Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, IL 60061
USA
24 Hour Hotline: 847-367-7700
Revision Date:9/11/2014
Manufacturer:
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, IL 60061
USA
2. Hazard Identification
EMERGENCY OVERVIEW: May cause eye, skin, or respiratory tract irritation. KEEP OUT OF REACH OF CHILDREN. Harmful if
inhaled. Harmful if swallowed. Causes severe skin and eye burns. Causes eye irritation. Vapors extremely irritating to eyes and
respiratory tract. Use ventilation necessary to keep exposures below recommended exposure limits, if any. Avoid contact with eyes,
skin and clothing.
Classification
Symbol(s) of Product
Signal Word
Danger
GHS HAZARD STATEMENTS
Acute Toxicity, Oral, category 4H302Harmful if swallowed.
Acute Toxicity, Dermal, category 4H312Harmful in contact with skin.
Acute Toxicity, Dermal, category 5H313May be harmful in contact with skin.
Skin Irritation, category 2H315Causes skin irritation.
Eye Irritation, category 2H319Causes serious eye irritation.
Acute Toxicity, Inhalation, category 3H331Toxic if inhaled.
Corrosive to Metals, category 1H290May be corrosive to metals.
Aspiration Hazard, category 2H305May be harmful if swallowed and enters airways.
Skin Corrosion, category 1H314Causes severe skin burns and eye damage.
Eye Irritation, category 2BH320Causes eye irritation.
Skin Corrosion, category 1H314Causes severe skin burns and eye damage.
Skin Sensitizer, category 1H317May cause an allergic skin reaction.
GHS PRECAUTIONARY STATEMENTS
P102Keep out of reach of children.
P103Read label before use.
P202Do not handle until all safety precautions have been read and understood.
Date Printed: 9/11/2014
13463-67-7
PROPRIET
ARY
1344-28-1
9046-10-0
112-57-2
P234Keep only in original container.
P260Do not breathe dust/fume/gas/mist/vapours/spray.
P261Avoid breathing dust/fume/gas/mist/vapours/spray.
P262Do not get in eyes, on skin, or on clothing.
P264Wash … thoroughly after handling.
P270Do not eat, drink or smoke when using this product.
P271Use only outdoors or in a well-ventilated area.
P273Avoid release to the environment.
P280Wear protective gloves/protective clothing/eye protection/face protection.
P281Use personal protective equipment as required.
P285In case of inadequate ventilation wear respiratory protection.
P312Call a POISON CENTER or doctor/physician if you feel unwell.
P351Rinse cautiously with water for several minutes.
P360Rinse immediately contaminated clothing and skin with plenty of water before removing
clothes.
P361Remove/Take off immediately all contaminated clothing.
P374Fight fire with normal precautions from a reasonable distance.
P402Store in a dry place.
P406Store in corrosive resistant/… container with a resistant inner liner.
P302+P350IF ON SKIN: Gently wash with plenty of soap and water.
P501Dispose of contents/container to …
P322Specific measures (see … on this label).
P363Wash contaminated clothing before reuse.
P301+P312IF SWALLOWED: Call a POISON CENTER or doctor/physician if you feel unwell.
P302+P352IF ON SKIN: Wash with plenty of soap and water.
P321Specific treatment (see … on this label).
P352Wash with plenty of soap and water.
P362Take off contaminated clothing and wash before reuse.
P332+P313If skin irritation occurs: Get medical advice/attention.
P305+P351+P338IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if
present and easy to do. Continue rinsing.
P337+P313If eye irritation persists: Get medical advice/attention.
P311Call a POISON CENTER or doctor/physician.
P304+P340IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for
breathing.
P405Store locked up.
P403+P233Store in a well-ventilated place. Keep container tightly closed.
P390Absorb spillage to prevent material damage.
P310Immediately call a POISON CENTER or doctor/physician.
P301+P330+P331IF SWALLOWED: rinse mouth. Do NOT induce vomiting.
P303+P361+P353IF ON SKIN (or hair): Remove/Take off immediately all contaminated clothing. Rinse skin
with water/shower.
P272Contaminated work clothing should not be allowed out of the workplace.
P333+P313If skin irritation or rash occurs: Get medical advice/attention.
The text for GHS Hazard Statements shown above (if any) is given in the "16. Other Information" section.
4. First-aid Measures
FIRST AID - EYE CONTACT: Immediately flush eyes with plenty of water for at least 15 minutes holding eyelids open. Get medical
attention. Do NOT allow rubbing of eyes or keeping eyes closed.
FIRST AID - SKIN CONTACT: Wash skin with soap and water. Remove contaminated clothing. Get medical attention if irritation
develops or persists. Immediately flush skin with plenty of water for at least 15 minutes while removing clothing. Get medical
attention immediately. Wash clothing separately before reuse. Destroy contaminated shoes.
