Page 1
OPERATOR'S MANUAL
REPLACEMENT FILTER NO. A32VC03
For Ryobi Cordless Hand Vac
Tuff Sucker™ – Model No. VC180WD
Always mention the above number when
communicating with us regarding this
replacement filter.
We have engineered and manufactured your new replacement filter to Ryobi’s high standard for dependability, ease of
operation, and operator safety. When properly cared for, the replacement filter will give you years of rugged, trouble-free
performance.
WARNING: To reduce the risk of injury, the user must read and understand this operator’s manual and the
operator’s manual for your Hand Vac.
Thank you again for buying a Ryobi replacement filter .
SAVE THIS MANUAL FOR FUTURE REFERENCE
Page 2
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic precautions
should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING
HAND VAC
REPLACING FILTER
See Figures 1 & 2.
WARNING:
Never use your hand vac without dust bowl, filter,
and filter rack properly in place.
WARNING:
To reduce the risk of fire, electric shock, or injury, read
and understand all instructions in this operator’s
manual and the operator’s manual for the hand vac
before using hand vac, changing attachments, filters,
or making adjustments.
■ Do not use hand vac outdoors.
Use only as described in this manual. Use only with
■
the VC180 Hand Vac.
■
Do not allow to be used as a toy. Close attention is
necessary when used by or near children.
■ Keep hair, loose clothing , fingers, and all parts of the
body away from openings and moving parts.
■ A cordless hand vac does not have to be plugged into
an electrical outlet, therefore it is always in operating
condition. Be aware of possible hazards when using
your hand vac or when changing accessories.
■ DO NOT PLACE BATTERY PACK NEAR FIRE OR
HEAT. The batteries may explode.
SAVE THESE INSTRUCTIONS
REMOVING DUST BOWL
NOTE: The dust bowl should be checked, emptied and
cleaned periodically to obtain maximum dust collection.
■
Turn off hand vac and remove battery pack before
changing attachments, filters, or making adjustments.
Depress the release button located on top of hand vac.
■
Pull dust bowl down and out as shown to separate
from motor housing.
NOTE: Do not tilt or tip the hand vac back with liquids in
the dust bowl.
■ Remove the assembled filter rack and filter by pulling
them out of the dust bowl. NOTE: The filter is locked in
place in the filter rack.
PRESS RELEASE BUTTON
See Figure 1.
See Figure 2.
DUST BOWL
PULL DUST BOWL DOWN
AND OUT TO REMOVE
FILTER RACK
HAND VAC
FILTER
BATTERY
PACK
Fig. 1
Fig. 2
Page 3
REPLACING FILTER (CONTINUED)
See Figures 3 & 4.
■ Twist the filter to unlock from the filter rack tabs and
remove the filter.
■ Dispose of filter.
■ Empty filter rack and dust bowl; wash if necessary.
Make sure filter rack and dust bowl are completely dry
before reattaching to hand vac.
■ With arrow on filter pointed up, place new filter in the
filter rack ensuring the slots in the filter are aligned with
the tabs on the filter rack. Twist the filter to lock in
place.
■ Place the assembled filter rack and filter into the dust
bowl.
■ Position the two sections as shown in Figure 4. Align
slots on bottom of dust bowl with tabs on bottom of
motor housing then snap the two sections together.
See Figure 3.
TWIST FILTER
TO REMOVE
ARROW
SHOULD BE
POINTED UP
FILTER RACK WITH
FILTER ASSEMBLED
AND LOCKED IN
PLACE
TWIST FILTER
TO INSTALL
SLOTS
TABS
Fig. 3
SLOTS
TABS
Fig. 4
RYOBI TECHNOLOGIES, INC.
1428 Pearman Dairy Road, Anderson, SC 29625
Post Office Box 1207, Anderson, SC 29622-1207
Phone 1-800-525-2579
www.ryobitools.com
983000-099
11-02
Loading...