Rudd 21IR50DV User Manual
30 21IR30DV 30 30.3 51 57 57 17-3/4 14-1/2 3 5 51-1/2 20 110 0.61 $224 $331
40 21IR40DV 30 30.3 60 57-1/2 57-1/2 19-3/4 14-1/2 3 5 51-1/2 20 125 0.59 $231 $342
50 21IR50DV 32 32.3 67 57 57 21-3/4 14-1/2 3 5 51-1/2 20 150 0.58 $235 $348
These units are designed
to meet or exceed ANSI
(American National
Standards Institute)
requirements and have
been tested according to
D.O.E. test procedures and
meet or exceed the energy
efficiency requirements of
NAECA, ASHRAE standard
90, ICC Code and all state
energy efficiency performance criteria for energy
consuming appliances.
Before purchasing this
appliance, read important
energy cost and efficiency
information available from
your supplier.
Rheem Water Heating • 101 Bell Road, Montgomery, Alabama 36117-4305 • www.rheem.com
PRINTED IN U.S.A 12/05 WP FORM NO. 102G-9 Rev. 17
In keeping with its policy of continuous progress and product improvement, Rheem reserves the right to make changes without notice.
DESCRIPTION FEATURES ROUGHING IN DIMENSIONS (SHOWN IN INCHES) ENERGY INFORMATION
HT.TO ROOF HT.TO
GAS INPUT IN RECOVERY IN FIRST HOUR HT.TO TANK GAS VENT JACK SIDE WATER SHIP. ENERGY AVG. ANN.
GAL. THOUS. BTU/HR. G.P.H. 90° RISE DEL. G.P.H. VENT HT. DIAM. CONN. SIZE VENT SZ. T&P CONN. WT. FACTOR OPER. COSTS
CAP. MODEL NUMBER NAT/ LP NAT./LP NAT./ LP A B C D E F G H (LBS) NAT./LP NAT. LP
T
Y
P
E
T
A
L
L
G
2"
1/2"
RELIEF
VALVE
COLD
WATER
CONN.
ADJUSTS TO PITCHES
OF UP TO 5/12"
WATER CONNECTIONS
ALL 3/4" N.P.T.
H
D
E
C
F
A
B
24" MIN.
0" MIN.
WALL
CLEARANCE
Adjustable Roof Jack Vent
Design allows adjustment to roof
pitches of up to 5/12". Four roof jacks
available to accommodate roof
thickness of 12" up to 95".
Direct Combustion
Air Inlet
Air is drawn directly into combustion
chamber through air inlet fixed to
base; 1/2" screen for rodent
protection.
THE WARRIOR DV IS U.L.CERTIFIED FOR
MANUFACTURED HOME USE, MEETS
ANSI STANDARDS FOR MODULAR HOME
CONSTRUCTION, AND COMPLIES WITH HUD
SAFETY AND CONSTRUCTION STANDARDS.
ROOF JACKS
12" Non Adjustable AP12119B
15-32" Adjustable AP12118B
30-60" Adjustable AP12118C
48-95" Adjustable AP12118D
AIR INLETS
6" Non Adjustable AP12019B
11-22" Adustable AP12017B
EXTENSION PIPE KIT
Roof Jack Extension Pipe Kit AP12021
Warrior DV The Direct Vent Gas Water Heater for Manufactured Housing
Available in 30, 40 and 50 Gallon Models
1-Year Limited Tank Warranty* 1-Year Limited Parts Warranty*
•
No external vented door is required
•
All combustion air comes from outside the
home
•
Provides maximum design freedom since it
can be placed anywhere within the home
•
Hot water outlet located at top
•
Factory installed temperature and pressure
relief valve – side location.
•
Exclusive Rheemglas®tank lining resists
corrosion and prolongs tank life
•
Field convertable controls for natural gas or
LP operation
•
Meets or exceeds National Appliance
Energy Conservation Act (NAECA)
requirements
•
Peizo ignitor – easy light pilot
•
Certified for manufactured (HUD) and
modular construction
•
Anode rod equalizes aggressive water
action
•
Cold water inlet – side connection allows
for fast, economical hook-up
*See Residential Warranty Information Brochure for
complete warranty information.
Energy Factor and Average Annual Operating Costs based on D.O.E.
(Department of Energy) test procedures. D.O.E.national average fuel rate
natural gas 91¢/therm; LP $1.23/gallon.
• Roof jack and air inlet must be ordered separately with
30, 40 and 50 gallon direct vent models and must be in
accordance with instructions furnished with the heater.
No other roof jack or air inlet assemblies are approved
for installation with this heater.Clamps and secure
strapping are packed in water heater carton.
*FOUR ROOF
JACKS AVAILABLE
TO ACCOMMODATE
ROOF THICKNESS OF 12" UP TO 95"
NOTE: for 5 year tank warranty substitute “V” for “I” in model number.Example 21VR30DV
®
®
Loading...