7. Turn the switch to standby “0” / “OFF” and wait until the blades come to a complete
stop before removing the lid from the jug/bowl, and before removing the jug/bowl from
the motor/ base unit.
8. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
9. Children should be supervised to ensure that they do not play with the appliance.
10. Do not use the unit without first locking the lid in place.
11. Do not fill the jug/bowl with boiling liquids. Allow liquids to cool to a lukewarm
temperature before you put them in the jug/bowl. This type of temperature would be
comfortable to the touch.
12. Do not put your hand into the jug/bowl, even when they have been removed
for cleaning – the blades are very sharp.
13. Do not come into contact with moving parts.
14. Do not put any other object (spoon, spatula, etc.) into the jug/bowl while the unit
is plugged in.
15. Do not leave the unit unattended when plugged in.
16. Misuse of this appliance can result in injury.
17. Position the motor unit on a dry, firm, level surface, close to a power socket
and out of reach of children.
18. Route the mains lead so that it cannot be caught accidentally or tripped over.
19. Keep the unit and the mains lead away from hotplates, hobs and burners.
20. Store the unit away from direct sunlight and fluorescent light where
possible.
21. Do not let the jug/bowl overflow. If liquid gets under the motor unit, it
may be sucked into the motor, damaging it.
22. Do not fill the jug/bowl above the MAX mark. If you do, the contents may
force the lid off when you start the motor.
23. The unit is equipped with a powerful motor and therefore processes very
quickly. Due to its efficiency there is no need to run the motor for more than 2
minutes at a time.
24. Do not run the motor for more than 2 minutes, either continuously, or using
the pulse setting, otherwise it may overheat. After 2 minutes of use, switch it
off for at least 2 minutes allowing it to cool to room temperature and allowing it