Russell Hobbs RH1130 Instructions And Warranty

INSTRUCTIONS AND WARRANTY

MODEL NO: RH1130

BRUSHED SATIN FINISH HAND MIXER

2

Congratulations on purchasing our Russell Hobbs Hand Mixer. Each unit is

manufactured to ensure safety and reliability. Before using this hand mixer for the first

time, please read the instruction manual carefully and keep it for future reference.

FEATURES OF THE BRUSHED SATIN FINISH HAND MIXER

IMPORTANT SAFEGUARDS

When using any electrical hand mixer, basic safety precautions should always be

followed including the following:

CAUTION: When using the hand mixer, the unit must not be used for longer than 1

minute cycles, as this puts pressure on the motor which could lead to overheating and

product malfunction. It is recommended to allow the hand mixer a few seconds break

after each cycle and not to use for more than 5 minutes for one single operation.

1. Please read the instructions carefully before using any hand mixer.

2. Always ensure that the voltage on the rating label corresponds to the mains

voltage in your home.

3. Incorrect operation and improper use can damage the hand mixer and cause

injury to the user.

4. The hand mixer is intended for household use only. Commercial use invalids the

warranty and the supplier cannot be held responsible for injury or damage

caused when using the hand mixer for any other purpose than that intended.

5. Avoid any contact with moving parts.

6. This appliance is not intended for use by persons (including children) with

reduced physical, sensory or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision or instruction concerning

use of the appliance by a person responsible for their safety.

7. Children should be supervised to ensure that they do not play with the hand

mixer.

8. Check the power cord and plug regularly for any damage. If the cord or the plug

is damaged, the manufacturer or a qualified person must replace it in order to

avoid an electrical hazard.

3

9. Do not use the hand mixer if it has been dropped or damaged in any way. In

case of damage, take the unit in for examination and/or repair by an authorised

service agent

10. To reduce the risk of electric shock, do not immerse or expose the motor

assembly, plug or the power cord to water or any other liquid.

11. Never immerse the unit in water or any other liquid for cleaning purposes.

12. Remove the plug from the socket by gripping the plug. Do not pull on the cord to

disconnect the hand mixer from the mains. Always unplug the unit when not in

use, before cleaning or when adding or removing parts.

13. The use of accessory attachments that are not recommended or supplied by the

manufacturer may result in injuries, fire or electric shock.

14. A short cord is provided to reduce the hazards resulting from becoming

entangled in or tripping over a longer cord.

15. Do not let the cord hang over the edge of a table or counter. Ensure that the cord

is not in a position where it can be pulled on inadvertently.

16. Do not allow the cord to touch hot surfaces and do not place on or near a hot gas

or electric burner or in a heated oven.

17. Do not use the hand mixer on a gas or electric cooking top or over or near an

open flame.

18. Use of an extension cord with this hand mixer is not recommended. However, if it

is necessary to use an extension lead, ensure that the lead is suited to the power

consumption of the hand mixer to avoid overheating of the extension cord, hand

mixer or plug point. Do not place the extension cord in a position where it can be

pulled on by children or animals or tripped over.

19. This hand mixer is not suitable for outdoor use. Do not use this hand mixer for

anything other than its intended use.

20. DO NOT carry the hand mixer by the power cord.

21. Do not leave this hand mixer unattended during use. Always unplug the unit

when not in use or before cleaning.

22. Always operate the hand mixer on a smooth, even, stable surface. Do not place

the unit on a hot surface.

23. Ensure both beaters are fitted to the mixer before use.

24. It is absolutely necessary to keep this appliance clean at all times as it comes

into direct contact with food.

4

25. When blending hot liquids, be careful not to splatter by ensuring the blending arm

is placed into the mixer before starting use. Begin mixing at a low speed.

26. Ensure that the switch is in the “Off” position after each use.

27. The manufacturer does not accept responsibility for any damage or injury caused

by improper or incorrect use, or for repairs carried out by unauthorised

personnel.

28. In case of technical problems, switch off the machine and do not attempt to repair

it yourself. Return the hand mixer to an authorised service facility for

examination, adjustment or repair. Always insist on the use of original spare

parts. Failure to comply with the above mentioned pre-cautions and instructions,

could affect the safe operation of this machine.

NOTICE: This appliance is not for professional use. You should follow the requested

breaks. Failure to follow this instruction carefully may result in damage to the motor.

When using the hand mixer, the unit must not be used for longer than 1 minute cycles,

as this puts pressure on the motor which could lead to overheating and product

malfunction. It is recommended to allow the hand mixer a few seconds break after each

cycle and not to use for more than 5 minutes for one single operation.

PARTS DIAGRAM

1. Motor/Mixer body

2. Handle Cover

3. Beaters/Dough hook ejection button

4. Speed selector

5. Turbo boost button

6. Non slip mat

7. Dough hook (for large hole)

8. Dough hook (for small hole)

9. Beaters

5

CAUTION: Always check the hand mixer is switched OFF and not connected to the

mains power supply, when changing or touching the beaters or dough hooks.

OPERATING INSTRUCTIONS

FITTING THE BEATERS & DOUGH HOOKS

Remove the plug from the power outlet. Set the speed switch to “0”.

Insert the beaters or dough hooks, left side first, one at a time into the slots on the

bottom of the mixer.

Push and twist simultaneously until the beater or dough hook “clicks” into place. Insert

the left side first, this is the one which has a “lip” at the end of it.