RuggON PM-311 User Manual

User’s Manual

PM-311

PM-311 User Manual

1 |

Introduction

1. Please read these safety instructions carefully.

2. Please keep this User’s Manual for later reference.

3. Please disconnect this equipment from connecter before cleaning. Don’t use liquid

or prayed detergent for cleaning. User moisture sheet or cloth for cleaning.

4. Make sure the equipments are connected to the power source with the correct

voltage, frequency, and ampere.

5. All cautions and warnings on the equipment should be noted.

6. Never pour any liquid into opening: this could cause fire or electrical shock.

7. Never open the equipment. For safety reason, the equipment should only be opened

by qualified service personnel.

8. If one of the following situations arises, get the equipment checked by a service

personnel:

a. Liquid has penetrated into the equipment.
b. The equipment has been exposed to moisture.
c. The equipment has not worked well or you cannot get it work according to user

manual.

d. The equipment has dropped and damaged. If the equipment has obvious sign of

breakage.

9. Caution on use of battery: User the battery recommended by the manufacturer or

the same type of battery installed by the manufacturer. If incorrect battery is used,

PM-311 User Manual

2 |

it may cause explosion or fire hazard. Recycle or discard used batteries according
the manufacturer’s instruction or your local authority.

10. The computers use nonvolatile memory that requires a battery to retain system

information when power is removed. The 3V lithium battery is on the system board.
The battery life depends on the amount of time the computer is powered on. If the
computer does not display the correct time and date, replace the battery.

IMPORTANT：Loss of BIOS settings occurs when the battery is removed. BIOS settings

must be reconfigured whenever the battery is replaced.

WARNING：A risk of fire and chemical burn exists if the battery is not handled properly.

Do not disassemble, crush, puncture, or short external contacts, or expose the battery
to temperatures higher than 60 °C (140 °F). Do not dispose of a used battery in water
or fire.

CAUTION：Danger of explosion if battery is incorrectly replaced. Replace only with same

or equivalent type recommended by the manufacturer. Discard used batteries according
to the manufacturer’s instructions.

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.

PM-311 User Manual

3 |

FCC RF Radiation Exposure Statement:

1. This Transmitter has been demonstrated co-location compliance requirements with

Wi-Fi, Bluetooth and RFID Modules. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.

2. This equipment complies with FCC RF radiation exposure limits set forth for an

uncontrolled environment. This device was tested for typical hand held operations
with the device contacted directly to the human body to the back side of the tablet pc.
To maintain compliance with FCC RF exposure compliance requirements, avoid direct
contact to the transmitting antenna during transmitting.

EEuurrooppee –– EEUU DDeeccllaarraattiioonn ooff CCoonnffoorrmmiitty

y

This device complies with the essential requirements of the R&TTE Directive
1999/5/EC and EMC directive 2004/108/EC. The following test methods have been
applied in order to prove presumption of conformity with the essential requirements of
the R&TTE Directive 1999/5/EC and EMC directive 2004/108/EC:

 EN 55022: 2006 +A1: 2007
 EN 61000-3-2 : 2006
 EN 61000-3-3 : 1995 + A1 : 2001 + A2 : 2005
 EN 55024: 1998 + A1: 2001 + A2: 2003

(IEC 61000-4-2: 2008;
IEC 61000-4-3: 2006 + A1:2007;
IEC 61000-4-4: 2004;
IEC 61000-4-5: 2005;
IEC 61000-4-6: 2003 + A1: 2004 +A2: 2006;
IEC 61000-4-8: 1993 +A1: 2000;
IEC 61000-4-11: 2004)

 EN 60950-1: 2001

Safety of information technology equipment

 EN 300 328 V1.7.1: 2006
 EN 301 489-17 V2.1.1: 2009 and EN 301 489-1 V1.8.1: 2008
 EN 62311: 2008

This device is a 2.4GHz wideband transmission system (transceiver), intended for use in
all EU member states and EFTA countries under the following conditions and/or with the
following restrictions:

 In Italy the end-user should apply for a license at the national spectrum authorities

PM-311 User Manual

4 |

in order to obtain authorization to use the device for setting up outdoor radio links
and/or for supplying public access to telecommunications and/or network services.

