RVS Systems RVS-355W-SC-04, RVS-35WM User Manual

Instruction Manual
SimpleSight™ Wireless 7” Single Screen Monitor
With Wired Side Camera Inputs
RVS-35WM
Reverse With Condence
1
TABLE OF CONTENTS
Introduction.............................. 03
Before Beginning Installation ....................... 07-08
Wiring . . ........................... . . . . . 09
Menu Introduction . . ........................... . 10
Monitor Specications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Camera Specications . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Warranty.......................... . . . . . 12
Disclaimer.......................... . . . . . 13
2
Rear View Safety
NOTE!
Please read all of the installation instructions carefully before installing the product. Improper installation will void manufacturer’s warranty.
Congratulations on purchasing a Rear View Backup
Camera System!
With this manual you will be able to properly install and
operate the unit.
The Backup Camera System is intended to be installed as a supplement aid to your standard rear view mirror that already exists in your vehicle. The Backup Camera System should not be used as a substitute for the standard rear view mirror or for any other mirror
that exists in your vehicle.
In some jurisdictions, it is unlawful for a person to drive a motor vehicle equipped with a TV viewer or screen located forward of the back of the driver’s seat or in any location that is visible, directly
or indirectly, to the driver while operating the vehicle.
INTRODUCTION
Reverse With Condence
3
Please read the entire manual and follow the instructions and
warnings carefully. Failure to do so can cause serious damage and/or
injury, including loss of life. Be sure to obey all applicable local
trac and motor vehicle regulations as it pertains to this product.
Improper installation will void manufacturer’s warranty.
USAGE:
The Rear View Camera System is
designed to help the driver safe­ly detect people and/or objects helping to avoid damage or injury. However, you the driver, must use it properly. Use of this system is not a substitute for safe, proper or legal driving.
Never back up while looking at the
monitor alone. You should always
damage or injury. Always back up slowly.
The Rear View Camera System is
not intended for use during exten­sive back-up maneuvers or backing into cross trac or pedestrian walk­ways.
Please, always remember, the area
displayed by the Rear View Camera
check behind and around the vehi-
SAFETY INFORMATION
cle when backing up, in the same way as you would if the vehicle did not have the Rear View Camera System. If you back up while looking only at the monitor, you may cause
4
System is limited. It does not display the entire panorama that is behind you.
Rear View Safety
INSTALLATION:
Electric shock or product
malfunction may occur if this product is installed incorrectly.
Use this product within
the voltage range specied. Failure to do so can cause electronic shock or product malfunction.
or disconnected wire may cause a re.
While installing the Rear View
System be careful with the wire positioning in order to avoid wire damage.
The Rear View System should only
be used when the vehicle is in reverse.
SAFETY INFORMATION
Take special care when
cleaning the monitor.
Make sure to rmly ax the prod-
uct before use.
If smoke or a burning smell
is detected, disconnect the system immediately.
Where the power cable may touch
Do not watch movies or
operate the monitor while driving; as it may cause an accident.
Do not install the monitor
where it may obstruct drivers view or obstruct an air bag device.
a metal case, cover the cable with friction tape. A short circuit
Reverse With Condence
Dropping the unit may cause
possible mechanical failure.
5
If you have questions about this product, contact:
Rear View Safety
1797 Atlantic Avenue
Brooklyn, NY 11233
Tel: 1.800.764.1028
IN NO EVENT SHALL SELLER OR MANUFACTURER BE
SAFETY INFORMATION
LIABLE FOR ANY DIRECT OR CONSEQUENTIAL DAMAGES OF
ANY NATURE, OR LOSSES OR EXPENSES RESULTING FROM
ANY DEFECTIVE PRODUCT OR THE USE OF ANY PRODUCT.
6
Rear View Safety
Before drilling please check that no cable or wiring is on the other side
MENU
MIR/NO R
PAIR
HARDWIRE
OR CIGARETTE LIGHTER PLUG
FEMALE TO MALE
MONITOR
CAMERA
MALE TO FEMALE
LOOSE
POWER
CABLE
LOOSE
POWER
CABLE
of the wall. Please clamp all wires securely to reduce the possibility of them being damaged while vehicle is in use. Keep all cables away
from hot/moving parts and electrical noisy components.
We recommend doing a benchmark test before installation
to insure that all components are working properly.
Step 1: Choose the monitor locations.
Step 2: Install all cables in vehicle, when necessary a 0.8 (20mm) hole should be drilled for passing camera cable through vehicles walls. Install split grommets where applicable.
Step 3: Once all cables and wiring have been properly routed, perform a system function test by temporarily connecting the system.
BEFORE YOU BEGIN
MALE PLUG
FEMALE PLUG
WATERPROOF CONNECTION
1 2 3
PUT IN
TWIST &
TIGHTEN
Reverse With Condence
WATERPROOF
7
Warning!
