Safety 1st 8023, Glow & Go 08023 User Manual
French Guide Included
Mode d’emploi
en français inclus
User Guide
©2008 Dorel Juvenile Group. All Rights Reserved.
www.djgusa.com (800) 544-1108
www.safety1st.com
Made in CHINA. Fabriqué en CHINE.
Styles and colors may vary. Les styles et les couleurs peuvent varier.
Distributed by (distribué par) Dorel Juvenile Group, Inc.,
2525 State St., Columbus, IN 47201-7494
Dorel Distribution Canada, 873 Hodge, St-Laurent, QC H4N 2B1
04/02/08 4358-4554
Glow & Go
Monitoring System
08023
PLEASE READ THE FOLLOWING WARNINGS AND ALL ASSEMBLY
INSTRUCTIONS CAREFULLY BEFORE USING THE GLOW & GO MONITORING
SYSTEM. KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
TERMS USED IN WARNINGS:
The term “Receiver” corresponds to “Parent’s
Unit” and the term “Transmitter” corresponds to “Baby’s Unit” in the rest of this
instruction booklet.
• The Glow & Go Monitoring System is not intended to replace responsible and
proper parental supervision.
• Check your child’s activity at regular intervals as this monitor will not alert
parents to the silent activities of a child.
• Before using your Glow & Go Monitoring System:
- Read and follow all instructions carefully.
- Read and observe all warnings on the product and in this
instruction booklet.
• To prevent entanglement with the adapter cord,
NEVER PLACE THE CORD IN
OR NEAR A CRIB OR PLAYPEN.
DO NOT place the Receiver anywhere its AC
adapter cord is within reach of children.
•
ALWAYS KEEP THE TRANSMITTER, RECEIVER AND AC ADAPTERS OUT OF
REACH OF CHILDREN.
• This product is not intended to be used as a medical monitor and its use
should not replace adult supervision.
• It is essential to check reception regularly. Please see the Testing Reception
section for complete instructions.
• The Glow & Go Monitoring System is intended for indoor use only.
•
NEVER use the Transmitter or Receiver near water. For example, do not use
near a bathtub, bathroom sink, laundry tub, kitchen sink, in a wet basement,
etc.
• Always unplug the AC adapters from wall outlets during long periods
of non-use.
• Position the Transmitter, Receiver and AC adapters to allow adequate
ventilation and prevent these components from overheating.
• To prevent overheating, keep the Transmitter, Receiver and AC adapters away
from heat sources such as radiators, heat registers, stoves or other
appliances (including amplifiers) which produce heat. Also keep these
components out of direct sunlight.
• Use only the AC adapters provided. Use of any other adapters may damage
the Transmitter and/or Receiver. Plug the AC adapters into standard
household current only (120V AC outlet)! To prevent entanglement and
overheating,
DO NOT use extension cords.
•
The AC adapters may become slightly warm to the touch during operation.
This is nor
mal.
• Position the AC adapter cords so that they are not walked on or pinched by
items placed upon or against them, paying par
ticular attention to cords at AC
WARNING
2
3
adapter plugs, wall plugs, and the point at which the cords attach to the
Transmitter and Receiver.
• This product should be serviced only by qualified service personnel at Dorel
Juvenile Group when:
- An AC adapter or its plug is damaged,
- The Transmitter or Receiver have fallen,
- Liquid has spilled into the Transmitter or Receiver or
- The Transmitter or Receiver do not appear to operate normally or exhibit a
marked change in performance
•
DO NOT attempt to service this product beyond that described in the
Troubleshooting section at the end of these instructions. All other servicing
should be referred to qualified personnel at Dorel Juvenile Group.
NOTE: The LEDs emit IR (infra red) light that is not harmful.
TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE THIS
PRODUCT TO WATER OR MOISTURE. NEVER ATTEMPT TO OPEN THE CASE OF THE
PRODUCT. THIS IS DANGEROUS AND WILL VOID THE WARRANTY.
NO SERVICEABLE
PARTS INSIDE. REFER SERVICING TO DOREL JUVENILE GROUP CONSUMER
RELATIONS (800) 544-1108.
WARNING
FCC Information
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
•
The carrier fr
equency on channel I is 49.850 MHz and the carrier frequency on channel II is 49.870 MHz.
•
The field strength is 80 dB microvolts per meter at 3 meters.
