Page 1
LARDER FRIDGE
INSTRUCTION MANUAL
Model num ber: RH120
Please read these instructions carefully and
keep them for future reference
Page 2
Page 3
Index
BEFORE USING THE APPLIANCE.....................................................................2
Safety Instructions.............................................................................................................2
Before Switching On..........................................................................................................2
Recommendations............................................................................................................3
Installation and Switching On The Appliance.................................................................4
THE PARTS OF THE APPLIANCE AND THE COMPARTMENTS........................5
TEMPERATURE.................................................................................................6
Thermostat Setting............................................................................................................6
CLEANING AND MAINTENANCE.......................................................................7
Defrosting...........................................................................................................................7
Replacing The Light Bulb.................................................................................................8
TRANSPORTATION AND CHANGING OF INSTALLATION POSITION...............8
Changing door position....................................................................................................9
BEFORE CALLING YOUR AFTER SALES SERVICE.........................................11
- 1 -
Page 4
BEFORE USING THE APPLIANCE
Safety Instructions
• If the model contains R600a-see name plate under refrigerant (the coolant isobutane),
naturals gas that, is very environmentally friendly but also combustible. When
transporting and installing the unit care must be taken to ensure that none of the
refrigeration circuit components become damaged. In the event of damage avoid
naked flames or ignition sources and ventilate the room in which the unit is placed
for a few minutes.
Warning: Keep ventilation openings in appliance enclosure or in structure for building
in, clear of obstruction.
• Do not use mechanical devices or other artificial means to accelerate the defrosting
process.
• Do not use electrical appliances in the refrigerator or freezer compartment of the
appliance.
• If this appliance is to replace an old refrigerator with a lock; break or remove the lock
as a safety measure before storing it, to protect children while playing might lock
themselves inside.
• Old refrigerators and freezers contain insulation gases and refrigerant, which must
be disposed of properly. Entrust the disposal of a scrap unit categorically to
competence of your local waste disposal service and contact your local authority or
your dealer if you have any questions. Please ensure that the pipe of work of your
refrigerating unit does not get damaged prior to being picked-up by the relevant waste
disposal service.
Important note:
Please read this booklet before installing and switching on this appliance. The
manufacturer assumes no responsibility for incorrect installation and usage as described
in this booklet.
Conformity Information
• Tropical Class is defined for the environment temperatures between 16°C and 43°C
in accordance with the TS EN ISO 15502 Standards.
• The appliance is designed in compliance with the EN15502, IEC60335-1 /
IEC60335-2-24, 2004/108/EC standards.
Before Switching On
• Wait after 3 hours before plugging the appliance in to the main
power to ensure proper performance.
• There can be an odor when you first switch on the appliance, it
will disappear after the appliance starts to cool.
- 2 -
Page 5
Recommendations
Warning: Do not use mechanical devices or other means to accelerate the defrosting
process, other than those recommended by the manufacturer. Do not use electrical
appliances inside the food storage compartments of the appliance, unless they are of
the type recommended by the manufacturer. Keep ventilation openings, in the appliance
enclosure or in the built-in structure, clear of obstruction. Do not damage the refrigerant
circuit.
• Do not use adapters or shunts, which could cause overheating
or burning.
• Do not plug old, warped power supply cables.
• Do not twist and bend the cables.
• Do not allow children to play with the appliance. Children must
NEVER sit on drawers or hang from the door.
• Do not use sharp metal objects for removing ice on the freezer
compartment; they could puncture the refrigerator circuit and
cause unrepairable damage to the unit.
• Do not plug the power supply with wet hands.
• Do not place containers (glass bottles or tin containers) of liquids
into the freezer especially gassy liquids as they could cause
the container to burst during freezing.
• Bottles that contain a high percentage of alcohol must be sealed
well and placed vertically in the refrigerator.
• Do not touch the cooling surfaces, especially with wet hands as
you could be burnt or hurt.
• Do not eat ice, which have just been removed from the freezer.
• The appliance is not intended for use by people (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by
a person responsible for their safety. Children should be supervised to ensure that
they don’t play with the appliance.
• If the supply cord is damaged it must be replaced by the manufacturer or service
agent or similary qualified people in order to avoid a hazard.
- 3 -
Page 6
Installation and Switching On The Appliance
• This appliance is connecting to 220-240V or 200-230V and 50 Hz. Please check
nameneplate of appliance and be sure voltage range suitable to your mains voltage.
• If you need help or are unsure how to install the unit please contact the service agent
or appointed peson.
