150x210mm
User Manual
Bluetooth Cassette
TM
Reset
ON/OFF
Indicator light
MIC
Charger Slot
Specification
Frequency Response Range:30HZ -- 15KHZ
Bluetooth Vision: V4.0
Transmission distance: 10M
Playtime: 6 hours
Charging Voltage: 5V/1A
Charging Time: 2 hours
How to operate:
1. Press and hold the button to power on/off.
2. The blue/red indicator flashes quickly while the product searching
for Bluetooth that could be paired.
3. Turn on the Bluetooth in your device settings and select “BW
Cassette” to pair.
4. Insert the product into the cassette player and press PLAY
5. Select music on your device and enjoy the music.
Bluetooth Mode Operation:
Blue and red light flashing means it’s in pairing mode.
Blue light is constantly on when there is a call coming.
Blue light flashes slowly when it playing music.
How to accept / reject / end a call
Accepting a call – Press the “on/off” button.
Rejecting a call – Press and hold the “on/off” button.
Ending a call - Press the “on/off” button.
If there is enclosed cassette slot in your car, please don’t use this
cassette to operate the phone calls.
Charging Mode:
Red light is constantly on when product is charging.
Product is fully charged, then the red light automatically switches off.
When the power is low, red / blue light flashes quickly.
Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from
that to which the receiver is needed.
—Consult the dealer or an experienced radio/TV technician for
help.
Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Loading...