WARNING: Changes and modifications not expressly approved by Dorel Juvenile Group or registrant of
this equipment can void your authority to operate this equipment under Federal Communications
Commissions r
ules.
CLEANING: Use a dry cotton cloth to keep the Monitor free from dust. Do Not Use Water!
NOTE: We've included a thermometer to help assure you that the temperature of your baby's room is
within the comfortable and recommended range of 16°C to 20°C. We recommend you check against
your home thermometer to ensure accuracy.
4
• Lay out and identify all parts.
• Do not return this product to the place of purchase. If any parts are missing, or if you are having
difficulty using this product, email consumer@djgusa.com, call Consumer Relations at
(800) 544-
1108, or f
ax a
t (800) 207-8182. You can also visit our website at www.safety1st.com.
Have the model number (08023) and date code (manufacturing date) ready before you call.
T
he da
t
e c
ode is loca
t
ed inside the battery compartment of the Parent’s Unit.
• The Parent’s Units take 3 AAA alkaline batteries (not included). The Baby’s Unit takes one 9
volt battery (not included. AC adapter may be used instead of batteries.
• There are two Parent’s Units included with this model that function identically. For simplicity,
the instructions will state “Parent’s Unit” throughout.
Keep These Instructions for Future Use
LCD Display
On/Off
Channel Switch
AC Port (on back)
Microphone
Nightlight On/Off
AC/DC Adapter (3 included)
Night Glow LEDs (3)
Green Power On Indicator
A
B
C
D
Features and Components
E
F
G
Antenna/Handle
Volume Control
Sound Lights
On/Off
Speaker
Channel Selector
Green Power On Indicator
J
M
N
O
2 Parent’s Units
Baby’s Unit
A
F
L
O
L
E
K
B
J
N
K
M
C
G
Baby’s room temperature
D
E
H
I
P
P
H
I
NOTE:
The Parent’s Unit and Baby’s Unit may use either the
AC adapter or batteries. When plugged in, the AC adapter will
be the source of power.
1.
Battery Use: Unscrew the screw on the back of the
Parent’s Unit
(Figure A). Pull off the battery door.
Insert batteries with polarity as indicated. Secure the
door with the screw.
2.
AC Use: Connect the AC adapter into the side of
the Parent’s Unit
(Figure A). Connect the AC
adapter into a power outlet.
NOTE:
Parent’s
Unit may be used as traditional monitor,
on a table top or other flat surface, or it may be carried
with you. If desired, slide the belt clip over your belt.
IMPORTANT: When choosing locations to set
up the Baby’s Unit and Parent’s Unit follow
these guidelines:
•
For best sound quality, place Baby’s Unit 4
to 6’ (1.5 to 2 m) away from the baby.
•
Use the Parent’s Unit far enough away
from the Baby’s Unit so as not to get
feedback.
5
Setting Up Your Glow & Go Monitoring System
Choose Locations:
To Set Up the Parent’s Unit:
CAUTION
A
Screw
• During use of the monitor, if the sound
quality deteriorates you may be reaching
the limits of the monitor’s range. If this
happens, you will need to move the
P
arent’s Unit in closer proximity to the
Baby’s Unit.
• Adjust the volume to a comfortable level
for your environment.
• Keep these instructions as they contain important
information.
•
DO NOT mix old and new batteries.
•
DO NOT mix alkaline, standard (carbon zinc), or
rechargeable (nickel-cadmium) batteries.
• Non rechargeable batteries are not to be recharged.
• Check that all contact surfaces are clean and
bright befor
e installing batteries.
• The supply terminals are not to be short-circuited.
•
DO NOT submerge any part of the product in water.
• Dispose of batteries safely.
• Remove batteries when stor
ed for long periods of
non-use.
• Unplug power cord before replacing batteries.
BATTERY CAUTION:
• Use only the adapters supplied with this
product. Incorrect adapter polarity or voltage
can seriously damage the product.
• THERE IS A RISK OF EXPLOSION IF THE
BATTERIES ARE REPLACED BY AN
INCORRECT TYPE.
• Use AAA size alkaline batteries only for parent
unit, and a 9 volt battery for baby’s unit
(batteries not provided).
• When using batteries, check batteries regularly. DO NOT use monitor system in
portable mode when batteries are low.
• DO NOT submerge any part of the product in water.
• Remove batteries when stored for long periods of non-use.
• Unplug power cord before replacing batteries.
Loading...