• Before making the connection to the power supply, ensure that the voltage on the
nameplate corresponds to the voltage of electrical system in your home.
• Insert the plug into a socket with an efficient ground connection. If the socket has no
ground contact or the plug does not match, we suggest you to call an authorised
electrician for assistance.
• The plug should be accessible after the appliance is positioned.
• Manufacturer is not responsible for failure to complete the
ground connection as described in this booklet.
• Do not place the appliance in direct sunlight.
• Do not use in open air and shall not be exposed to rain.
• Place the refrigerator far from heat sources and in a wellventilated position. The refrigerator should be at least 50 cm
from radiators,gas or coal stoves and 5 cm far from electrical
stoves.
• Keep the top free for at least 15 cm.
• Do not place heavy and lots of things on the appliance.
• If the appliance is installed next to another refrigerator or freezer,
observe a miminum distance of 2 cm to prevent condensation.
• Do not put very ( !) hot food or bowl on the top table.It can damage
the toptable.
• Fit the plastic wall spacers to the condenser at the back of the
refrigerator in order to prevent leaning to the wall for good
performance.
• The appliance must be stand firmly and level on the floor Use
levelling-feet to compensate for an uneven floor.
• The outside of the appliance and the accessories inside should be cleaned with a
solution of water and liquid soap ; the inside of the appliance with sodium bicarbonate
dissolved in lukewarm water. After drying replace all the accessories.
- 4 -
Page 7
THE PARTS OF THE APPLIANCE AND THE COMPARTMENTS
1
6
7
2
3
4
1) TOP TABLE
2) REFRIGERATOR SHELF
3) CRISPER COVER
4) CRISPER
5) LEVELING FEET
6) DOOR PROFILE
6
5
7) EGG SHELF&HOLDER
8) THERMOSTAT BOX
This presentation is only for information about the parts of the appliance.
Parts may vary according to the appliance model.
- 5 -
Page 8
TEMPERATURE
Thermostat Setting
• Thermostat automatically regulates the inside temperature of the refrigerator
compartment and freezer compartment.By rotating the knob from position 1 to 5,
colder temperatures can be obtained.
• « 0 » position shows thermostat is closed and no cooling is available.
• For short-term storage of food in the freezer compartment, you can set the knob
between minimum and medium position (1-3)
• For long-term storage of food in the freezer compartment, you can set knop medium
position.(3-4)
Note that; the ambiant temperature, the temperature of the freshly stored food and
how often the door is opened, affects the temperature in the refrigerator compartment.
If required, change the temperature setting.
• When you first switch on the appliance, for starting a suitable cooling, the appliance
should work 24 hours continuously until it cools down to sufficient temperature.
• In this time do not open the door so often and place a lot of food inside the appliance.
• If the unit is switched off or unplugged, you must allow at least 5 minutes before
restarting or re-plugged the unit in order not to damage the compressor.
• Larders (coolers) have not any freezer compartment but can cool up to 4-6°C.
If your fridge is not cooling enough;
Your fridge is designed to operate in the ambient temperature intervals stated in the
standards, according to the climate class stated in the information label. We do not
recommend operating your fridge out of stated temperatures value limits in terms of cooling
effectiveness.
Climate ClassAmbient Temperature (°C)
T
ST Between 16 and 38 (°C)
N
SN Between 10 and 32 (°C)
- 6 -
Between 16 and 43 (°C)
Between 16 and 32 (°C)
Page 9
CLEANING AND MAINTENANCE
• Disconnect unit from the power supply before cleaning.
• Do not clean the appliance by pouring water.
• The refrigerator compartment should be cleaned
periodically using a solution of bicarbonate of soda and
lukewarm water.
• Clean the accessories seperately with soap and water Do
not clean them in the washing machine.
• Do not use abrasive products, detergents or soaps.After
washing, rinse with clean water and dry carefully. When the
cleaning operations have been completed reconnect the
plug of the unit with dry hands.
• You should clean the condenser with broom at least twice
a year in order to provide energy saving and increase
the productivity.
Defrosting
• Defrosting occurs automatically in refrigerator compartment during operation ; the
defrost water is collected by the evaporating tray and evoparates automatically.
• The evaporating tray and the defrost water drain hole should be cleaned periodically
with defrost drain plug to prevent the water from collecting on the bottom of the
refrigerator instead of flowing out.
• You can also pour ½ glass of the water to drain hole to clean inside.