FIRST AID - INHALATION: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get
immediate medical attention. Do NOT use mouth-to-mouth resuscitation. If you experience difficulty in breathing, leave the area to
obtain fresh air. If continued difficulty is experienced, get medical assistance immediately.
FIRST AID - INGESTION: Swallowing less than an ounce will not cause significant harm. For larger amounts, do not induce
vomiting, but give one or two glasses of water to drink and get medical attention. If swallowed, do not induce vomiting. If victim is
conscious and alert, give 2 to 4 cupfuls of water or milk. Call a physician or poison control center immediately. Never give anything
by mouth to an unconscious person. Treat symptomatically and supportively. Do not induce vomiting unless advised by a physician.
Call nearest Poison Control Center or Physician immediately.
5. Fire-fighting Measures
EXTINGUISHING MEDIA:
Alcohol Film Forming Foam, Carbon Dioxide, Dry Chemical, Water Fog
UNUSUAL FIRE AND EXPLOSION HAZARDS: FLASH POINT IS TESTED TO BE GREATER THAN 200 DEGREES F. No unusual
fire or explosion hazards noted. Keep containers tightly closed.
SPECIAL FIREFIGHTING PROCEDURES: Water may be used to cool closed containers to prevent buildup of steam. Containers
can rupture and release highly toxic material if exposed to heat. Substance is non-combustible but reacts with many metals to form
explosive hydrogen gas. Use water spray to keep fire-exposed containers cool. Containers may explode when heated.
6. Accidental Release Measures
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: Dispose of according to local, state (provincial) and federal
regulations. Do not incinerate closed containers. Avoid runoff into sewers and waterways. Provide ventilation and approach spill
from upwind using proper personal protective equipment as indicated in Section 8. Carefully neutralize spill with sodium bicarbonate
(NaHCO3). Contain spilled liquid with sand or earth. DO NOT use combustible materials such as sawdust.
7. Handling and Storage
HANDLING: Avoid contact with eyes. Wash hands before eating. Wash thoroughly after handling. Remove contaminated clothing
and launder before reuse. Use only with adequate ventilation. Follow all MSDS/label precautions even after container is emptied
because it may retain product residues. Avoid breathing fumes, vapors, or mist. Avoid contact with eyes, skin and clothing.
STORAGE: Keep from freezing. Keep container closed when not in use. Store in a dry, well ventilated place. Keep container tightly
closed when not in use.
ENGINEERING CONTROLS: Prevent build-up of vapors by opening all doors and windows to achieve cross-ventilation. Use
process enclosures, local exhaust ventilation, or other engineering controls to control airborne levels below recommended exposure
limits. Provide general dilution of local exhaust ventilation in volume and pattern to keep TLV of hazardous ingredients below
acceptable limits.
Date Printed: 9/11/2014
RESPIRATORY PROTECTION: A NIOSH/MSHA approved air purifying respirator with organic vapor cartridge or canister may be
permissible under certain circumstances where airborne concentrations are expected to exceed exposure limits. A respiratory
protection program that meets OSHA 1910.134 and ANSI Z88.2 requirements must be followed whenever workplace conditions
warrant a respirator's use.
SKIN PROTECTION: Nitrile or Neoprene gloves may afford adequate skin protection. Use gloves to prevent prolonged skin contact.
Use impervious gloves to prevent skin contact and absorption of this material through the skin.
EYE PROTECTION: Use safety eyewear designed to protect against splash of liquids. Use ANSI Z87.1 approved safety eyewear.
OTHER PROTECTIVE EQUIPMENT: Refer to safety supervisor or industrial hygienist for further information regarding personal
protective equipment and its application. Refer to safety supervisor or industrial hygienist for further guidance regarding types of
personal protective equipment and their applications.
HYGIENIC PRACTICES: Wash thoroughly with soap and water before eating, drinking or smoking. Remove contaminated clothing
immediately and launder before reuse.
CONDITIONS TO AVOID: Avoid contact with strong acid and strong bases. Avoid contact with metals.
INCOMPATIBILITY: Incompatible with strong oxidizing agents, strong acids and strong alkalies. Product slowly corrodes copper,
aluminum,zinc, and galvanized surfaces
HAZARDOUS DECOMPOSITION: When heated to decomposition, it emits acrid smoke and irritating fumes. By open flame, carbon
monoxide and carbon dioxide. Decomposition produces hydrogen chloride, chlorine and hydrogen gases.
HAZARDOUS POLYMERIZATION: Will not occur under normal conditions.
STABILITY: This product is stable under normal storage conditions.
11. Toxicological information
EFFECTS OF OVEREXPOSURE - EYE CONTACT: Causes eye burns. Causes eye irritation. Substance causes severe eye
irritation. Injury may be permanent.
