Saeco HD8836 Installation Manual

02

Rev.02 del 15-07-12

The manuf acturer reserves the right to change t he features of the product without prio r notice.

www.philips.com/saeco

EN

02

Register your product and get support at

www.philips.com/welcome

02

English

EN

Type HD8836 / HD8837

SUP 037DR

OPERATING INSTRUCTIONS

02

READ THESE OPERATING INSTRUCTIONS CAREFULLY BEFORE USING THE MACHINE.

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should always be
followed, including the following:

1. Read all instructions.

2. Do not touch hot surfaces. Use handles or knobs.

3. To protect against fire, electric shock and injury to persons do not immerse

cord, plugs, or appliance in water or other liquid.

4. Close supervision is necessary when the appliance is used by or near
children.

5. Unplug from outlet when not in use and before cleaning. Allow to cool
before putting on or taking off parts, and before cleaning the appliance.

6. Do not operate any appliance with a damaged cord or plug or after the
appliance malfunctions, or has been damaged in any manner. Return
appliance to the nearest authorized service facility for examination, repair
or adjustment.

7. The use of accessory attachments not recommended by the appliance
manufacturer may result in fire, electric shock or injury to persons.

8. Do not use outdoors.

9. Do not let cord hang over edge of table or counter, or touch hot surfaces.

10. Do not place on or near a hot gas or electric burner, or in a heated oven.

11. Always attach plug to appliance first, then plug cord into wall outlet. To

disconnect, turn any control to “off”, then remove plug from wall outlet.

12. Do not use appliance for other than intended use.

13. Save these instructions.

SAVE THESE INSTRUCTIONS

• 2 •

CAUTION

This appliance is for household use only. Any servicing, other than cleaning and
user maintenance, should be performed by an authorized service center. Do not
immerse machine in water. To reduce the risk of fire or electric shock, do not
disassemble the machine. There are no parts inside the machine serviceable by
the user. Repair should be done by authorized service personnel only.

1. Check voltage to be sure that the voltage indicated on the nameplate
corresponds with your voltage.

2. Never use warm or hot water to fill the water tank. Use cold water only.

3. Keep your hands and the cord away from hot parts of the appliance during

operation.

4. Never clean with scrubbing powders or harsh cleaners. Simply use a soft
cloth dampened with water.

5. For optimal taste of your coffee, use purified or bottled water. Periodic
descaling is still recommended every 2-3 months.

6. Do not use caramelized or flavored coffee beans.

INSTRUCTIONS FOR THE POWER

SUPPLY CORD

English

A. A short power-supply cord (or detachable power-supply cord) is to be

provided to reduce risks resulting from becoming entangled in or tripping
over a longer cord.

B. Longer detachable power-supply cords or extension cords are available

and may used if care is exercised in their use.

C. If a long detachable power-supply cord or extension cord is used,

1. The marked electrical rating of the detachable power-supply cord or

extension cord should be at least as great as the electrical rating of the
appliance

2. If the appliance is of the grounded type, the extension cord should be a

grounding-type 3-wire cord, and

3. The longer cord should be arranged so that it will not drape over the

counter top or table top where it can be pulled on by children or tripped
over.

• 3 •

GENERAL INFORMATION

The co ee machine is suitable for preparing espresso co ee using either co ee beans or ground
co ee and is equipped with a device to dispense steam and hot water. The structure of the ma­chine has been designed for domestic use only and is not suitable for continuous professional­type operation.

Keep these operating instructions in a safe place and make them available to anyone
who may use the co ee machine.

For further information or in case of problems that are not included or not completely explained
in these instructions, please contact an authorized service center.

Warning. No liability is held for damage caused by:

• Incorrect use not in accordance with the intended purposes;

• Repairs not carried out by authorized service centers;

• Tampering with the power cord;

• Tampering with any parts of the machine;

• Storage or use of the machine at a temperature outside the operating temperature
range (+15°C / +45°C);

• The use of non-original spare parts and accessories.

