Energy Efficiency ...................................................................................................... 32
For Customer Services, Spare Parts & Manufacturer's Warranty Information please call 01204 664 084
-4-
Before Use
Safety Warnings
Do not use an extension lead for this appliance. Only plug directly into a wall
socket.
Do not plug in damaged plug sockets
In case the power cable becomes damaged, contact 01204 664 084 for advice.
Never pull the cable when unplugging – always grip the plug itself.
Do not plug-in or pull-out the plug from the receptacle with wet hands to prevent
electric shock.
Never touch the machine with wet hands or feet.
Never open the detergent drawer when the appliance is running.
Never force the door to open when the washing machine is running.
Do not touch discharging hose and water during discharging as the appliance
may reach high temperatures when running.
In case of any breakdown, unplug the appliance first and then turn the tap off. Do
not attempt to repair by yourself, always contact 01204 664 084 for advice.
Remember that packaging materials of your machine may be dangerous for
children. Keep the packaging materials in a place where children cannot reach or
dispose of them appropriately.
Do not allow your children to play with the washing machine as it is an electrically-
driven appliance.
Keep your pets away from your machine.
Your machine should only be used by adults in line with the information provided
in this user’s manual.
Your machine is designed to be used domestically. Commercial use will cause
your warranty to be cancelled.
Anyone’s intervention to your machine except for a qualified engineer, in anyway
will cause your warranty to be invalid.
Ideal operating temperature of your machine is 15-25˚C.
Do not place your machine on carpet as this will block ventilation of the base.
Do not keep inflammable liquids near your machine.
You should remove the transport bolts of your machine before the first usage.
Faults occurring in machines operated with transport bolts fitted are not covered
by the warranty.
Do not put the discharging hose of your machine in a bucket or sink.
Your machine is not covered under warranty for faults caused by any kind of
external factors (pesticides, fire, etc.).
The appliance is not intended for use by people (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety. Children should be supervised
to ensure that they do not play with the appliance.
For Customer Services, Spare Parts & Manufacturer's Warranty Information please call 01204 664 084
-5-
Recommendations
Ensure you run the machine empty on a full cycle at 95°C with detergent
before using the machine properly for the first time.
Put detergent into the drawer at the beginning of each wash.
It is recommended that you wash only extremely dirty laundry in prewashing
programme.
The amount of laundry you put in your washing machine should not exceed 6kg.
If your machine is not going to be used for a long time you should unplug the
appliance, turn off the water inlet and leave the door slightly open. This is so that
the inside of your machine will remain dry and will not cause an unpleasant smell
of damp.
1.Detergent drawer
2.Programme knob
3.Electronic display
4.Door
5.Cover of pump filter
1 2 3 4 5
6. Transport bolt
7.Power cable
8. Discharging hose
9. Water inlet valve
9
6 8 7
For Customer Services, Spare Parts & Manufacturer's Warranty Information please call 01204 664 084
-6-
Front
Back
Components
For Customer Services, Spare Parts & Manufacturer's Warranty Information please call 01204 664 084
-7-
Installation
Removing transportation bolts
Transportation bolts, which are located at the back of the machine, must be removed
before using or running the machine.
Loosen the bolts by rotating counterclockwise with a suitable spanner.
Pull out the bolts together with the coloured plastic spacer, (the screws that have
been removed from the machine should be kept in case the machine needs to be
used in future).
To seal the holes insert the supplied plastic caps.
For Customer Services, Spare Parts & Manufacturer's Warranty Information please call 01204 664 084
-8-
Levelling the machine
Your machine should be installed on a hard surface – do not install onto a carpet.
For your machine to work quietly and without any vibration, it should it be settled
on a flat, non-slippery and tough ground.
Loosen the plastic adjustment nut.
Adjust the feet upward and downward by rotating them clockwise and anti
clockwise.
When the correct balance has been achieved, tighten the plastic adjustment nut
again by rotating it upwards.
Never put cardboard, wood or other materials under your machine to try and
stabilise the unit.
Electrical connection
Your washing machine is set to 220-240V and 50Hz.
The mains cord of your washing machine is equipped with a specific grounded
plug. This plug should always be inserted to a grounded socket of 13 amps. The
current value of the fuse should be 10 amps.
We do not take responsibility for any damage that occurs due to
ungrounded usage.
Operating your machine under low voltage will cause the life cycle of your
machine to be reduced and its performance to be restricted.
For Customer Services, Spare Parts & Manufacturer's Warranty Information please call 01204 664 084
-9-
Water inlet connection
Only a qualified engineer should install this machine
Your machine has a single water (cold) inlet.
To prevent leakages on the connection joints, 1 seal is included in the hose
packing, (Fit this seal on the end of the water inlet hose at the tap side.)
Connect the bracketed end of the water inlet hose to the water inlet valve at the
rear of the machine and the other end to your tap.
Water pressure of 0,1-1 MPa from your tap will enable your machine to work more
efficiently, (0,1 MPa pressure means water flow of more than 8 litres in 1 minute
from a fully opened tap).
After all connections are completed, check for leakages around the connection
joints by turning on your tap completely and seeing if any water escapes.
Be sure that water inlet hose is not folded, broken or crushed.
Mount the water inlet hose to a 3”/4 geared water tap.
Water discharge connection
Be sure that the water inlet hoses are not folded, twisted, crushed or elongated by
stretching.
The water drain hose should be mounted at a height of minimum 60 cm,
maximum 100 cm from the ground.
The end of the water drain hose can be fitted directly to the drainage hole.
Never attempt to extend the water drain hose by adding extra parts.
Operating voltage /
frequency (V/Hz)
(220-240) V ~/50Hz
Total current (A)
10
Water pressure (Mpa)
Maximum: 1 Mpa
Minimum: 0.1 MPa
Total power (W)
2200
Maximum dry laundry
capacity (kg)
9
Wringing revolution (rev /
min)
1200
Programme number
15
Dimensions
(Height x Width x Depth)
(mm)
845 x 597 x 582
For Customer Services, Spare Parts & Manufacturer's Warranty Information please call 01204 664 084
-10-
Technical specifications
Loading...
+ 23 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.