SAFE-T-ALERT 35-742 User Manual

RECREATIONAL VEHICLE (RV)
Combination Carbon Monoxide and Gas Alarm
USER’S MANUAL
Model 35-742
PATENT US 7,248,156 ALL RIGHTS RESERVED 35RV052008-2
ATTENTION: This user’s manual contains important Carbon Monoxide (CO) and gas alarm installation, operation, troubleshooting and warranty information. Read, follow, and keep this manual for future reference.
NOTE: If you install or purchase this alarm for another person, give this manual to that person.
IMPORTANT: This unit must be replaced within five years of its production date. Record the manufacture date in the section, Owner’s Replacement Record, in this manual for future use. The replacement date indicates the date beyond which the device may no longer detect carbon monoxide, propane or natural gas accurately.
DUAL SENSOR TECHNOLOGY
The SAFE-T-ALERT™ 35 Series combination CO / Gas Alarm is an alarm that combines into a single compact system, a powerful alarm that detects both Carbon Monoxide (CO) and explosive gases Propane (LPG) and Methane (Natural Gas). The 35 Series uses the latest microprocessor technology combined with two electronic self-cleaning sensors that operate independently of each other. The combined unit can detect both CO and explosive gases simultaneously.
This detector is UL Listed as a CO, Propane and Methane (Natural Gas) detector for RV use. Other explosive gases detected, but not tested by UL, include Acetone, Alcohol, Butane, and Gasoline all of which you may have in your RV.
To prevent false alarms from brief “puffs” of gas the detector has a recheck cycle before alarming. If high levels of gas remain during the recheck cycle, the detector will alarm.
The electronic CO sensor in your SAFE-T-ALERTTM CO alarm is very sensitive to CO gas. It will not react to safe levels of most other gases.
WHY EVERY RV NEEDS A 35 SERIES CO AND GAS ALARM
Everyone is at risk for carbon monoxide poisoning! Particularly sensitive are children, pregnant women, the elderly and people with lung or heart disease or anemia! Carbon monoxide (CO) is an odorless, colorless gas that prevents the blood from carrying oxygen to vital organs. CO is 200 times more likely to replace oxygen in the blood. The Consumer Product Safety Commission (CPSC) recommends using at least one CO alarm located outside of sleeping areas. For the best security, locate a CO alarm in each sleeping area. Safe-T-Alert CO alarms are available for secondary installations.
Propane gas can cause explosions! Using propane requires taking safety precautions to avoid injury. LP gas is usually identified by an unpleasant odor. Certain conditions may make some people unable to detect this unpleasant odor. These conditions include advanced age, colds, allergies, and the use of tobacco, alcohol or drugs that may diminish the sense of smell.
ABOUT THIS ALARM
Because CO is a colorless, odorless, tasteless and highly poisonous gas; it can endanger lives even at low levels of concentration. The CO Alarm will alert you to potentially dangerous situations. The following
symptoms may be related to CO POISONING. Discuss these symptoms with ALL household members and RV guests:
Mild Exposure: Headaches, running nose, sore or watery eyes, often
described as “flu-like” symptoms.
Medium Exposure: Dizziness, drowsiness, vomiting.
Extreme Exposure: Unconsciousness, brain damage and death.
NOTE: Reported cases of CO gas poisoning indicate that while victims are aware they are not well, they are disoriented. They are unable to save themselves by exiting the RV or calling for assistance. Small
children and pets may be affected first.
Your SAFE-T-ALERTTM 35-742 alarm helps protect your household members and guests from CO produced while using your RV. CO gas is produced when any type of fuel is incompletely burned. Potential sources of CO in and around your RV can include gas or diesel engine exhaust, portable space heaters, gas stoves and ovens, furnaces, defective engine exhaust systems, portable grills, other nearby RVs, portable generators, generator exhaust, and other propane-powered appliances. All are sources of CO. The following are also sources of CO that may affect your RV:
Extended operation of unvented fuel burning appliances can build up high CO levels.
An idling vehicle in an open or closed garage.
Temperature inversions can trap exhaust near the ground.
CO build up can be caused by reverse/negative venting of fuel burning
appliances including; 1) Clogged, loose or faulty stacks or chimneys of (clothes dryers, furnaces and water heaters, etc.), 2) wind direction and/or velocity, 3) simultaneous operation of multiple fuel burning appliances, and/or exhaust fans.
!
WARNING:
LIMITATIONS OF CO and GAS ALARMS
THIS ALARM WILL NOT WORK WITHOUT POWER. Some
reasons for no alarm power are; a blown or missing fuse, broken wire, a faulty wire connection or circuit breaker, a discharged battery, cut lead wires, or improper supply (+) or ground (-) connections.
THIS ALARM WILL ONLY INDICATE THE PRESENCE OF GAS AT THE SENSOR. CO or explosive propane/natural gas gases may be
present in other areas. MTI recommends installing CO alarms in all sleeping areas. Do not block or cover the alarm with any object that can prevent a gas leak or carbon monoxide from reaching the sensor.
