Rudd 22V40FDVX User Manual
Warrior DVX The Vertical Co-Axial Direct Vent Gas Water Heater for Manufactured Housing
Roof Jack
(Purchased Separately)
Roof Jack
Adjustment Range
12"
Min
FRONT VIEW
A
B
C
X
®
ADJUSTABLE TILT
R
OOF FLANGE
34° MAX.
(
8 - 12 PITCH)
4
2° MAX.TILT IS
AVAILABLE WITH
O
PTIONAL KIT
(10-3/4 - 12 PITCH)
GAS CONTROL
(THERMOSTAT )
WATER
CONNECTIONS
WATER
CONNECTIONS
WATE R HEATER
TOP VIEW OF CLOSET
RELIEF
VALVE
Available in 40 and 50 Gallon Tall Gas Models
NEW FVIR Compliant!
NEW Roof Jack Flange Adjustment Range Available up to 34° (8 - 12)
NEW Smaller Foot Print – No External Air Tube
5-Year Limited Tank Warranty*1-Year Limited Parts Warranty*
Installed side mounted T&P valve
•
Can be installed anywhere in the home
•
Field convertible controls for natural gas
•
or LP operation
3/4" hot and cold top connections
•
Meets or exceeds National Appliance
•
All models are certified for applications
•
up to 7,700 feet above sea level.
Certified for manufactured (HUD)
•
and modular construction
*See Residential Warranty Information Brochure for
complete warranty information.
Energy Conservation Act (NAECA)
requirements
Piezo ignitor – easy light pilot
•
Easily fits into a standard drain pan
•
ESCRIPTION FEATURES ROUGHING IN DIMENSIONS (SHOWN IN INCHES) ENERGY INFORMATION
D
T
Y
GAL. THOUS. BTU/HR. G.P.H. 90° RISE DEL. G.P.H. WATER WT. FACTOR OPER. COSTS
P
E
AP. MODEL NUMBER NAT. LP NAT. LP NAT.
C
T
40 22V40FDVX 36 30 36.4 30.3 66 19-3/4 59-3/4 5 3/4 155 0.59 $231 $342
A
L
50 22V50FDVX 36 32 36.4 32.3 80 21-3/4 59-1/2 5 3/4 165 0.58 $235 $348
L
THE WARRIOR DVX
IS ANSI AND U.L.
CERTIFIED FOR USE
IN MODULAR HOME
CONSTRUCTION AND
MANUFACTURED
HOME USE. THIS
UNIT COMPLIES WITH
HUD SAFETY AND
CONSTRUCTION
STANDARDS.
GAS INPUT IN RECOVERY IN FIRST HOUR DIAM. HEIGHT SIZE SHIP. ENERGY AVG. ANN.
AB CC
nergy Factor and Average Annual Operating
E
osts based on D.O.E. (Department of Energy)
C
est procedures. D.O.E. national average fuel rate
t
atural gas 91¢/therm; LP $1.23/gallon.
n
TANK VENT
ONNECTION (LBS) NAT./LP NAT. LP
These units are designed
to meet or exceed ANSI
(American National
Standards Institute)
requirements and have
been tested according to
D.O.E. test procedures and
meet or exceed the energy
efficiency requirements of
NAECA, ASHRAE standard
90, ICC Code and all state
energy efficiency performance criteria for energy
consuming appliances.
Before purchasing this
appliance, read important
energy cost and efficiency
information available from
your supplier.
In keeping with its policy of continuous progress and product improvement, Rheem reserves the right to make changes without notice.
Rheem Water Heaters • 101 Bell Road, Montgomery, Alabama 36117-4305 • www.rheem.com
P R I N T E D I N U . S.A 1 0 / 0 7 W P F O R M N O. 1 02 GW- 8 R ev. 3
CO-AXIALROOF JACK SIZING TABLE
34° MAX. (8-12 ROOF JACK
PITCH) ROOF JACK ADJUSTMENT
KIT PART NUMBER RANGE (SEE X)
AP14363A 24 - 37 Inches
AP14363B 33 - 68 Inches
AP14363C 45 - 97 Inches
AP14363D 60 - 130 Inches
AP14363E 72 - 160 Inches
NOTE: 42° Max. adjustment roof jacks available.
Roof Jacks must be ordered separately with this
direct vent water heater and installed in accordance
with the instructions furnished with the heater.
No other roof jack or vertical vent kit is approved
for installation with this heater.
Loading...