Saebo Stim Pro ACCESSORY KIT INSTRUCTIONS

SaeboStim Pro

Sensory Electrical Stimulation

(SES) Accessory Kit

Glove

TheraCream

Garment Snap

Arm Sleeve

Connector

Saebo

www.saebo.com

Instructions for Use:

1. The Electrode Wires provided
with the SaeboStim Pro
connect to the Output Ports
(OUT A / OUT B) located at
the top of the Stimulator.
The wire connectors were
designed so they will insert

and connect rmly into place.

Since only one Electrode Wire
is needed, it is recommended
that you plug it into Outlet A.
See Figure 1.

2. Connect the SaeboStim
Pro Electrode Wire to the
Garment Snap Connectors by
inserting the pin ends into
the Connector. See Figure 2.

Figure 1

Figure 2

3. With the Garments on a at surface, attach the Garment Snap
Connectors to the Glove and Arm Sleeve by pressing it rmly

until you hear an audible click. See Figures 3 and 4.

Figure 3

Figure 4

4. Remove all jewelry and clean the skin thoroughly.
Conductive Electrode Garments do not work well if any
lotion, oil, or dirt is on the skin.

5. Apply the conductive
TheraCream over the
treatment area (arm and
hand). Please be sure to
cover the entire treatment
area thoroughly to avoid
an uncomfortable, stinging
sensation. See Figure 5.

Figure 5

6. Apply the Arm Sleeve onto
the arm and position it over
the elbow region with the
Connector on top, where
easily visible. Make sure the
Sleeve conforms snugly over
the entire treatment area.
See Figure 6.

Figure 6

7. Apply the Glove onto the
hand. Be sure the Glove
conforms snugly to the entire
hand so stimulation can be
provided evenly across the
entire treatment area. Be sure
the Connector is positioned
on the top portion of the
hand, where easily visible.
See Figure 7.

Figure 7

Note - If you are having trouble applying the Glove, rest your

arm on a table with the hand o the edge. Bend your
wrist downward to help straighten your ngers. This

should ease the donning process.

8. Once the Garments are in place and the Electrode Wires are
connected to the SaeboStim Pro, treatment can begin.

a. Turn on the SaeboStim Pro (refer to the SaeboStim Pro

instruction manual).

b. Press the Channel Key (CH) once, and icon A will ash.

Then, continuously press the Program Key (P) until you reach
Program 14. See Figure 8.

Program Key

Figure 8

Channel Key

c. While the Channel A icon is still ashing, press the (+)

Intensity Key until you feel a light tingling sensation.
It is not uncommon to primarily feel the stimulation in the
glove and not the elbow sleeve.

Next, reduce the sensation by pressing the (-) Intensity Key

until you no longer feel the tingling.

NOTE: According to research, the optimum therapeutic level of
stimulation should be just below the “sensory” level. In other words,
try to reduce the stimulation to the exact intensity level where you no
longer feel the electricity or tingling sensation.

Cleaning Instructions

Garments should be hand washed with mild detergent in lukewarm
water and rinse thoroughly. Allow to air dry; DO NOT place in dryer.

For information pertaining to contraindications, warnings or adverse
reactions, please refer to the SaeboStim Pro instruction manual or
contact Saebo directly.