Group : 0+/1/2
Weight : 0-25kg, from birth up to approx. 7 years
GlideFix
Child Restraint System
User Guide
1
Congratulations on your purchase!
To ensure maximum protection and optimum comfort for your
child, it is essential that you read through the entire manual
carefully and follow all instructions.
IMPORTANT — DO NOT USE FORWARD
FACING BEFORE THE CHILD’S WEIGHT
EXCEEDS 9 kg!
DOREL AUSTRALIA PTY LTD
655-685 Somerville Road
Sunshine West Victoria 3020
This restraint system is ISOFIX Universal when used in Group 1
(9-18 kg) with ISOFIX:
NOTICE
1. This is an ISOFIX CHILD RESTRAINT SYSTEM. It
is approved to Regulation No. 44, 04 series of
amendments for general use in vehicles fitted with
ISOFIX anchorages systems.
2. It will fit vehicles with positions approved as ISOFIX
positions (as detailed in the vehicle handbook),
depending on the category of the child seat and of the
fixture.
3. The mass group and the ISOFIX size class for which
this device is intended is: 9-25 kg and B1.
2
This restraint system is ‘Universal’ when used in group
0+/1/2 (0-25 kg) with vehicle belt:
NOTICE
This is a ‘Universal’ child restraint. It is approved to
Regulation No. 44, 04 series of amendments, for general
use in vehicles and it will fit most, but not all, car seats.
A correct fit is likely if the vehicle manufacturer has
declared in the vehicle handbook that the vehicle is
capable of accepting a ‘Universal’ child restraint for this
age group.
This child restraint has been classified as ‘Universal’
under more stringent conditions than those which
applied to earlier designs which do not carry this notice.
If in doubt, consult either the child restraint
manufacturer or the retailer.
This restraint system is ‘Semi-universal’ when used in group 2
(15-25 kg) installed with ISOGO and vehicle belt, and suitable
for fixing into the seat positions of the following cars:
CAR FRONT REAR
Car Fitting List Outer Outer Centre
No Yes No
Seat positions in other cars may also be suitable to
accept this child restraint. If in doubt, consult either the
child restraint manufacturer or the retailer.
3
4
Table of Contents
Understanding Your Car seat
Parts ...............................................................................6
Installation Position ...................................................9
Installation in Vehicle
Gr0+ Vehicle Belt Installation ...............................10
Gr1 Vehicle Belt Installation ...................................13
IMPORTANT — Only suitable if the approved
vehicles are fitted with 3 point with retractor
safety- belts, approved to UN/ECE Regulation
No. 16 or other equivalent standards.
ProhibitionCorrect position
See Car Fitting List
9
Gr0+ Vehicle Belt Installation
Group 0+(0-13 kg), Rear Facing, Vehicle Belt Installation
NOTE:
Group 0+.
X2
The Top Tether must be removed when used in
1. Rotate the top tether's 2
metal retainers, pull out
them to remove the top
tether.
2. Recline the seat to R
position.
3. Put the restraint rear
facing to the vehicle
seat, pull out the
vehicle's safety belt.
WARNING: DO NOT USE FORWARD FACING BEFORE
THE CHILD’S WEIGHT EXCEEDS 9 kg!
10
Gr0+ Vehicle Belt Installation
4. Pass the seat belt from
the back of the seat.
5. Pass the shoulder belt
from the back of the
seat guide hook, make
sure the shoulder belt
is limited in the guide
hook.
WARNING:
DO NOT place rear-facing child seat on
front seat with airbag!
6. Pass the lap belt from
the Gr0+ belt guide and
make sure the lap belt
is limited in the guide
hook.
11
Gr0+ Vehicle Belt Installation
7 . Pass the lap belt from
the bottom of the seat
base as shown.
8. Pull out the lap belt
from the other side of
the Gr0+ belt guide,
lock the tongue into the
buckle until you hear the
"click!"
CLICK!
9. Secure the seat firmly,
and tighten the shoulder
belt.
12
Loading...
+ 28 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.