RVS Systems RVS-350 User Manual
DRIVER FATIGUE
MONITORING SYSTEM
RVS-350
User Manual
Product Composition
*RVS-350 includes the host and 5 pin signal line. It can work on all types of vehicle, both 12V and 24V
power supply.
Caution
Do not attempt to disassemble or alter any part of the equipment if you are not authorized
professional
Do not adjust system while driving.
Please handle carefully, avoid dropping or subjecting the product to severe impacts.
Do not clean or maintain the equipment with chemical solvent or thinner, it may damage the
surface.
Do not allow the product to come into contact with or become immersed in water or other
liquids. Do not store the product in humid/dusty areas.
Do not heavily drag or kink the cable, do not place heavy object on the cable. This may
cause a fire.
Special legal statement: The RVS-350 is only a monitoring system, it alone does not guarantee
safe driving. Please note that Rear View Safety is not responsible for any accidents.
While every effort has been made to ensure that the information contained in this guide is
accurate and complete, we assume no liability for any errors or omissions.
We reserve the right to change the specifications of the hardware and software described herein
at anytime without prior notice.
Note
◆ The RVS-350
scars or
◆ The product's
+50
dormant. Once the cab temperatures reaches the normal working temperature, it will start work
automatically again. If the system has been working, it doesn't matter even if the temperature
decreases or increases.
.
° C
If the cab t
does not recognize the people who have only one eye, white eyebrows, rough
wrinkles around eyebrows.
storage temperature is -45°C ~ +85°. The working temperature in cab is -10
emperature
is below -10°C or above +50°C, the system automatically become
Installation
Note: We recommend professional installation.
1. Connect 5 pin signal cable connect with power supply. Place according to the
System (GPS) Connection, connect the 5 pin cable of host with 5 pin signal cable.
2. Install the device on the dashboard directly in front of
installation location and the driver’s normal driving position should be within 20°. The
RVS-350 can be fixed on uneven surface as long as the camera is trained on the driver’s face.
the driver. The degree between the
part of AVL
°C ~
3. Tear the protective film from suction cup of
simple sticker bracket, please omit this step) Tear red sticker of holder’s bottom, put the host on
optimal position of dashboard. Train the lens on your face and adjust the position of the lens
according to the state of the green light. Do not
instrument panel.
4. The host connected with bracket, the lens must be installed vertical. Bracket can be adjusting
the height from screw on the right side. Bracket has two universal adjustable balls. The lens
must be
vertical. Don’t press the double-sided ad
positioning can be easily re-adjusted.
5. To test installation, sit normal
flashing this indicates that the driver's eyes have been detected. The distance from lens to the
driver's eyes should be between 60cm-90cm. When the driver are looking at the front and the
green light stays bright, it is properly installed. Adjust the correct position of the camera so the
green light can keep on as far as possible. A flashing green light is normal when the driver
opens their eyes, especially for drivers wearing rimmed spectacles.
6. If the dashboard of truck and bus is
should not be higher than the driver’s eyes and the angle between the installation location
and the driver’s eyes should not exceed 30
7. The distance from lens to the driver's eyes should be between 60cm-90cm. For some cases,
installed vertically. That means the green light and the center of the lens remain
hesive tape too fir
ly in the vehicle, if the green light of the camera is bright or
low, install the RVS-350 at a higher position. The host
bracket, put the host on the holder (If choose
block the main display parameters of the
m at first, so any inappropriate
°.
Loading...