 This device may not be used for setting up outdoor radio links in France and in some areas the RF

output power may be limited to 10 mW EIRP in the frequency range of 2454 – 2483.5 MHz. For
detailed information the end-user should contact the national spectrum authority in France.

PM-311 User Manual

5 |

Table of Contents

Introduction ............................................................ 1

Table of Contents ................................................... 5

Chapter 1 ................................................................. 8

General Information ............................................... 8

1.1. Introduction.......................................................................................... 8

1.2. Specification ........................................................................................ 8

1.2.1. Main System ............................................................................................ 8

1.2.2. I/O Interface ............................................................................................. 9

1.2.3. In Front Control ........................................................................................ 9

1.2.4. Power Management ................................................................................. 9

1.2.5. Environment ............................................................................................. 9

1.2.6. Material .................................................................................................. 10

1.2.7. Operation OS ......................................................................................... 10

1.2.8. Certifications .......................................................................................... 10

1.2.9. Optional: Internal Module ........................................................................ 11

1.2.10. Optional: External Accessories ............................................................. 11

1.3. Packing List ....................................................................................... 12

Chapter 2 ............................................................... 13

System Setup ....................................................... 13

2.1. Exploring Your PM-311...................................................................... 13

2.1.1. The PM-311 IO ...................................................................................... 13

2.2.Preparing for Installation ................................................................... 17

2.2.1.Switch ON the main battery .................................................................... 17

2.2.2.Plugging to the DC supply ...................................................................... 17

2.2.3.Starting Your System .............................................................................. 18

PM-311 User Manual

6 |

2.2.4.Connecting the keyboard and mouse ..................................................... 18

Chapter 3 ............................................................... 19

Using the PM-311 ................................................. 19

3.1.Introduction......................................................................................... 19

3.2.Using the USB Ports .......................................................................... 19

3.3.Using the External Audio System ..................................................... 19

3.4.Installing the Battery (optional) ........................................................ 19

3.5.Using a SIM Card .................................................................................... 20

3.5.1.Inserting a SIM Card ............................................................................... 20

3.5.2.Removing a SIM Card ............................................................................. 21

3.6.Using a 2-in-1 Snap On MODULE (Barcode Scanner + MSR) (optional)21

Chapter 4 ............................................................... 23

The BIOS Setup Program .................................... 23

4.1.Main Screen Setup Utility .................................................................. 23

4.2.Advanced BIOS Features .................................................................. 25

4.3.Security Chip Configuration.............................................................. 25

4.4.Boot Management Setup ................................................................... 26

4.5.Exit Control ......................................................................................... 27

Chapter 5 ............................................................... 28

User Interface for PM-311 .................................... 28

5.1.Introduction......................................................................................... 28

5.2.About the User Interface .................................................................... 28

5.2.1.Enable or disable the User Interface ....................................................... 28

5.2.3.System Status Information ...................................................................... 28

5.3.Using the Application ......................................................................... 31

5.3.1.Brightness Control .................................................................................. 31

5.3.2.Volume Control ....................................................................................... 31

5.3.3.Webcam Launch ..................................................................................... 32

5.3.4.Monitor Switch ........................................................................................ 32

PM-311 User Manual

7 |

5.3.5.RF Device ON/OFF Control .................................................................... 33

Chapter 6 ............................................................... 35

Maintenance ......................................................... 35

6.1.Maintaining the Battery ...................................................................... 35

6.2.Maintaining the LCD Display ............................................................. 35

6.3.Cleaning the PM-311 .......................................................................... 35

PM-311 User Manual

8 |

CChhaapptteerr 1

1

General Information

11..11.. IInnttrroodduuccttiioonn

PM-311 rugged tablet PC is Intel® Cedar Trail Platform (N2600+NM10) processor core architecture based

rugged Tablet PC with a bright 7-inch LED backlight LCD display. The powerful CPU brings the most dynamic

applications to life without sacrifices to any industrial reliability.

