Ruby Tech GS-2116C User Manual

RUB

Networking & Communications

TECHTECH

GS-2116C

R

Gigabit Switch

L2 Managed Switch

Gigabit Switch

GS-2116C: 16-Port GbE L2 Managed Switch with 2 SFP Dual Media

Key FeaturesKey Features

Standard compliance

---IEEE 802.3x Flow Control capability

---IEEE 802.1q VLAN

---IEEE 802.1p QoS

RoHS Compliance
Performance

Switching capacity

---16 Gigabit Ethernet ports with non-

blocking wire speed performance

---8 K MAC addresses

---272KB on-chip frame buffer

---Supports Jumbo frame, up to 9K

---Broadcast/Multicast Storm
Suppression

---Port Mirroring
VLAN

---Port-base VLAN

---IEEE802.1q tag-base VLAN, up to 256
active VLANs

---Q-in-Q is an efficient method for
enabling Subscriber Aggregation.
VSM(Virtual Stacking Management)

---Up to 16 switches can be managed
via Single IP

----Virtual stacking, no extra stacking
hardware is required

----Distributed stacking, no physical
central wiring closet is needed
QoS

---Supports Layer 4 TCP/UDP port and
ToS classification

---Supports 802.1p QoS with two level
priority queue

---Supports priority in a Q-in-Q tag
Bandwidth Control

---Supports bandwidth rating per port
ingress and egress rate limit
1000Mbps with 1Mbps increment

Protocol

LACP

---Port trunking with 8 trunking groups

---up to 8 ports for each group
GVRP/GARP

---802.1q with GVRP/ GARP
Multicasting

---Supports IGMP snooping including
active and passive modes

BenefitsBenefits

2 dual media ports for flexible fiber connection

Port 15, 16 dual media ports are provided for flexible fiber connection. You

can select to install optional SFP transceiver modules in these cages for
short, medium or long distance fiber backbone attachment. Use of the SFP
will disable their corresponding built-in 10/100/1000BASE-T connections.

QoS supports layer 4 classification

lsoThe switch supports not only Layer 2 802.1p Priority Queue control, but a

supports programmable higher layer classification and prioritization to enable
enhanced Quality of Service (QoS) support for real time applications based
on information taken from Layer 2 to Layer 4, such as VoIP.

Port Mirroring helps supervisor monitoring network

Port mirroring copies traffic from a specific port to a target port. This

mechanism helps track network errors or abnormal packet transmission
without interrupting the flow of data.

Q-in-Q VLAN for performance & security

The VLAN feature in the switch offers the benefits of both security and

performance. VLAN is used to isolate traffic between different users and thus
provides better security. Limiting the broadcast traffic to within the same
VLAN broadcast domain also enhances performance. Q-in-Q, the use of

double VLAN tags is an efficient method for enabling Subscriber Aggregation.
This is very useful in the MAN.

802.3ad Port Trunk for bandwidth aggregation

The Gigabit ports can be combined together to create a multi-link load-sharing

trunk. Up to 8 Gigabit ports can be set up per trunk for forwarding bandwidth
up to 16Gbps, all traffic is aggregated based on MAC addresses, thus

balancing the traffic load. The switch supports up to 8 trunking groups. Port

trunks are useful for switch-to-switch cascading, providing very high full-duplex
speeds.

802.1x Access Control improves network security

802.1x features enable user authentication for each network access attempt.

Port security features allow you to limit the number of MAC addresses per
port in order to control the number of stations for each port. Static MAC
addresses can be defined for each port to ensure only registered machines
are allowed to access. By enabling both of these features, you can establish
an access mechanism based on user and machine identities, as well as
control the number of access stations.

802.1D compatible & 802.1w rapid spanning tree

For mission critical environments with multiple switches supporting STP, you

can configure the switches with a redundant backup bridge path, so
transmission and reception of packets can be guaranteed in event of any
switch on the network.

Broadcast/Multicast Storm control

To limit too many broadcast/multicast flooding in the network, broadcast/

multicast storm control is used to traffic. Threshold values are restrict excess
available to control the rate limit for each port. Packets are discarded if the
count exceeds the configured upper threshold.