THIS ALARM IS INTENDED FOR USE IN RV's. It is intended for use in inside locations of a RV. It is not designed to measure compliance
with commercial and industrial standards. THIS ALARM MAY NOT BE HEARD. The alarm’s loudness is
designed to meet or exceed regulatory standards; however, the alarm may not be heard if alarms are located in remote locations or behind closed doors. Persons who are hard-of-hearing, have consumed alcoholic beverages, taken prescription, non-prescription or illegal drugs, may not hear the alarm.
THIS ALARM IS DESIGNED TO DETECT CARBON MONOXIDE AND PROPANE GAS. THE ALARM IS NOT DESIGNED TO DETECT SMOKE, OR FIRE.
THIS ALARM MAY NOT ALARM AT LOW CO LEVELS It is not
Bedroom
Bath
Kitchen
Do not install within 12" of
a window that can open
Do not install within
12" of a door
drapes or furniture
Recommended Alarm Location
Bedroom
Living Area
Travel Trailer
Recommended Alarm Location
1
Figure 2
designed to measure compliance with the Occupational Safety Health Administration (OSHA) commercial or industrial standards. Individuals
with medical problems may consider using warning devices, which provide audible and visual signals for CO concentrations under 30 ppm.
THIS ALARM IS NOT A REPLACEMENT FOR INSURANCE. Always be sure your RV is fully insured.
HOW TO PROTECT YOUR FAMILY
CAUTION- The SAFE-T-ALERTTM 35 series combination CO and Gas Alarm is designed to protect individuals from the acute effects of carbon monoxide exposure and gas leaks. It will not fully safeguard individuals with specific medical conditions. If in doubt, consult a medical practitioner.
To protect your family, you should:
ALL the instructions in this manual. Test your unit every week. Alarms that do not work will not alert you to hazardous levels of CO or explosive gas. See the section, Test Procedure, in this manual for further information.
MAKE REGULAR VISUAL INSPECTIONS. Check all fuel burning
equipment including gas water-heaters, kitchen gas stoves, space heaters, gas dryers and all pilot lights. Check the color of the pilot flame. The color should be blue.
MAKE REGULAR VISUAL INSPECTIONS OF THE ENGINE
AND GENERATOR EXHAUST SYSTEMS. Cracked exhaust systems can allow CO to enter the living area.
PROFESSIONALLY MAINTAIN YOUR ENGINE AND
GENERATOR. Although gas engines and generators produce CO, a
poorly tuned engine and generator will produce greater amounts CO.
If you smell unusual odors you may have a gas leak, immediately
call a local propane gas supplier or fire department to check for possible leaks.
WHERE TO INSTALL
Install the 35 series in the kitchen area near sources of a potential gas
leaks. Some potential sources are a furnace, refrigerator, stove or oven. If potential sources of a gas leak are in separate areas, MTI recommends installing a gas alarm in each area.
The Consumer Product Safety Commission recommends installing
a CO alarm outside the sleeping area. The 35 series combination CO and gas alarm complies with that recommendation. For added protection, MTI suggests installing a stand-alone CO alarm in the bedroom area.
INSTALL ALARM at least 4 inches but not more than 20 inches off
the floor.
WHERE NOT TO INSTALL 35 SERIES ALARMS
DO NOT INSTALL behind furniture, drapes, in closets or areas that
will block gas flow to the alarm.
DO NOT INSTALL within 12 inches (30cm) of opening windows,
exterior doors, heating or return vents, or other drafty areas.
DO NOT INSTALL on an outside wall.
DO NOT INSTALL on a wall switch controlled by a power line,
ground fault circuit or to a circuit breaker.
NOTE: Older RVs may have little or no insulation and therefore are
draftier. Carefully consider mounting locations.
The following diagrams provide additional alarm installation information:
Figure
Motorhome
Kitchen Area
DO NOT INSTALL Figure 3
Do not install
Do Not install behind
within 12" of vents
INSTALLATION INSTRUCTIONS
Model 35-742
!
WARNING
FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN A MALFUNCTION OR FAILURE OF THE ALARM AND MAY VOID THE WARRANTY.
SHOCK HAZARD: Turn off power before installing. Power Supply 12 VDC.
Recommended Wire Size 14 GA. TO 18 GA. Connect the alarm to a properly fused circuit, maximum over
protection device rating 15 amps.
SPECIAL WIRING NOTICE: When replacing CCI Controls LP Gas Leak Detectors they may have two power leads. Safe-T-Alert units have one power lead. Simply connect the Safe-T-Alert power lead (Red) to the coach/house power supply and cap or remove the second power lead. DO
NOT CONNECT BOTH POWER LEADS TO THE Safe-T-Alert ALARM – this will result in a dead chassis battery.
Loading...
+ 3 hidden pages