Russell Hobbs RHPK3000RED Instruction Manual

1

RHPK3000RED_IB_FA_031215

SALT & PEPPER MILLS

2 YEAR WARRANTY

INSTRUCTIONS & WARRANTY

RHPK3000RED

Motor Unit

(underside)

1

2

3

4

8

5

9

10

6

7

Congratulations on the purchase of your Russell Hobbs appliance. Each unit is manufactured
to ensure safety and reliability. Before using the appliance for the first time, please read the
instruction booklet carefully and keep it for future reference. Pass it on if you pass on the
appliance.

When using electrical appliances, basic safety precautions should always be followed.

2

1. Switch

2. Battery compartment

3. Batteries (not included)

4. Motor unit

5. Spindle

6. Viewing window

7. Grinder

8. Bulb connection points

9. Brass connection pins

10. LED Light (not pictured)

DISMANTLING

• Grip around the body of the motor unit and clear viewing window.

• Turn the cover to move the pointer

from lock to unlock .

Lift the motor unit off the grinder.

• Remove the battery compartment by grasping around the motor unit top and body and
turning to move the pointer

from lock to unlock .

FIT BATTERIES

• For maximum performance, always use good quality batteries.

• Fit 6 AAA batteries (not included) into each motor unit.

• The polarities ("+" & "-") are marked on the battery compartment.

FILL THE GRINDERS

• Ensure you are using grinder quality seasoning.

• Fill the grinders with peppercorns, sea salt, dried herbs or spices.

• Donotoverll;thiswillcauseproblemsduringreassembly.

ASSEMBLING

• Retthemotorunittothegrinderbyaligningthepointer with the unlock on the clear
viewing window.

• Rotate the motor unit moving it into the lock

position.

• Retthebatterycompartmentbyaligningthepointer

with the unlock on the motor unit.

Rotate the battery compartment moving it into the lock

position.

ADJUST THE GRIND

• Tip the whole mill upside down and turn the grinder clockwise towards the negative for a

nergrind.

NOTE: Grind will become progressively finer as you rotate the grinder.

• Tip the mill the right way up and press the switch.

• Check the grind size and if required, readjust to suit by turning the grinder anti-clockwise
towards the positive

.

NOTE: Do not turn the knob more than 6 complete rotations clockwise towards the"+". This may unscrew the
knob from the spindle.

• Do the same for the other mill.

USING THE MILLS

• Hold the mill directly over food to be seasoned and press the switch. The motor will run while
the switch is pressed and the light will illuminate.

• Release the switch to stop the motor.

3