RUB

TECHTECH

Networking & Communications

R

Gigabit Switch

L2 Managed Switch

Gigabit Switch

STP/RSTP

---802.1d/1w/1s STP

Network Security

---802.1x access control

---Management Access Policy Control
(L2 ACL)

SNMPv1,v2c Network Management
RFC 1213 MIB (MIB-II)

---Interface MIB

---Address Translation MIB

---IP MIB

---ICMP MIB

---TCP MIB

---UDP MIB

---SNMP MIB

RFC 1757 RMON MIB

---Statistics Group 1

---History Group 2

---Alarm Group 3

---Event Group 9

RFC 1493 Bridge MIB
RFC 1643 Ethernet MIB
Enterprise MIB

OverviewOverview

The GS-2116 is an L2 managed Gigabit
switch that supports SNMP, Web UI and
CLI management interface. It is equipped
with 16 Gigabit TP ports and 2 dual media
ports that accommodate optional 10/100/
1000Base-T or SFP modules. In addition,
the switch implements the QoS (Quality of
Service), Mac Filtering Policy, Port Mirror,
VLAN and full L2 protocol. It is suitable for
workgroups or WAN edge application.

Technical SpecificationsTechnical Specifications

LED Description:

LED Color Function

Global POWER Green -Lit when +5V power is coming up
Global CPU Green -Blinks when CPU is active
Port LINK/ACT Green -Lit when connection with remote device
1-16 is good

-Blinks when any traffic is present
Port 10/100/ Green -Lit Green when TP link on 1000Mbps
1-16 1000Mbps /Amber speed

-Lit Amber when TP link on 100Mbps
speed

-Off when 10Mbps or no link occurs
Port SFP Green - Lit when SFP connection with remote
15,16 device is good

-Blinks when any traffic is present

Diagnostic LEDs:

System LED Power
10/100/1000M TP Port Per Port LED Link/Act, 10/100/1000Mbps
Gigabit SFP Module LED SFP

Network Interface:

Configuration Connector Port
10/100/1000Mbps TP Jack (RJ-45) TP(RJ-45) 1 to 16
1000Mbps SFP Fiber Module SFP 15, 16

Cable and Maximum Length:

Feature Detailed Description
TP Cat. 5 UTP cable, up to 100m
1000Base-SX SC M-M Up to 220/275/500/550m, which

depends on Multi-Mode Fiber type

1000Base-LX SC S-M Single-Mode Fiber, up to10/30/50Km
1000Base-LX WDM SC S-M Single-Mode Single Fiber, Bidi 20Km

Hardware Specifications:

Feature Detailed Description

Voltage 100~240 VAC
Frequency 50~60 Hz
Consumption 30W
Ambient Temperature 0 to 40 C
Humidity 5% to 90%
Dimensions 44(H) x 442(W) x 209(D) mm

Weight 2.86kg

Safety UL
Complies with FCC Part 15 Class A & CE

Mark

Packing InformationPacking Information

Carton Dimensions (mm) pcs/Carton N.W (KG) G.W (KG)

530x512x345 5 19 20

Ordering InformationOrdering Information

GS-2116C 16-Port GbE L2 Managed Switch with 2 SFP Dual Media

Optional SFP Module

SFP.LC 1000Base-SX GE SFP Fiber Module,
LC Multi-Mode 850nm
SFP.LC.M2 1000Base-SX GE SFP Fiber Module,
LC Multi-Mode 1310nm 2km

Note: We recommend the SFP transceiver from the following vendors:

1. Ruby Tech Corporation

2. Agilient Technologies

Ruby Tech Corp.

3. AVAGO Technologies

4. Finisar Corporation

3F, No.1, Lane 50, Nan Kang Road, Sec.3, Taipei, Taiwan http://www.rubytech.com.tw
TEL:[phone] FAX:[phone] E-mail [e-mail]

2008-07.25 Version A

Technical information listed is subject to change without prior notice. All brand names and trademarks are property of their respective owners.

Copyright c 2008 Ruby Tech Corp. All rights reserved.