

LED ­Do Not Touch

2. Remove security screw

5. Unwrap battery

and connect

3. Remove cover from base,

push on lock to separate

1

2

6. Terminal block (for remote and

relay options) – refer to full install
online for wiring connections

7. Test – place magnet next to reed, turn on,

separate magnet from reed

8. Apply language label if desired

MOUNTING

MOUNTING HOLESMOUNTING HOLES

9. Place reed at desired location

(top, right, bottom or left)

11. Install reed magnet, mark with pencil,

drill, install using plastic anchor, drill
3/16” (4.5mm). Install into wood or
steel: drill 1/8” (3mm). Mount with (2)
M3.5 x 32mm screws.

10. Position base. Mark and drill four (4) holes 1”

(25mm) deep. Using plastic anchor, drill 3/16”
(4.5mm). Install into wood or steel: drill 9/64”
(3.5mm). Mount using (4) M4 x 25mm screws.

Mounting holes

Mounting holes

12. Test, turn key on, open door

13. Replace cover, snap lid from top,

secure with security screw

2306 Airport Rd • Waterford, MI 48327, USA

Phone: [phone] • Fax: [phone]

SWITCH SETTINGS 1 2 3 4 5 6 7 8

Arming - immediate OFF*
Arming - 15 second delay ON
Trip - immediate OFF*
Trip - 15 second delay ON
Shut-off based on duration

(switches 4 & 5)

Shut-off approx. 3 sec. after
door closes

Duration - 30 second alarm OFF* OFF*
Duration - 180 second alarm OFF ON
Duration - continuous alarm ON OFF
Duration - annunciator mode ON ON
Low battery detection ON OFF*
Low battery detection OFF ON
Volume - high ON*
Volume - low OFF
Relay function OFF OFF*
Relay function ON ON

*default

[e-mail] • www.sti-usa.com

OFF*

ON

Subject to change
without notice.

Taylor House • 34 Sherwood Road • Bromsgrove, Worcestershire • B60 3DR • England

Tel: [phone] • Fax: [phone] • [e-mail] • www.sti-emea.com

6400 QUICK INSTALL

FEB2018