1. This monitor is high voltage. Only professionals should open the monitor's case.
2. Do not watch the video while driving unless you are monitoring the rear view camera display.
System Introduction
This system has three video inputs: one wireless and two wired.
Press the power button to turn the monitor on. Press "MENU" to ac­cess main menu. Use the arrow keys to navigate the menu and use the "MENU" button to conrm your selection. To toggle back a screen press the"REV" button.
Instant Pair
1. Short press on monitor MENU to enter MENU
2. Short press PAIRING to begin pairing process
BEFORE YOU BEGIN
3. Cycle power on camera
4. System will pair automatically - Make sure to cycle camera power after starting pairing process
Note: Make sure the antenna on the monitor is installed straight up, not to either side.
8
Rear View Safety
Wiring
Monitor
3 Amp Fuse
33ft Extension Cable
(Sold Separately)
1
2 3
4 5
1. DC12-24V
2. Ground
3. Port #3 (Blue)
4. Port #2 (Brown)
5. Port #1 (White)
Power Harness
WIRING
Side Camera
(Sold Separately)
Wireless Backup Camera
(Sold Separately)
Reverse With Condence
Side Camera
(Sold Separately)
9
CAMERA
SELECTION
DOWN ARROW
MENU/
SELECTION
BUTTON
POWER
ON / OFF
MENU
CAM
UP ARROW
Back/Exit
REV
Pairing: Pair monitor with camera
Brightness/Contrast/Saturation/Sharpness: Adjust image properties
Picture Adjust: Stretch image horizontally (right/left and left/right)
Turn: Toggle between mirror/normal image on each individual channel
Day/Night: Toggle between back-lit buttons and auto dimming
MENU INTRODUCTION
Name: Change name of each individual channel
Trigger Source: Toggle channel destination for each trigger
Trigger Delay: Adjust time delay on each trigger
Distance Grid: Toggle which channel distance grid lines will display on
Grid Position: Adjust grid lines
Auto Power: On: Monitor will automatically turn on when powered. O: Monitor will only turn on when triggered. Auto: Monitor will follow previous state.
Reset: Reset settings to factory default
10
Rear View Safety
Monitor Specications
Panel Size 7" LED Digital Panel Video System NTSC / PAL Auto Detection Resolution 800 X 3 (RGB) X 480 Brightness 400 cd/m
2
Contrast Ratio 500:1 Screen Mode 16:9 Field of View Top 50°, Bottom 70°, L/R 70° Video Input 3 Channel (1 Wireless, 2 Wired) Dot Pitch 0.192 (H) X 0.1805 (V)
Transmission Distance 100ft Video Source 1Vp-p, 75 
Power Supply DC 12V-24V (+/- 10%) Power Consumption 5W Operating Temperature -30°C ~ +80°C RH 90% MAX
CAMERA DIMENSIONS
Overall Dimensions 7" (L) x 5" (H) x 1" (D) Weight 400G Vibration Rating 5G Sync System Internal Auto Pair Yes
Reverse With Condence
11
ONE YEAR WARRANTY
REAR VIEW SAFETY, INC. WARRANTS THIS PRODUCT AGAINST MATERIAL DEFECTS FOR A PERIOD OF ONE YEAR FROM DATE OF PURCHASE. WE RESERVE THE RIGHT TO REPAIR OR REPLACE ANY SUCH DEFECTIVE UNIT AT OUR SOLE DISCRETION. REAR VIEW SAFETY, INC. IS NOT RESPONSIBLE FOR A DEFECT IN THE SYSTEM AS A RESULT OF MISUSE, IMPROPER INSTALLATION, DAMAGE OR MISHANDLING OF THE ELECTRONIC COMPONENTS. REAR VIEW
SAFETY, INC. IS NOT RESPONSIBLE FOR CONSEQUENTIAL DAMAGES OF ANY KIND.
THIS WARRANTY IS VOID IF: DEFECTS IN MATERIALS OR WORKMANSHIP OR DAMAGES
RESULT FROM REPAIRS OR ALTERATIONS WHICH HAVE BEEN MADE OR ATTEMPTED BY OTHERS OR THE UNAUTHORIZED USE OF NONCONFORMING PARTS; THE DAMAGE IS DUE TO NORMAL WEAR AND TEAR, THIS DAMAGE IS DUE TO ABUSE, IMPROPER MAINTENANCE, NEGLECT OR ACCIDENT; OR THE DAMAGE IS DUE TO USE OF THE REAR VIEW SAFETY, INC.
SYSTEM AFTER PARTIAL FAILURE OR USE WITH IMPROPER ACCESSORIES.
