RVS Systems RVS-350P User Manual

PROFESSIONAL

DRIVER FATIGUE

MONITOR

RVS-350P

User Manual

Product Composition

*RVS-350P includes the host and 5 pin signal line. It can work on all types of vehicle, both 12V and
24V power supply.

Caution

 Do not attempt to disassemble or alter any part of the equipment if you are not authorized

professional

 Do not adjust system while driving.
 Please handle carefully, avoid dropping or subjecting the product to severe impacts.
 Do not clean or maintain the equipment with chemical solvent or thinner, it may damage the

surface.

 Do not allow the product to come into contact with or become immersed in water or other

liquids. Do not store the product in humid/dusty areas.

 Do not heavily drag or kink the cable, do not place heavy object on the cable. This may cause

a fire.

 Special legal statement: The RVS-350P is only a monitoring system, it alone does not

guarantee safe driving. Please note that Rear View Safety is not responsible for any accidents.

 While every effort has been made to ensure that the information contained in this guide is

accurate and complete, we assume no liability for any errors or omissions.

 We reserve the right

at anytime without prior notice.

to change the specifications of the hardware and software described herein

Note

◆ The RVS-350P does not recognize the people who have only one eye, white eyebrows, rough

scars or wrinkles around eyebrows.

◆ The product's storage temperature is -45°C ~ +85°. The working temperature in cab is -10°C ~

+50° C.

dormant. Once the cab temperatures reaches the normal working temperature, it will start work
automatically again. If the system has been working, it doesn't matter even if the temperature
decreases or increases.

If the cab temperature is below -10°C or above +50°C, the system automatically become

Installation

Note:

1. Connect 5 pin signal cable connect with power supply. Place according to the part of AVL

2. Install the device on the dashboard directly in front of the driver. The degree between the

3. Tear the protective film from suction cup of bracket, put the host on the holder (If choose

4. The host connected with bracket, the lens must be installed vertical. Bracket can be adjusting

recommend

We

System (GPS) Connection, connect the 5 pin cable of host with 5

installation location and the driver’s normal driving position should be within 20°. The
RVS-350P can be fixed on uneven surface as long as the camera is trained on the driver’s face.

simple sticker bracket, please omit this step) Tear red sticker of holder’s bottom, put the host on
optimal position of dashboard. Train the lens on your face and adjust the position of the lens
according to the state of the green light. Do not block the main display parameters of the
instrument panel.

the height from screw on the right side. Bracket has two universal adjustable balls. The lens
must be installed vertically. That means the green light and the center of the lens remain
vertical. Don’t press the double-sided adhesive tape too firm at first, so any inappropriate
positioning can be easily re-adjusted.

professional installation.

pin signal cable.

5. To test installation, sit normally in the vehicle, if the green light of the camera is bright or
flashing this indicates that the driver's eyes have been detected. The distance from lens to the
driver's eyes should be between 60cm-90cm. When the driver are looking at the front and the
green light stays bright, it is properly installed. Adjust the correct position of the camera so the
green light can keep on as far as possible. A flashing green light is normal when the driver
opens their eyes, especially for drivers wearing rimmed spectacles.

6. If the dashboard of truck and bus is low, install the RVS-350P at a higher position. The host
should not be higher than the driver’s eyes and the angle between the installation location
and the driver’s eyes should not exceed 30°.

7. The distance from lens to the driver's eyes should be between 60cm-90cm. For some cases,