- 7 -
Page 10
Replacing The Light Bulb
When replacing the light of the refrigerator compartment;
1. Unplug the unit from the power supply,
2. Press the hooks on the sides of the light cover top and remove the light cover
3. Change the present light bulb with a new one of not more than 15 W.
4. Replace the light cover and after waiting 5 minutes plug the unit.
TRANSPORTATION AND CHANGING OF INSTALLATION
POSITION
Transportation and Changing of Installation Position
• The original packages and foamed polystyrene (PS) can be concealed if required.
• In transportation the appliance should be tied with a wide stripe or a strong rope.
The rules written on the corrugated box must be applied while transporting.
• Before transporting or changing old
installation position, all the moving objects
(ie,shelves,crisper…) should be taken out
or fixed with bands in order to prevent the
shake.
Before Switching On
• Wait after 3 hours before plugging the appliance in to the main power to ensure
proper performance.
• There can be an odor when you first switch on the appliance, it will disappear after
the appliance starts to cool.
- 8 -
Page 11
Changing door position
Step-1: Lie down the appliance on it’s left
side put a piece of protective
material under neath the
appliance, i.e. card, towel, etc.
Step-3: Unscrew the two screws which are
fixing the bottom hinge.
Step-1: Dismantle both levelling feet.
Step-4: Dismantle the bottom hinge.
Step-5: After removing the door from the
cabined and unscrew the pin of
the right top hinge.
Step-6: Screw the pin on the left top hinge.
- 9 -
Page 12
Step-7: Replace the bushing and bushing
caps on the door as shown.
Step-8: Unscrew the pin of the bottom
hinge and screw it on the other
hole.
Step-9: Assemble the door and the bottom
hinge with two screw on the left
side.
Step-10: Assemble both levelling feet to
their places.
- 10 -
Page 13
BEFORE CALLING YOUR AFTER SALES SERVICE
If your refrigerator is not working properly,it may be a minor problem, therefore check the
following, before calling an electrician to save time and money.
What to do if your refrigerator does not operate ;
Check that ;
1. There is no power,
2. The general switch in your home is not disconnected ,
3. The thermostat setting is on « 0 » position,
4. The socket is not sufficient. To check this, plug in another appliance that you
know which is working into the same socket.
What to do if your refrigerator performs poorly ;
Check that ;
1. You have not overloaded the appliance ,
2. The doors are closed perfectly ,
3. There is no dust on the condenser ,
4. There is enough place at the rear and side walls.
5. The refrigeration thermostat setting is in the “1” position (it so set the thermostat
dial suitable value)
If there is noise ;
1. The cooling gas which circulates in the refrigerator circuit may make a slight
noise(bubbling sound) even when the compressor is not running. Do not worry
this is quite normal. If these sounds are different check that ;
2. The appliance is well leveled ,
3. Nothing is touching the rear ,
4. Anything that is on the front sides or top of the unit are not vibrating.
If there is water in the lower part of the refrigerator ;
Check that ;
1. The drain hole for defrost water is not clogged (Use defrost drain plug to clean
the drain hole)
Recommendations
• In order to increase space and improve the appearance,the « cooling section » of
refrigerators is positioned inside the back wall of the refrigerator compartment. When
the appliance is running, this wall is covered with frost or water drops,according to
weather the compressor is running or not. Do not worry. This is quite normal. The
appliance should be defrosted only if an excessively thick layer forms on the wall.
• If the appliance is not used for long time (for example during the summer holidays)set
te thermostat knob to « 0 » position. Defrost and clean the refrigerator leaving the
door open to prevent the formation of midew and smell.
- 11 -
Page 14
Page 15
Page 16
For Customer Services &
Warranty Information please call
0845 683 8717
Opening times:
Monday - Friday
8am until 8pm
Saturday & Sunday 10am until 4pm
Customer Service Department
Picktree Court
Picktree Lane
Chester-le-Street
Co Durham
DH3 3SY
Revision 1
This symbol is known as the 'Crossed-out wheelie bin Symbol'. W hen this
symbol is marked on a product/batteries, it means that the product/batteries
should not be disposed of with your general household waste. Only discard
electrical/electronic/battery items in separate collection schemes, which cater
for the recovery and recycling of materials contained within. Your co-operation
is vital to make sure the success of these schemes and for the protection of the
environment. For your nearest disposal facility, visit www.recycle-more.co.uk
or ask in store for details.
W e reserve the right due to possible changes to design to alter the instruction
manual without prior notice.
52034910
Loading...