TECHNICAL DATA
SPC-37
RUST-OLEUM® SPECIALTY
GLOW IN THE DARK
1
Form: GDH-127
Rev.: 021819
DESCRIPTION AND USES
PRODUCT
SKU
DESCRIPTION (Aerosol)
267026
Glow In The Dark
PRODUCT APPLICATION
PRODUCT APPLICATION (cont.)
Rust-Oleum® Specialty Glow In The Dark is a luminous paint
that creates a glowing effect for 2-4 hours in the dark after
being charged by natural or artificial light. It can be applied
to wood, metal, drywall and plastic. Periodic re-application
may be needed for outdoor use. IMPORTANT! Use over a
white or light colored surface.
Use outdoors or in a well-ventilated area such as an open
garage. Use when temperature is between 50°F (10°C) and
90°F (32°C) and humidity is below 65% to ensure proper
drying. Avoid spraying in very windy and dusty conditions.
Cover surrounding area to protect from spray mist.
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical contaminants
by washing the surface with a commercial detergent, or
other suitable cleaning method. Rinse with fresh water and
allow to thoroughly dry. Remove loose paint and rust with a
wire brush or sandpaper. Lightly sand glossy surfaces.
WARNING! If you scrape, sand or remove old paint from any
surface, you may release lead paint dust. LEAD IS TOXIC.
EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS
ILLNESS, SUCH AS BRAIN DAMAGE; ESPECIALLY IN
CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH approved respirator to control
lead exposure. Clean up carefully with a HEPA vacuum and
a wet mop. Before you start, find out how to protect yourself
and your family by contacting the National Lead Information
Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.
PRIMING
Use of a white Rust-Oleum® primer provides excellent
adhesion and hiding and is especially recommended for
bare wood and metal.
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle, DO NOT STRIKE
CAN. Contact Rust-Oleum. Shake often during use. Hold
can upright 10-16” from surface and spray in a steady backand-forth motion, slightly overlapping each stroke. Keep the
can the same distance from the surface. Keep the can in
motion while spraying. Apply 2 or more coats a few minutes
apart. Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70ºF (21°C) and 50%
relative humidity. Allow more time at cooler temperatures.
Dries to the touch in 15 minutes and to handle in 1-2 hours.
Fully dry in 24 hours. Apply a second coat or a clear coat
within 1 hour or after 24 hours. Apply clear in 2-3 coats a
few minutes apart.
CLEAN-UP
Wipe tip before storing. Clean up wet paint with xylol or
mineral spirits. Throw away empty can in trash pickup. Do
not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object into
can valve opening.
TECHNICAL DATA
SPC-37
RUST-OLEUM® SPECIALTY
GLOW IN THE DARK
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 877∙385∙8155
www.rustoleum.com
Form: GDH-127
Rev.: 021819
PHYSICAL PROPERTIES
GLOW IN THE DARK
Resin Type
Modified Alkyd
Pigment Type
Strontium Oxide Aluminate
MIR
0.80 Max
Fill Weight
10 ounces
Solvents
Acetone, N-Butyl Acetate, Xylene
Practical Coverage
(assumes 15% material loss)
8-10 sq.ft./can
(0.7-0.9 m2/can)
Dry Times at 70-80ºF
(21-27ºC) and 50%
Relative Humidity
Touch
15 minutes
Handle
1-2 hours
Fully Dry
24 hours
Shelf Life
5 years
Flash Point
-156°F (-104°C)
Safety Information
For additional information, see SDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.
Calculated values are shown and may vary from the actual manufactured material.
Loading...