WARRANTY PERFORMANCE
DURING THE ABOVE WARRANTY PERIOD, SHOULD YOUR REAR VIEW SAFETY PRODUCT EXHIBIT A DEFECT IN MATERIAL OR WORKMANSHIP, SUCH DEFECT WILL BE REPAIRED WHEN THE COMPLETE REAR VIEW SAFETY, INC. PRODUCT IS RETURNED, POSTAGE PREPAID AND
INSURED, TO REAR VIEW SAFETY, INC. OTHER THAN THE POSTAGE AND INSURANCE
REQUIREMENT, NO CHARGE WILL BE MADE FOR REPAIRS COVERED BY THIS WARRANTY.
WARRANTY DISCLAIMERS
NO WARRANTY, ORAL OR WRITTEN, EXPRESSED OR IMPLIED, OTHER THE ABOVE WARRANTY IS MADE WITH REGARD TO THIS REAR VIEW SAFETY, INC. REAR VIEW SAFETY, INC. DISCLAIMS
WARRANTY
ANY IMPLIED WARRANTY OR MERCHANTABILITY OR FITNESS FOR A PARTICULAR USE OR
PURPOSE AND ALL OTHER WARRANTIES IN NO EVENT SHALL REAR VIEW SAFETY. INC. LIABLE FOR ANY INCIDENTAL, SPECIAL, CONSEQUENTIAL, OR PUNITIVE DAMAGES OR FOR
ANY COSTS, ATTORNEY FEES, EXPENSES, LOSSES OR DELAYS ALLEGED TO BE AS A
CONSEQUENCE OF ANY DAMAGE TO, FAILURE OF, OR DEFECT IN ANY PRODUCT INCLUDING,
BUT NOT LIMITED TO, ANY CLAIMS FOR LOSS OF PROFITS.
12
Rear View Safety
DISCLAIMER
REAR VIEW SAFETY AND/OR ITS AFFILIATES DOES NOT GUARANTEE OR PROMISE THAT THE USER OF OUR SYSTEMS WILL NOT BE IN/PART OF AN ACCIDENT OR OTHERWISE NOT COLLIDE WITH AN OBJECT AND/OR PERSON. OUR SYSTEMS ARE NOT A SUBSTITUTE FOR CAREFUL AND CAUTIOUS DRIVING OR FOR THE CONSISTENT ADHERENCE TO ALL APPLICABLE TRAFFIC LAWS AND MOTOR VEHICLE SAFETY REGULATIONS. THE REAR VIEW SAFETY PRODUCTS ARE
NOT A SUBSTITUTE FOR REARVIEW MIRRORS OR FOR ANY OTHER MOTOR VEHICLE EQUIPMENT MANDATED BY LAW. OUR CAMERA SYSTEMS HAVE A LIMITED FIELD OF VISION AND DO NOT PROVIDE A COMPREHENSIVE VIEW OF THE REAR OR SIDE AREA OF THE VEHICLE. ALWAYS MAKE SURE TO LOOK AROUND YOUR VEHICLE AND USE YOUR MIRRORS TO CONFIRM
REARWARD CLEARANCE AND THAT YOUR VEHICLE CAN MANEUVER SAFELY. REAR VIEW
SAFETY AND/OR ITS AFFILIATES SHALL HAVE NO RESPONSIBILITY OR LIABILITY FOR DAMAGE AND/OR INJURY RESULTING FROM ACCIDENTS OCCURRING WITH VEHICLES HAVING SOME OF REAR VIEW SAFETY PRODUCTS INSTALLED AND REAR VIEW SAFETY AND/ OR ITS AFFILIATES, THE MANUFACTURER, DISTRIBUTOR AND SELLER SHALL NOT BE LIABLE FOR ANY INJURY, LOSS OR DAMAGE, INCIDENTAL OR CONSEQUENTIAL, ARISING OUT OF THE USE OR INTENDED USE OF THE PRODUCT. IN NO EVENT SHALL REAR VIEW SAFETY AND/OR ITS AFFILIATES HAVE ANY LIABILITY FOR ANY LOSSES WHETHER DIRECT OR INDIRECT, IN
CONTRACT, TORT OR OTHERWISE INCURRED IN CONNECTION WITH THE SYSTEMS,
INCLUDING BUT NOT LIMITED TO DAMAGED PROPERTY, PERSONAL INJURY AND/OR LOSS OF
LIFE. NEITHER SHALL REAR VIEW SAFETY AND/OR ITS AFFILIATES HAVE ANY
RESPONSIBILITY FOR ANY DECISION, ACTION OR INACTION TAKEN BY ANY PERSON IN
RELIANCE ON REAR VIEW SAFETY SYSTEMS, OR FOR ANY DELAYS, INACCURACIES AND/OR
ERRORS IN CONNECTION WITH OUR SYSTEMS FUNCTIONS.
DISCLAIMER
Reverse With Condence
13
If you have any questions
about this product, contact:
Rear View Safety, Inc.
1797 Atlantic Avenue
Brooklyn, NY 11233
800.764.1028
Better Cameras. Better Service.
IT’S OUR GUARANTEE.
14
Rear View Safety
Loading...