Safe & sound SA8093 User Manual

Safe & Sound Digital Thermometer SA8093
LCD SCREEN
THERMOMETER PROBE
Instructions Carefully read all the instructions and warnings on this leaflet before use.
This item is waterproof. Do not immerse in more than 15cm of water and for a maximum of 30 minutes.
Wash probe thoroughly before first and each subsequent use with a damp cloth. Sanitise probe if required by wiping with cold water sterilising solution, 70% Isopropyl alcohol or similar method.
Store out of reach of children, in a cool dry place away from sunlight and direct heat sources.
Always consult your doctor concerning raised temperatures and any other worrying symptoms. It may be a good idea to establish and record your usual temperature regularly when not ill.
A mild rise in temperature would be to about 37.8ºC and you should consult your doctor if your temperature remains at this for more than 24 hours or if your temperature rises to 38.6ºC.
Respiratory air may affect the accuracy of measurement. You are recommended to close the mouth for about 1 minute to let temperature in the mouth become steady.
This thermometer can measure the temperature between 32°C and 44°C. Accuracy is ± 0.1ºC between 35.5°C – 42°C and ± 0.2°C for the remainder of the range.
Directions
The unit is switched on and off with the button alongside the display window. The start-up screen will appear on the LCD display and a beep will be heard. If it has been used previously, the last reading will be shown on the screen for 2 seconds.
If “Lo ºC / Lo ºF” appears, it means the room temperature is below 32°C or 89.6°F. “Hi ºC / Hi ºF” will be displayed if the room temperature is greater than 42.9°C or 109.2°F. If the room temperature is greater than 32°C, it will be displayed rather than Lo °C. If the thermometer displays over 35°C dip the thermometer tip in cold water for approximately 5 seconds prior to measuring your temperature.
The °C/°F symbol will flash when the thermometer is ready for use.
Place the tip under the tongue and close the mouth. Wait for approximately 40 to 60 seconds or until you hear bleeping tones and the “°C” / ”°F” symbol to stop flashing. After hearing the bleeping tones, wait 4 more seconds.
The unit may now be removed and the displayed temperature recorded.
The unit will auto power off after around 10 minutes of not being used.
To switch between °C and °F
Make sure the thermometer is turned off. Hold down the ON/OFF button until it shows C – F on the LCD screen and then, release it. The current unit will flash, to change it, press the button and choose the desired unit. Wait approximately 5 seconds until the thermometer will automatically turn off.
BATTERY COVER
ON/OFF BUTTON
Replacing the batteries
The low battery symbol appears when the battery requires replacing.
Turn the thermometer face down and remove the battery cover using a coin on the counter-clockwise direction then, remove the battery. The replacement battery should be of the same type CR2032. Make sure “positive” side is facing upwards. Turn the cover clockwise with a coin to close it.
Always take care when removing the battery cover as damage may occur if the unit is dropped or knocked against any hard surface.
Remove batteries if the unit is not being used for a long period of time to prevent them from leaking.
Do not throw away used battery in household waste. Dispose of the battery at your local waste disposal centre in the appropriate battery dispose site.
WARNING – For your safety
Thoroughly inspect all parts before the first use and before each subsequent use to ensure that
• there are no defects, signs of wear or foreign particles. Discard immediately if signs of wear, damage or defect are noted.
Keep away from children when not in use as small parts could present a choking hazard. Battery
• cover end cap and battery are easily removed and present a serious risk of choking or injury if swallowed.
Use only under adult supervision.
Only use this item in accordance with supplied instructions and in accordance with any advice
• from your doctor or other healthcare professional.
Do not use to measure the temperature of any chemical solution.
Specification Temperature Measurement Range:
Body Mode 32.0°C – 42.9°C (89.6°F – 109.2°F) Accuracy ± 0.1°C/0.2°F (35.5°C – 42.0°C / 95.9°F – 107.6°F ) ± 0.2°C/0.4°F (32.0°C – 35.5°C, 42.0°C – 42.9°C, / 89.6°F – 95.9°F, 107.6°F – 109.2°F)
Operating ambient: Measuring
Temperature: 5°C - 35°C
Humidity: ≤80% RH
Storage and transport condition
Temperature: -25°C - 55°C
Humidity: ≤95% RH
Battery life: 100 hours under continuous operation Net weight: 24g Calibration: This thermometer is initially calibrated at the time of manufacture. If it is used
according to the operating instructions, periodic re-adjustment is not required.
PLEASE RETAIN THE INFORMATION ON THIS PACK FOR FUTURE REFERENCE
Made In: PRC. Produced for: Paul Murray Plc, Wide Lane, Southampton, SO18 2FA, UK.
www.murrayshealthandbeauty.com
REVISION 1 June 2018
WEE / AF0043SY / PRO
Explanation of symbols:
Battery is low
These symbols mean that you must not throw away the product and batteries in household waste. Dispose of the product and batteries at your local waste disposal centre for correct treatment and recycling.
Type BF equipment.
The product is in compliance with 93/42/EEC 0120.
This indicates the lot number – note that the first four digits of the lot number is also the year and month of manufacture.
Loading...