In these cases, the warranty shall be deemed null and void.

SAFETY REGULATIONS

Never allow water to come into contact with any of the electrical parts of the

machine: Danger of short circuit! Steam and hot water may cause scalding!
Do not direct the steam/hot water wand towards body parts. Carefully handle the
steam/hot water wand by its grip: Danger of scalding!

• 4 •

Intended Use

The co ee machine is intended for domestic use only. Do not make any technical changes or use
the machine for unauthorized purposes since this would create serious hazards! The appliance is
not to be used by persons (including children) with reduced physical, mental or sensory abilities
or with limited experience and/or expertise, unless they are supervised by a person responsible
for their safety, or they are instructed by this person on how to properly use the machine.

Power Supply - Power Cord

Only connect the co ee machine to a suitable socket.
The voltage must correspond to that indicated on the machine label located on the inside of
service door.
Never use the co ee machine if the power cord is defective or damaged.
If damaged, the power cord must be replaced by the manufacturer or an authorized service
center. Do not pass the power cord around corners, over sharp edges or over hot objects and
keep it away from oil. Do not use the power cord to carry or pull the co ee machine.
Do not pull out the plug by the power cord or touch it with wet hands. Do not let the power cord
hang freely from tables or shelves.

For the Safety of Others

Keep children under control to prevent them from playing with the product. Children are not
aware of the risks related to electric household appliances. Do not leave the machine packaging
materials within the reach of children.

Danger of Burns

Never direct the steam/hot water wand towards yourself or others: Danger of scalding! Always
use the handles or knobs provided.

Machine Location - Suitable Location for Operation and Maintenance

For best use, it is recommended to:

• Choose a safe, level surface, where there will be no danger of overturning it or being inju-

red.

• Choose a location that is su ciently well-lit, clean and near an easily reachable socket.

• Provide for a minimum distance from the sides of the machine as shown in the illustration.

• During machine turning on/o , it is recommended to place an empty glass under the dispen-

sing head.
Do not keep the machine at a temperature below 0°C (32°F).
Frost may damage the machine.
Do not use the co ee machine outdoors.
In order to prevent its housing from melting or being damaged, do not place the machine on
very hot surfaces and close to open  ames.

Storing the Machine - Cleaning

Before cleaning the machine, turn it o by pressing the ON/OFF button, and then switch the
power button to “0”. Remove the plug from the socket.
Wait for the machine to cool down.
Never immerse the machine in water!
It is strictly forbidden to tamper with the internal parts of the machine.
Water left in the tank for several days should not be consumed. Wash the tank and  ll it with
fresh drinking water.
If the machine will not be used for a long time, dispense water from the steam wand, and care­fully clean the Pannarello (if supplied), then turn it o and unplug it.
Store it in a dry place, out of the reach of children.
Keep it protected from dust and dirt.
Since the machine uses natural ingredients to brew beverages (fresh ground co ee, water, milk,
etc.), some residues of co ee ground or condensed water would de nitely be present on its
supporting surface.
For this reason we recommend to periodically clean both the visible parts of the machine and
the area beneath it.

Servicing / Maintenance

In case of failure, problems or a suspected fault resulting from the falling of the machine, imme­diately remove the plug from the socket.
Never attempt to operate a faulty machine.
Servicing and repairs may only be carried out by authorized service centers.
All liability for damages resulting from work not carried out by professionals is declined.

Fire Safety Precautions

In case of  re, use carbon dioxide (CO2) extinguishers. Do not use water or dry powder extin­guishers.

English

• 5 •

Grinder adjustment knob

Pre-ground bypass doser

Co ee bean hopper lid

Co ee bean hopper

Control panel

Dispensing head

Drip tray

Full drip tray indicator

Water tank

Power cord

Strong co ee brew button

Long co ee brew button

Wand protective gripper

Steam/hot water wand

Brew group lubricant

Dregdrawer

Drip tray

Pre-ground co ee scoop

LCD Display

Power switch

Water hardness test

Brew group

Intenza water  lter

ON/OFF button

“Aroma” - Pre-ground co ee
selector button.

