Safety 1st 44301A User Manual

Tubside

Bath Seat

44301A

User Guide

Questions?
Comments?
Contact Us:

www.safety1st.com

[phone]

©2006 Dorel Juvenile Group. All Rights Reserved.
www.djgusa.com [phone]

.safety1st.com

www
Made in USA.
Styles and colors may vary. Les styles et les couleurs peuvent varier.
Los estilos y los colores pueden variar.
Distributed by (distribué par) (distribuido por) Dorel Juvenile Group, Inc.,
2525 State St., Columbus, IN 47201-7494
Dorel Distribution Canada, 873 Hodge, St. Laur
8/30/06 4358-3305C

Fabriqué aux États-Unis

.

Hecho en EE.UU.

ent, QC H4N 2B10

WARNING:

PLEASE READ THE FOLLOWING
WARNINGS AND ALL ASSEMBLY
INSTRUCTIONS CAREFULLY BEFORE
USING THE TUBSIDE BATH SEAT. KEEP
THESE INSTRUCTIONS FOR FUTURE
REFERENCE.

PREVENT DROWNING:

• Babies can drown in as little as 1 inch of water.

ALWAYS bathe your infant using as little water

as necessary.

• Babies can drown even when other children are in
or near the bathtub.
children to substitute for an adult.

• Children have drowned when left unattended in
bath seats.
reach.

NEVER USE BATH SEAT UNLESS IT IS

•
PROPERLY ATTACHED TO A BATH TUB.

• Product is suitable for children able to sit up
unassisted (approximately 5 months of age).

• Product is not suitable for children able to pull up to
a standing position who may attempt to climb out
(approximately 10 months of age).
Discontinue use if this product becomes

•
damaged, broken or disassembled.

2

ALWAYS keep child within arm’s

DO NOT allow other

Parts Names

NOTE: There are no parts to assemble. The names of parts are shown below for
your convenience.

B

A

C

E

Adjustable Arm

A

Elbow Cushion

B
C

Locking Button

D

Clamp Handle

D

G

Passive Restraint Seat

E

Swivel Seat Locking Tab

F

Bath Seat

G

F

NOTE: The Tubside Bath Seat fits on most standards tubs. DO NOT use on the
following style tubs:

• The tub edge width is less than 3.5” (8.9 cm) or greater than 5.5” (14 cm)

• The inside depth (top to bottom) is less than 12” (30.5 cm) or gr

eater than

15.5” (39.37 cm)

• Free Standing (legged or pedestal), Oval or Drop-In

• Spa Type

3

Setting Up Your Tubside Bath Seat

To Set Up:

1. Slide the Adjustable Arm up, depress

Locking Button, and fully extend
Arm.

2. Turn the Adjustable Arm 180

degr

ees (Figure 2). Slide the Arm
down past the Red Warning Label
(Figure 2a).

1

Adjustable
Arm

Locking Button

2

2a

Red
Warning
Label

4

Setting Up Your Tubside Bath Seat

3. To place the bath seat onto tub, grasp

the Bath Seat and pull the Clamp
Handle underneath the Elbow Cushion
until fully extended.

4. With Clamp Handle fully extended, fit

the Elbow Cushion around the tub
edge. Let the Bath Seat slide down to
the tub floor. Release the Clamp
Handle only when the Bath Seat and
Elbow Cushion are fully resting on the
tub.

CAUTION:

DO NOT use the Bath Seat if:

• the bottom of Red Warning Label
is exposed (Figure 4a).

3

4

4a

Clamp
Handle

Elbow Cushion

• the Bath Seat and Elbow Cushion
are not in full contact with the
surfaces of the tub.

To Swivel Bath Seat:

TIP: Choose your desired seat position
before placing your child in the bath
seat.

1.

To Swivel Seat: Lift Locking Tab on
back of seat. Rotate seat away from
Elbow Cushion.

NOTE: Seat will only swivel 260

ees. Do not force seat.

degr

o Lock Seat

2.

T
Tab on back of seat.

NOTE: Be sure to always lock the seat
before placing a child in the Bath Seat.

: Push down Locking

Red
Warning
Label

1

Up to Swivel
Down to Lock

5

Using Your Tubside Bath Seat

To Use Bath Seat:

1.

Fill tub using a minimum of water
and check water temperature
before putting child in seat.

WARNING:

Babies can drown in as little as
one inch of water.
bathe your infant using as little
water as necessary.

2.

With bath seat attached to the
tub, carefully lower your child into
the seat.

3.

As your child sits down, his or her
weight will depress the Passive
Restraint Seat which decreases the
size of the leg openings for added
security.

ALWAYS

1

Leg Openings

TIP: For baby’s hard to reach spots,
you may wish to use the swivel seat
option.

To Clean:

1.

After draining the tub, pull the
Clamp Handle towards you, grasp
the Seat, and lift the Bath Seat
from the tub.

2.

Rinse the Bath Seat thoroughly

esh water. Allow excess

with fr

er to dr

wat

6

ain and towel dry.

1

Handle

Care of Your Tubside Bath Seat

To Store:

1.

Slide Adjustable Arm up, depress
Locking Button, and fully extend
Arm.

1

Locking
Button

2.

Turn the Adjustable Arm 180
degrees. Slide the Arm down and
into the storage position.

2

Storage
Position

Adjustable
Arm

7