EFFECTS OF OVEREXPOSURE - SKIN CONTACT: Contact causes severe skin irritation and possible burns. Substance may
cause slight skin irritation. Severely irritating; may cause permanent skin damage.
EFFECTS OF OVEREXPOSURE - INHALATION: Low hazard for usual industrial handling or commercial handling by trained
personnel. Routine handling and application does not require use of respiratory protection; however, if air monitoring demonstrates
vapor, mist, or dust levels above applicable limits, wear an appropriate, properly fitted respirator (NIOSH/MSHA approved) during
handling and application. Follow respirator manufacturer's directions for respirator use. Harmful if inhaled. High gas, vapor, mist or
dust concentrations may be harmful if inhaled. Avoid breathing fumes, spray, vapors, or mist. High vapor concentrations are irritating
to the eyes, nose, throat and lungs.
EFFECTS OF OVEREXPOSURE - INGESTION: Substance may be harmful if swallowed. Corrosive and may cause severe and
permanent damage to mouth, throat and stomach.
EFFECTS OF OVEREXPOSURE - CHRONIC HAZARDS: Contains Titanium Dioxide. Titanium Dioxide is listed as a Group
2B-"Possibly carcinogenic to humans" by IARC. No significant exposure to Titanium Dioxide is thought to occur during the use of
products in which Titanium Dioxide is bound to other materials, such as in paints during brush application or drying. Risk of
overexposure depends on duration and level of exposure to dust from repeated sanding of surfaces or spray mist and the actual
concentration of Titanium Dioxide in the formula. (Ref: IARC Monograph, Vol. 93, 2010)Repeated exposure to low concentrations of
HCl vapor or mist may cause bleeding of nose and gums.
This product has been reviewed according to the EPA ‘Hazard Categories’ promulgated under Sections 311 and 312 of the
Superfund Amendment and Reauthorization Act of 1986 (SARA Title III) and is considered, under applicable definitions, to
meet the following categories:
Acute Health Hazard
Sara Section 313:
This product contains the following substances subject to the reporting requirements of Section 313 of Title III of the
Superfund Amendment and Reauthorization Act of 1986 and 40 CFR part 372:
Chemical Name
Aluminum Oxide1344-28-1
CAS-No.
Toxic Substances Control Act:
This product contains the following chemical substances subject to the reporting requirements of TSCA 12(B) if exported from
the United States:
No TSCA components exist in this product.
Date Printed: 9/11/2014
Inventory Information
CountryValue
USA (TSCA)No Information
Canada (DSL)No Information
Mexico(INSQ)No Information
Europe (EINECS)No Information
Japan (ENCS)No Information
Philippines (PICCS)No Information
China (IECSC)No Information
Australia (AICS)No Information
Korea (KECI)No Information
New Zealand (NZIOC)No Information
No Information
CALIFORNIA PROPOSITION 65:
Warning: This products contains a substance known to the State of California to cause cancer.
Chemical Name
Titanium Dioxide
CAS-No.
13463-67-7
CALIFORNIA PROPOSITION 65 REPRODUCTIVE TOXINS
Page 6 / 7
Warning: This product contains a substance known to the State of California to cause birth defects or other reproductive
harm.
No Proposition 65 Reproductive Toxins exist in this product.
International Regulations:
CANADIAN WHMIS:
This SDS has been prepared in compliance with Controlled Product Regulations except for the use of the 16 headings.
Legend: N.A. - Not Applicable, N.E. - Not Established, N.D. - Not Determined
Date Printed: 9/11/2014
Text for GHS Hazard Statements shown in Section 3 describing each ingredient:
H226Flammable liquid and vapour.
H290May be corrosive to metals.
H302Harmful if swallowed.
H311Toxic in contact with skin.
H312Harmful in contact with skin.
H314Causes severe skin burns and eye damage.
H317May cause an allergic skin reaction.
H332Harmful if inhaled.
Icons for GHS Pictograms shown in Section 3 describing each ingredient:
GHS02
GHS05
GHS06
Page 7 / 7
GHS07
Rust-Oleum Corporation believes, to the best of its knowledge, information and belief, the information contained herein to be
accurate and reliable as of the date of this safety data sheet. However, because the conditions of handling, use, and storage of
these materials are beyond our control, we assume no responsibility or liability for personal injury or property damage incurred by
the use of these materials. Rust-Oleum Corporation makes no warranty, expressed or implied, regarding the accuracy or
reliability of the data or results obtained from their use. All materials may present unknown hazards and should be used with
caution. The information and recommendations in this material safety data sheet are offered for the users’ consideration and
examination. It is the responsibility of the user to determine the final suitability of this information and to comply with all applicable
international, federal, state, and local laws and regulations.
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.