Russound 854 User Manual
FOLD
FOLD
FOLD
FOLD
854
Mini Tabletop Infrared
Receiver
Instruction Manual
LIMITED WARRANTY
The Russound 854 IR Receiver is fully guaranteed for ten (10) years from the date of purchase against all defects in materials and workmanship. For this warranty to apply, the
unit must be installed and used according to its written instructions. During this period,
Russound will replace any defective parts and correct any defect in workmanship without
charge for either parts or labor. Accidental damage and shipping damage are not considered defects under the terms of this warranty. Russound assumes no responsibility for
defects resulting from abuse or servicing performed by an agency or person not specifically authorized in writing by Russound. If service is necessary, it must be performed by
Russound. Damage to or destruction of components due to excessive power voids the
warranty. In these cases, the repair will be made at the owner’s expense. To return for
repairs, the unit must be shipped to Russound at the owner’s expense, along with a note
explaining the nature of the service required. Be sure to pack in a corrugated container
with at least 3 inches of resilient material to protect the unit from damage in transit.
Before returning a unit for repair, call Russound at (603) 659-5170 for a Return
Authorization number. Write the RA number on the shipping label and ship to: Russound,
ATTN: Service, 5 Forbes Road, Newmarket NH 03857
Russound sells product only through authorized Dealers and Distributors to ensure that
customers obtain proper support and service. Any Russound product purchased from an
unauthorized dealer or other source, including retailers, mail order sellers and online sellers
will not be honored or serviced under existing Russound warranty policy. Any sale of
products by an unauthorized source or other manner not authorized by Russound shall
void the warranty on the applicable product.
5 Forbes Rd. Newmarket, NH 03857, USA
☎ 603.659.5170 • Fax 603.659.5388
e-mail: tech@russound.com
Come visit us at:
PRODUCT OVERVIEW
The 854 IR Receiver receives IR signals from a handheld IR remote control
and relays the signals to the audio/video equipment for operation from
another room.
FEATURES
• Blue IR confirmation LED
• Wide band IR receives IR from many types of remotes
• Non-skid base
• 36-inch cable with 1/8” (3.5mm) stereo mini-plug
SPECIFICATIONS
Receive Frequency: 36kHz to 58kHz
Transmit Frequency: 40kHz and 56kHz
Range: On Axis – 55ft to 80ft
30º Off Axis – 30ft to 55ft
Power: 12VDC 31mA max.
Dimensions: 2.28”W x 0.72”H x 1.68”D
(57mm x 18mm x 42mm)
SIGNAL
+12VDC
GND
Sleeve
Tip
Ring
WIRE CONNECTIONS
INSTALLATION
The 854 is used in two typical installations: Direct (connected directly to an
IR connecting block, e.g., 857) and Remote (remote mounting using an
interface, e.g., IRB-1 in-wall connecting block). In both installations, the 854
may be connected to the IR RECEIVER IN jack using the 1/8(3.5mm) ” stereo
mini-plug. In remote installations, it may be preferable to hardwire to the
4-position termination plug on the 857 or IRB-6 connecting block.
Y
Conductors on
1/8” (3.5mm) stereo mini-plug
854 IR RECEIVER
857 CONNECTING BLOCK
DESIGNED IN USA MADE IN KOREA
SIGNAL
STATUS
GND
+
12VDC
IR C
OMMON
I
N
ONFIRM
IR C
EMMITERS
LOCK
B
NFRARED
857 I
123456
ONNECTING
C
POWER SUPPL
846C 12VDC
IR R
ECEIVER
I
N
12VDC
+
P
OWER
12VDC
+
S
TATUS
IRB-1 CONNECTING BLOCK
INSTALLATION
REMOTE
IR RECEIVER CONNECTION
4 CONDUCTOR WIRE
AW2260AB 22 GAUGE
INSTALLATION
DIRECT
854 IR RECEIVER
OTHER IR PRODUCTS FROM RUSSOUND
858
Decora® In-wall
IR Receiver
IRB-1
In-wall IR
Connecting
Block
IRB-6
In-wall IR
Connecting
Block
845.1 Single IR
Micro-Emitter
1584.1 Dual IR
Micro-Emitter
SaphIR Eye
Flush Mount IR
Mini Receiver
SaphIR Phantom
Surface Mount IR
Mini Receiver
857
IR Connecting Block
Decora® is a registered trademark of Leviton Corp.
C
S
TATUS
+
12VDC
P
OWER
+
12VDC
IR R
ECEIVER IN
IR C
OMMON IN
+
12VDC
GND
STATUS
SIGNAL
DESIGNED IN USA MADE IN KOREA
ONNECTING
B
LOCK
IR C
ONFIRM
123456
857 I
NFRARED
EMITTERS
IR RECEIVER
IR RECEIVER CONNECTION
IR INTERFACE
1
2
EMITTERS
3
4
POWER
STATUS
Loading...