Delivering a variety of connectivity features, built-in USBs, Microphone and Headphone port. It is ideal for

an all-around system performance. Furthermore, PM-311 rugged tablet PC is equipped with fanless design.

11..22.. SSppeecciiffiiccaattiioon

n

The PM-311 rugged tablet PC is a flexible, multi-functional flat tablet PC. With following specifications that

can be applied in diverse operational environments and implemented in multi-faceted applications.

1.2.1. Main System

 Platform:

Intel® Cedar Trail Platform (N2600+NM10)

 CPU:

Intel ATOM N2600 1.6GHz Dual core

 Graphic:

Intel Graphics Media Accelerator 3600 series

 Chipset:

Intel® NM10 Express Chipset

 System Memory:

2GB DDRIII 800 SO-DIMM

 Storage:

1 x 32GB SATA Slim Half-Size Solid State Disk

 LCD Panel:

7-inches LED Backlight Screen

7“ XGA (1280x800) 350nits LCD, or 700nits LCD (option)

 Touch Panel

PM-311 User Manual

9 |

5-wire Resistive Touch Screen

 Audio:

-1 x High Quality Speaker (2W)

-Internal Microphone : 1 x in front Bezel

 Communication :

- 10/100Mbps Ethernet

- Wi-Fi IEEE 802.11 a/b/g/n ; Bluetooth 4.0

 Webcam:

Front - 2 Mega-pixel Camera

Rear - 5 Mega-pixel Camera with LED Flash light

1.2.2. I/O Interface

 External I/O :

 2 x USB 2.0 (type-A),

 1x MicroSD slot,

 1x RS232

 LED Status Indicator:

 Power LED Status: 1 x Green/Red Colors
 Storage LED Status: 1 x Blue Color
 Wi-Fi LED Status: 1 x Blue Color

1.2.3. In Front Control

 Switch :

 1 x Power Button

 Button :

 Program Function Buttons : 6 x Function keys (Programmable)

1.2.4. Power Management

 Power Adapter :

 AC to DC, 19VDC@3.42A, 65W
 AC 100V ~ 240V, 50~60Hz input
 19 DC-in

 Battery (Internal Battery) :

 Internal Smart Lithium Polymer Battery, 3000mAh (2S1P), 7.4V

1.2.5. Environment

 Operation Temperature :

 -10°C to +50°C (MIL-STD-810G Method 501.5 and 502.5)

 Storage Temperature :

 -20°C to +70°C (MIL-STD-810G Method 501.5 and 502.5)

 Humidity :

PM-311 User Manual

10 |

 5-95% without condensation (MIL-STD-810G Method 507.5)

 Drop :

 5-ft drop to Plywood (MIL-STD-810G Method 516.6 Procedure IV)

 Vibration :

 Operating : SSD (MIL-STD-810G Method 514.6 Category 4 Fig 514.6C-3)

 Mechanical Shock :

 Operating : 20g, 11ms, Terminal sawtooth
 Non-operating : 40g, 11ms, Terminal sawtooth (MIL-STD- 810G Method 516.6 Procedure I)

 Water/Dust Resistance : IP65 equivalent

1.2.6. Material

 Chassis :

 RuggedTablet PC Slate

 Enclosure :

 PC/ABS Plastic, PC/ABS and TPU Double Injection with Protective Rubber Grips Set

 Dimension (W x H x D mm) :

 225 x 168 x 26.5mm

 Weight :

 Approximate 950g (with internal battery)

1.2.7. Operation OS

 WIN7 PRO
 WES7-WS7P

1.2.8. Certifications

 EMI :

 FCC part 15 Class B
 CE (EN55022 / EN55024)

 Safety :

 UL (EN60950), CE

 RF :

 FCC part 15 subpart C

 SAR :

 FCC SAR (OET 65 C)