Service door

(Optional)

• 6 •

Co ee/hot water/steam dial.

INSTALLATION

For your own and for other people’s
safety, carefully follow the instruc­tions provided in the “Safety Regula­tions” section.

Machine Packaging

The original packaging has been designed
and constructed to protect the machine
during transport. We recommend keep­ing the packaging material for possible
future transport.

Preliminary Operations

• Remove the coffee bean hopper lid
and the drip tray with grill from the
packaging.

• Remove the co ee machine from the
packaging and position it in a place
that meets the requirements described
in the safety regulations.

• Place the drip tray with grill into its
appropriate seat on the machine. Make
sure it is fully inserted and clicks into
place.

• Place the co ee bean hopper lid on the
bean hopper.

Note: Insert the plug in the

machine and in the wall so­cket only when indicated and check
that the power button is switched
to “0”.

Important Note: Carefully

read the explanations of all
the warnings displayed on the LCD
control panel (section “LCD Display
Warnings”).

• Remove the water tank and install the
Intenza water  lter as recommended
on page 27.

• Fill the tank with fresh drinking water.
Do not exceed the “max” level indi­cated on the water tank. Once filled,
place the tank back into the machine.

Fill the tank only with fresh,

non-sparkling water. Hot wa­ter or any other liquid may damage
the tank and/or the machine. Do not
turn on the machine when the tank
is empty. Make sure there is enough
water in the tank.

• Remove the co ee bean hopper lid.

Note: The hopper may be pro-

vided with different safety
features according to the regula­tions of the country of use of the
machine.

• Slowly pour the co ee beans into the

hopper.

Only co ee beans may be put

into the co ee bean hopper.
Ground coffee, instant coffee or
any other object may damage the
machine.

• Replace the co ee bean hopper lid.

• Insert the plug into the socket on the

back of the machine.

English

Never remove the drip tray

when the machine is turned
on. Wait a couple of minutes after
turning on/off, since the machine
will be carrying out a rinse/self­cleaning cycle (see section “Rinse/
Self-cleaning Cycle”).

• Insert the plug of the other end of the
cable into a wall socket with suitable
power voltage.

• 7 •

• Turn the machine ON by pressing the
power switch to “I”.

Priming the Water Circuit

• To prime the water circuit, place a
container under the steam/hot water
wand(Pannarello, if supplied).

Black

Red

• The display shows the ON/OFF icon.

• Make sure the ON/OFF button is set to
the “

” position; if this is not the case,

set it to that position.

• Press the ON/OFF button to turn the
machine on.

• The display indicates that the circuit
must be primed.

Note: Before starting the

machine after long periods
of inactivity, the water circuit must
be primed.

Red

Orange

Orange

Green

• Turn the selector dial clockwise to set
it to the “

” position. The machine
starts the automatic priming of the
circuit by letting out a preset quantity
of water through the steam/hot water
wand (Pannarello, if supplied). The bar
under the icon shows the operation
progress.

At the end of the priming process,

the display shows an icon (see fig­ure) indicating that the selection dial
must be brought back to the central
“

” position.

• The display then shows the machine
warm-up icon, as shown in the  gure.

When warm-up is complete,

the machine performs a rinse
cycle of the internal circuits.
In this phase, this icon will be dis­played:

• When the operations described above

are complete, this icon will be dis­played:

The machine is then ready to brew

beverages.

• To brew co ee, dispense hot water or

steam, and for a proper use of the ma­chine, carefully follow the instructions
provided.

• 8 •• 8 •

If the machine is being used

for the  rst time or after a
long period of inactivity, follow the
operations described in the follow­ing section.